Hi
Have the N1 in OZ that was bought thru Singapore - not officially available here yet. The "power" button stopped werking like others have similarly reported.
However, I took the fone to a repairer guy and he says there is no issue with the hardware but he thinks that some software has put the fone into "auto-off" mode.
It is a stock N1 with just some apps on it ---- anyone know how to get around this problem or is the repairer wrong and it is a hardware problem ?
Cheers
I highly doubt software could prevent a phone from even beginning the bootup process. I'm assuming you can't access the recovery menu? Perhaps try removing the battery for a few minutes?
Related
Hi all, just wondering if anyone else has had this problem...
Last week, on a very hot day in Australia (36*C), I received an SMS message whilst the phone was charging....
Anyway, this turned the Diamond on, and it connected to Wifi, and stayed powered up (for some reason) for a couple of hours....
Anyway, the phone was very very hot when I unplugged it, and since then it has been playing up very badly...
The problem has been getting worse and worse, and Now I am at the stage where the phone is almost bricked !
When I switch on the phone, I am presented with a white screen. (It doesnt boot up)
If I power up holding down the Volume Down, Rest, Power Button, I can get into the bootloader screen.
I can even reflash the phone with a new Rom....
If I reflash, the phone may run for a minute or so, then crash, and refuse to power on..... (Same problem as above)
Im reluctant to send the phone off for warranty, as they cannot give me an estimate of if it can be fixed, when it will be fixed, or what day of the week it is.....
Has anyone else had this problem, and if so, how did they fix it ??????
(Im hoping I just got a dud version... I love this phone, but I am hoping this is not a common problem !?!?!?!)
Cheers for any help anyone provides !!!!!
try removing battery for 10-15 and make sure your running a 1.93 rom because 1.37 and older are known for heat issues.
you may have already done this, but its not in your first post and there are order of operations to follow.
hey buddy even i hav the same problem..it just restarts after heating up..and after 2 restarts it doesnt even go beyond 1st diamond loading screen...dont know what to do....
Guys, send your phones back to repaired or replaced. Just explain to your provider what is going on and I'm sure they'll try to help.
yea buddy...i guess so...thats the best way i can get my diamond fixed..
I have done a reasonable amount of searching on this and have not found anything specific to my problem so figured I should post a question.
I have an issue with my Dimaond when it gets hot generally either using Wifi or Phone Data connection that the screen goes out. Basically everything goes to the left side of the phone so if you hit the Task Icon in the top right corner you get the Start Menu. Phone is basically useless at this point and you have to wait for it to cool down. Has happened since day one and is generally worse when using it when charging. I was watching Utube on it the other night 5min video while on AC charge and it went out. I am running Dutty 2.5 Rom and 25.07 radio have tryed 25.08 and 25.05 no difference was happening when the phone had orginal HTC ROM as well. Also will happen on a long call if the screen is on.
Basically feel issue is hardware related and maybe faulty screen still under warrenty so wanted to know peoples opinion on weather I should send back. Problem is will take a couple of weeks and I don't really wnat to wait that long if I can help it. Also assume it would be best to flash standard ROM back, should I do anything with HARDSPL eg should this be changed back as well if I send it back.
And before anyone says it I have tryed searching this topic and have found lots about HOT dimaonds but nothing related to screen going out at the same time :-(
Thanks
I had this issue in my JasJam (Hermes) whre the screen would simply go white after a while of use and I would have to leave it for a while for it to work again.
Unfortunately it sa hardware issue and you should claim a warranty repair on it
I can't see how this could be a software problem so I figured it must be the screen eg hardware related. Would be nice to know if anyone has had the same issue with a dimaond... Seems we may be spending some time apart, just hope it doesn't take long to fix..
I've had the same issue
http://forum.xda-developers.com/showthread.php?t=428976
My first device had been replaced recently (i.e. today) by my network provider (o2) and the new device seems to work without any problems now even if it's "hot".
(i.e. default screen adjustment + creating heat by activating the phone, wlan, bt + recharging it)
I sent an email to HTC regarding the fault and they said it would have to go back for a warrenty repair. I brought it through a resellar so has to go back to HK from NZ so will be away three weeks uurggghhh... Just seems odd I don't have any physical damage on the screen but hte problem has been around since day one as I remember having the problem the first day I got it. Juyst seems to be getting worse and is easily reproduced by usiung utube over wifi gets hot and it is all over. Just wondering if I should put an offical ROM from HTC back on the device before I send it back as I currenty am running Dutty ROM, what do you think....
i put the original rom back on and they still found out the the rom had been flashed, and would not repair on warranty
yep, i also asked about this problem
http://forum.xda-developers.com/showthread.php?t=438733
there are some youtube video's of how the phone behaves
my phone seems to do it less frequently since stopping using panosha's rom
im using alpha zero 7 at the moment..
i've also noticed that it isnt necessarily a heat issue, my phone does it completely at random
yesterday i found though, that when the phone did the alignment issue, i gave it a good shake.. and hey.. its all aligned again?!
maybe it was just a fluke, it hasnt freaked out since..
holding thumbs
Hey,
I also have the same screen problem, but my Alignment goes to right.
If I press on the left side, a press on the right side is recognized.
Good to know that Im not the only one with this problem.
greets doena
I got my phone back a week ago replaced the screen has been away for over two months, complete disaster, anyway all sorted now and I have not had the problem since....
I had this exact same issue (out of the box).
It was a hardware fault and I exchanged it for another one.
Haven't had any problems since.
Minus-1 said:
I had this exact same issue (out of the box).
It was a hardware fault and I exchanged it for another one.
Haven't had any problems since.
Click to expand...
Click to collapse
Hardware's fault ? Most likely not. I will give u an example of why I think it was software related. My device ran hot as well but I simply switched roms and now it's the complete opposite. Your most recent device most likely come with a different Rom in the phone.
Hey Guys,
I think I did a thorough research on that issue, but could not find any hints as how to solve it.
Background: I planned on flashing my ROM and thus first of all tried to get it on HardSPL. After some connection trouble I finally got it on (though the progress bar jumped from 0% to 100% instantly after like 1 minute instead of the indicated 10... is that normal?)
I then tried to reboot holding POWER+VOLUME DOWN, but it booted just regularly. Conclusion at this point: It is not on HardSPL. So I kept repeating, but never succeeded, until recently I noticed neither my VOLUME UP nor my VOLUME DOWN button works at all. Never, not matter how hard, gently or desperately I push - no reaction.
So apparently it is a physical problem. Does anymore know it? Ideas? In another forum I read that some Palm Pre users suffer from this issue on their devices. They advised to take out the battery and leave the phone in a bag of rice for 24 hours, as it is an issue of humidity.
Now if I think ahead - I do not even have a bill, but could probably get it form the seller - if I send it to SE as a case of warranty, they will certainly/probably see the HardSPL and send it right back.
Pretty srewed thing, huh? Anyone solved this problem so far?
Thanks in advance.
I just had an i957 warrantied with all the symptoms of a hardware failure or hard brick, couldn't get any power on. It was running nrvate's CM10 and it died in the middle of normal use. A similar question has previously been posted but I didn't see any definitive answers. Is "SOLUTION: S/W Updated" just a software update? I know a fair amount about getting into downlaod mode, recovery, etc. and could not get anything to recognize the device, so I find it hard to believe that it was a software issue. Anyone else have a similar experience?
This is from the Samsung repair facility:
Original Problem:
TECHNICAL INQUIRY - POWER - WILL NOT POWER UP
Problem found:
NO POWER UP
Solution:
S/W UPDATED
My phone's screen just went black suddenly while i was using the phone last night. Nothing i do will wake the screen up, i tried rebooting by holding the power button, tried power+volume down also to boot into recovery .. no response. However the phone seems to be functioning as i can hear the screen lock sound. I think im stuck on the pin screen (the one to pass the boot-up-encryption). theres some vibration and feedback when i randomly press on the screen too.
The device is running Stock 6.0.1 , unrooted , stock kernel. Has this ever happened to anyone else ? could it be a software issue ?
I believe the LCD panel just went dead ..
Thanks!
Have you hooked it up to a computer and tried to see if it's recognised by ADB?
moses992 said:
My phone's screen just went black suddenly while i was using the phone last night. Nothing i do will wake the screen up, i tried rebooting by holding the power button, tried power+volume down also to boot into recovery .. no response. However the phone seems to be functioning as i can hear the screen lock sound. I think im stuck on the pin screen (the one to pass the boot-up-encryption). theres some vibration and feedback when i randomly press on the screen too.
The device is running Stock 6.0.1 , unrooted , stock kernel. Has this ever happened to anyone else ? could it be a software issue ?
I believe the LCD panel just went dead ..
Thanks!
Click to expand...
Click to collapse
I had a nexus that had a faulty screen and randomly shut off or something half the screen will glitch out and one day it just stopped working but I could hear the lockscreen sounds. Your best bet would be to send it in for service maybe its a loose connecting or a hardware issue. When mine started acting up it was a loose connecting so if I hit the phone with my hand it would go back to normal and then it stopped working. Its a common issue if you do a google search many people have encountered this
That sounds to me like a return-under-warranty job. If you were in the UK you could quote the Sale of Goods Act, which specifies that an item must be of suitable quality and last a reasonable amount of time, but in my case when I returned my faulty N5 to Google after 18 months they were as good as gold, didn't quibble, simply replaced it with a refurbished one which appeared to me to be indistinguishable from brand new.
Since by definition your phone must be very close to its warranty period, depending on when you got it, I'd start with that. This is the link I used from the UK - maybe different if you're elsewhere, but you should find a link called "Get a call from a hardware specialist":
https://support.google.com/store/co...roid_help&cfnti=escalationflow.c2c&cft=5&rd=1
Didgeridoohan said:
Have you hooked it up to a computer and tried to see if it's recognised by ADB?
Click to expand...
Click to collapse
Havent done that yet. Only thing that would be good for is making sure its a hardware defect right ?
jazz995756 said:
I had a nexus that had a faulty screen and randomly shut off or something half the screen will glitch out and one day it just stopped working but I could hear the lockscreen sounds. Your best bet would be to send it in for service maybe its a loose connecting or a hardware issue. When mine started acting up it was a loose connecting so if I hit the phone with my hand it would go back to normal and then it stopped working. Its a common issue if you do a google search many people have encountered this
Click to expand...
Click to collapse
That makes sense. could be just a loose connector between the LCD panel and the MoBo ..
Problem is i live in Jordan and I got the phone from Dubai. Its still under warranty of the seller (Souq.com ; an online store .. kind of like Amazon of the middle east ), So i have to send my phone to Dubai to fix it. Now i could just go to a local phone repair shop and ask the guy to check the connectors, but im afraid that would void the warranty and not solve the problem ;( .
dahawthorne said:
That sounds to me like a return-under-warranty job. If you were in the UK you could quote the Sale of Goods Act, which specifies that an item must be of suitable quality and last a reasonable amount of time, but in my case when I returned my faulty N5 to Google after 18 months they were as good as gold, didn't quibble, simply replaced it with a refurbished one which appeared to me to be indistinguishable from brand new.
Since by definition your phone must be very close to its warranty period, depending on when you got it, I'd start with that. This is the link I used from the UK - maybe different if you're elsewhere, but you should find a link called "Get a call from a hardware specialist":
https://support.google.com/store/co...roid_help&cfnti=escalationflow.c2c&cft=5&rd=1
Click to expand...
Click to collapse
I submitted the form , although i live in Jordan which has no presence of Google whatsoever but what the heck !
thanks all for your suggestions.
Google is supposedly a global company...
Let us know how it goes, and good luck.
Well, if you figure out that it is just the screen, you can use this program for basic control with a lot of latency
http://forum.xda-developers.com/showthread.php?t=2786395
It's a little rough and confusing but, it's workable. If you need help setting it up feel free to shoot me a PM.