Hi!! i'm trying to unlock my p3600, tried the pof solution, nothing, then i tried flash all of them(hardspl, radio, cooked rom)from minisd, and still locked..
I notice that when i start my p3600 it gives me this information:
M:05
B:05
D:3.00
R:NONE
G:NONE
And i notice this too:
Settings>System>Device Information>Version:
ROM version: 3.1.2c.AX3L
ROM date: 07/24/07
Radio version: NONE
Protocol version: NONE
Settings>System>Device Information>Identity:
Model No:TRIN100
Platform: PocketPC
IMEI: (blank)
please guys help me unlock my p3600, i dont know why dont upgrade the radio, still same thing: radio version NONE protocol version NONE..
thanks a lot!!!
did you try SSPL ..??!!
Related
Is my Wizard CID locked or unlocked?.
Here is the phone's details at present after I HardSPL(ed) it.
Wizard Service Tool v4.2.1
01/01/08 ....
-------------------------------------
CPU: Texas Instruments - OMAP850
MODEL: Wizard
IMEI: ?????
=> Bootloaders:
IPL: 2.21.0001 (G4 device)
SPL: 2.21.Olip (G4 device w/ HardSPL)
Built on Aug 26 2007 at 19:41:34
Copyright (c) 2007 Olipro & HTC - Hard-SPL
=> Firmware:
OS: 5.1.xxx (Build 14847.2.0.0)
ROM: 2.21
Registry AKU: .2.0.0
Radio: 02.07.1ò
Protocol: P413.1.03
=>Extended_ROM:
Version: 2.21.4.101
Name: Extended_ROM
Status: hidden
-------------------------------------------
However using the same tool to check the CID status, the results are.
Reading CID block...
Calculating CID block sum...
CID checksum: D1E00472
Decrypted stored sum: A752285F43A26357
Decrypted calcd sum: A752285F43A26357
Key index : 86 - Block index: 13
CIDkey: MODULESN
CID IMEI: ????????
CID: WIZO2B01
Phone is CID LOCKED!
------------------------------
Next using the same tool to SuperCID unlock the results are.
UnlockCID (Super CID)
SPL version is 2.21.Olip
DOC chip is write-protected!!
Downgrade SPL to no higher than 1.06 and
repeat procedure.
Question is, I thought that the HardSPL process, CID-unlocked the phone, why is the tool showing it is locked?.
Thanks for your help in advance.
Cheers
HardSPL isn't CID unlocking; is 'simply' patching a modified SPL (hence the name) to fool the bootloader into allowing flashing any ROM.
When WST checks the CID status it reads the CID block zone (which wasn't touched) thus reporting the REAL CID status
Thanks very much for your reply but on more thing?
Q 1: From the other details I have posted, is the phone WM6 ready?
Q 2:can you advice on any WM6 roms that are G4 safe to use?
I get the following problem error message with each WM6 rom is used to date.
[ERROR 300]"INVALID UPDATE TOOL: This update utility cannot be used for your PDA phone. Please get newer update utility".
I have searched and read many post on this problem in the forum but I am being super cautious, before I attempt anything I am not sure of regarding G4 limitations.
I am sure after I do the first upgrade sucessfully I will become more confident and adventurous.
Sorry forget question 2 I just read that ROM recommendation is not allowed in the forum.
Thanks in advance
whateveryouneed said:
Q 1: From the other details I have posted, is the phone WM6 ready?
Q 2:can you advice on any WM6 roms that are G4 safe to use?
I get the following problem error message with each WM6 rom is used to date.
[ERROR 300]"INVALID UPDATE TOOL: This update utility cannot be used for your PDA phone. Please get newer update utility".
I have searched and read many post on this problem in the forum but I am being super cautious, before I attempt anything I am not sure of regarding G4 limitations.
I am sure after I do the first upgrade sucessfully I will become more confident and adventurous.
Sorry forget question 2 I just read that ROM recommendation is not allowed in the forum.
Thanks in advance
Click to expand...
Click to collapse
The details posted lead me to believe you have a WM5 but can't be sure
As for the update tool you must try to use the ones posted by the cooks of the most recent ROMs
I don't know where you were told the ROM recommendation isn't allowed . What more experienced users say is that there are so many good ones that it gets hard to choose from. My favorites at the moment are the TNT ROMs
cheers
Thanks again. Wiil try TNT route.
I will try the TNT route.
By the way I am presently using WM5. Just wanted to upgrade to WM6 to gain a little speed and newer apps.
Cheers.
--------------------------------------------------------------------------------
Hi guys!!
my uncle came from europe and left his p3600 with me, here in Brazil, i tryed the unlock solution from pof but it still locked..
first i use the unlock tool, with AUTO_Unlock_v1.bat, then i flashed a new room(3.1.2c.AX3L), then turn it off, 10 seconds, turn on and nothing, i notice that when i start my p3600 it gives me this information:
M:05
B:05
D:3.00
R:NONE
G:NONE
And i notice this too:
Settings>System>Device Information>Version:
ROM version: 3.1.2c.AX3L
ROM date: 07/24/07
Radio version: NONE
Protocol version: NONE
Settings>System>Device Information>Identity:
Model No:TRIN100
Platform: PocketPC
IMEI: (blank)
Can you guys help me unlock my "new" p3600
thanks a lot!!
PS: sorry if i post this in the wrong place, im new here
and i tried flash from minisd all of them (hardspl,radio,cooked rom, unlock) but still same thing: radio version NONE protocol version NONE please some one help me..
Hi all
Please help me with small problem...
I buying yesterday very good machine HTC Diamond with this default DIAM100 HTC__001 06/19/08 ROM1.37.401.3 1.00.25.03 52.26a.25.09 19591 1.1.6 1.37.
I trying flash to this latest DIAM100 HTC__032 02/06/09 ROM2.03.479.2 1.09.25.23 52.51.25.26 20764 1.4.3 2.03
Run flash tool from HTC and end of this ERROR message and end....Diamon boot to normal work
Where is problem please is this number of version HTC__001 vs. HTC__032
On ticks under battery is this number:
S/N: HT823GN02959
P/N: 99HEJ035-00 F
I download official ROM from this link: http://wiki.xda-developers.com/index.php?pagename=Diamond_Upgrades
EDIT:
ALL its O.K and new ROM 2.03.479.2 is flashed!!!
I using this good: http://forum.xda-developers.com/showthread.php?t=400950
Many,many THX Olipro
Hello guys,
I've bought a new G1 with details below:
DREA100 PVT 32B
HBOOT-0.95.0000
CPLD-4
RADIO-2.22.23.02
Model: T-mobile G1(Black)
Firmware version: 1.6
baseband version: 62.50SC.20.17H_2.22.23.02
kernel: 2.6.29-00479-g3c7df37
build number: DMD64
Anyone can explain these information for me? i'm just a novice in this area. thanks.
P/s: what is SD card level 4? and what is level 6? what is the difference?
i have just rooted my G1 successfully with z4Root and Superoneclick, but i really don't know where to begin my rom update? which rom is stable? and how to prevent from being bricked? Is there really a software way to unbrick g1?
Model: Its yout phone
Kernel: The linux kernel, on this kernel is your rom builded on.
Radio 2.22.23.02 : your radio version (stock)
0.95.000 hboot : your hboot version (stock)
Firmware: your android version
If you want to flash a Rom, use this guide from me or this guide from ldrifta (and me)
Hi all,
I have HTC HD7 with the following info
OS Version: 7.10.8862.144
Firmware revision number: 2250.21.51201.707
Hardware revision number: 0002
Radio software version: 5.71.09.02a_22.51.50.21u
Radio hardware version: A.102.0.D4
Bootloader version: 5.12.2250.0(139198)
Chip SOC version: 2.2.5.0
and I want to root my device ,I don't have any zune backup
so what I have to do ?!
Search!!!!
You must SEARCH the forums, the only answer is downgrade the ROM and install a Custom ROM, search and read carefully the instructions...