I'm looking to buy a diamond and i need to make sure I get a version that will work with all the AT&T bands. I only get edge where I live, no H :-(
on the back of the box it says:
Network
HDSPA/WCDMA
900/2100 MHz
Up to 384 kbps up-link and 7.2 Mbps down-link speeds
Tri-band GSM/GPRS/EDGE:
900/1800/1900 MHz
(Band frequency & data speed are operator dependent)
The model number is P3700
any help is appreciated.. Thanks!
dont get it. I bought the same version and I am trying to use it on AT&T's network and it does not work. Calls drop off and calls dont get in. Have tried a whole lot including updating the radio but does not work.
You can buy any Diamond you want. You just need to flash a new quad band radio to it. There is a whole list of radios here: http://forum.xda-developers.com/showthread.php?t=407956.
That's what I did an everthing works fine.
Wind dancer, Maybe you can help me here. I bought a 2g phone with the and updated the radio to .05 but still dont get reception. when i do *#364 I see that the band that the phone is operating on is 850.
What radio did you you and did you update the ROM to 1.93? I am still on the base rom...1.37.720.2 WWE
s21ht 日版钻石在中国使用不了2100的WCDMA网络。英语不好会中文帮翻一下！
s21ht 日版钻石在中国使用不了2100的WCDMA网络。英语不好会中文帮翻一下！
此机好像在日本使用1700M 频率，在中国无法使用中国联通的WCDMA，刷 了几个ROM跟RADIO都没办，不知是此机只支持1700M吗。无法支持2100M的中国联通WCDMA吗
会中文的帮我翻译一下。。哈哈。谢谢
shishi007 said:
s21ht 日版钻石在中国使用不了2100的WCDMA网络。英语不好会中文帮翻一下！
此机好像在日本使用1700M 频率，在中国无法使用中国联通的WCDMA，刷 了几个ROM跟RADIO都没办，不知是此机只支持1700M吗。无法支持2100M的中国联通WCDMA吗
会中文的帮我翻译一下。。哈哈。谢谢
Click to expand...
Click to collapse
ENGLISH dude! If you look around the forums, everyone uses english. If you don't know english, try a translator, or use a japanese site. We are all more then happy to help, but we can't help if we can't read what you wrote.
shishi007 said:
s21ht 日版钻石在中国使用不了2100的WCDMA网络。英语不好会中文帮翻一下！
此机好像在日本使用1700M 频率，在中国无法使用中国联通的WCDMA，刷 了几个ROM跟RADIO都没办，不知是此机只支持1700M吗。无法支持2100M的中国联通WCDMA吗
会中文的帮我翻译一下。。哈哈。谢谢
Click to expand...
Click to collapse
TD Japanese Version couldn't use the WCDMA(2100) Network in China.
This TD seemed to use WCDMA 1700 in Japan, but couldn't be used in China. I've tried flashing a few Roms, also some Radios. Still it didn't.
Is this TD only support 1700MHz in Japan, which means it couldn't be used in WCDMA Network in China, which is 2100MHz?
Sorry for my poor translation.
Reuental said:
TD Japanese Version couldn't use the WCDMA(2100) Network in China.
This TD seemed to use WCDMA 1700 in Japan, but couldn't be used in China. I've tried flashing a few Roms, also some Radios. Still it didn't.
Is this TD only support 1700MHz in Japan, which means it couldn't be used in WCDMA Network in China, which is 2100MHz?
Sorry for my poor translation.
Click to expand...
Click to collapse
The translation is better then the kanji. {I can't remember Katakana or Hirogana, been too long since I have read, wrote, or even spoke} If you can translate this back for Shishi, that would be wonderful. Thanx for the help as a translater.
Check the model # {label under battery}, & enter the model into the search engine @ PDADB.net. This will list all the frequencies your specific model is capable of. Model # will be DIAM*** {replace the *s with the #s on your Diam.}
You can flash ROMs until the chip burns out, but this will not help, because all the frequency data is in the Radio. If the site says that your model is capable of 2100 {which I believe it should be}, then just find a radio that runs at 2100MHz, & flash it.
If this is a CDMA model then I am not too sure what the frequencies are. GSM Touch Diamonds are quad-band phones & definately utilize the 2100MHz WCDMA. Soe GSM Diams only show the tri-band frequencies, but if you just flash a quand-band Radio to it, & it'll be fully functional as a quad. It has the Hardware, you just may need to change the software.
Also, if you go to the phone settings, there is a tab for "Band". Look there & see if the 2100MHz is listed. If it is, check that it's enabled. If it's not then just flash a quad radio.
Good luck
Humblehippie said:
The translation is better then the kanji. {I can't remember Katakana or Hirogana, been too long since I have read, wrote, or even spoke} If you can translate this back for Shishi, that would be wonderful. Thanx for the help as a translater.
Check the model # {label under battery}, & enter the model into the search engine @ PDADB.net. This will list all the frequencies your specific model is capable of. Model # will be DIAM*** {replace the *s with the #s on your Diam.}
You can flash ROMs until the chip burns out, but this will not help, because all the frequency data is in the Radio. If the site says that your model is capable of 2100 {which I believe it should be}, then just find a radio that runs at 2100MHz, & flash it.
If this is a CDMA model then I am not too sure what the frequencies are. GSM Touch Diamonds are quad-band phones & definately utilize the 2100MHz WCDMA. Soe GSM Diams only show the tri-band frequencies, but if you just flash a quand-band Radio to it, & it'll be fully functional as a quad. It has the Hardware, you just may need to change the software.
Also, if you go to the phone settings, there is a tab for "Band". Look there & see if the 2100MHz is listed. If it is, check that it's enabled. If it's not then just flash a quad radio.
Good luck
Click to expand...
Click to collapse
Thank you for your help!
检查你的TD的型号（取下电池你就能看到），将你的手机型号输入PDADB.net的搜索引擎，它将会列出你的型号所适合的频率。型号是DIAM***。
你可以刷ROM，但是这没有作用，因为所有和你频率相关信息都在Radio里面。如果你的型号适合2100Mhz，那就选择一个2100频率的Radio，再刷Radio。
如果这个TD是CDMA型号的，那么我也不清楚他能适合频段是多少Mhz。GSM的TD是4频手机，所以口肯定能使用WCDMA的2100Mhz。GSM只显示3频，但如果你刷了四频的Radio，它就是个全功能的4频手机了。你只需选用合适的软件来激活它的硬件。
此外，如果你进入手机的设置项，其中有一个频段(BAND)选项，看看是否其中有2100Mhz 的频段，如果有，只需启用即可，如果没有，则需要刷一个4频段的Radio
Thank you for playing translater
Thank you everyone
http://pdadb.net/
rimary search results in names of Devices (1/3)
Searching process took 0.0198 seconds. Only one result matches exactly with "s21ht"
Compare Emobile Touch Diamond S21HT (HTC Diamond 210)
Release Date: October, 2008
51x102x11.35mm, 110g, Microsoft Windows Mobile 6.1 Professional , 32bit Qualcomm MSM7201A, 528MHz CPU, 192MiB RAM, 256+3814MiB ROM, 2.8" 480x640 color transflective TFT LCD, Proprietary audio jack, GSM900, GSM1800, GSM1900, UMTS1700, CSD, GPRS, EDGE, UMTS, HSDPA, mini-USB port, Bluetooth, WLAN, GPS, A-GPS, QuickGPS, FM radio, accelerometer, 3.1MP cam., AF, sec. camera, 900mAh removable battery | See all details
no umts2100
Can not be used 2100MHZ chinaunicom Network
谢谢上面的人，特别是帮我翻译的兄弟！！
I have a diamond with umts 850/1900,but I need to go to ASIA to work some days later,how can I change the UMTS frequencies to UMTS 2100
It is very unlikely this is possible as the the UMTS frequency is set in the GSM stack as far as I know. So, in less technical terms: it's baked in your hardware, no way to change it. Correct me if I'm wrong
as i know that no matter what vision the diamond is,the hardware is same.so,if i change some chips,maybe can let it work.have someone the experence?
There are a lot of different version of diamonds floating around. I have one which doesn't have 3G
Hi, this is my first thread here, sorry for my bad english.
Can Optimus 2X will have 2 digits freq. of FM radio receiver?
normally > 99.5 Mhz
I need this > 99.55 Mhz
(because in Thailand have a community radio broadcasting that broadcast in xx.25 Mhz and xx.75 Mhz.)
Samsung FM app. can change radio receiver between xx.x to xx.xx Mhz. (samsung ace)
Can it be?
Thanks for advance.
FM radio for Australia
--------------------------------------------------------------------------------
hi all
i installed this DEV_FM_ANTENNA_INTERNAL.cab , looks like its working??????
but it is for some other country as radio counter only goes to 90.0, here is Australia frq is diff and gos to 109.0 or there abouts.
has any one seen australian fm radio cab??
thanks
this is only to have radio without headphones... try change radio settings in Settings - Applications - Radio
thanks for that.... yes changed region to WORLD, and works.
but turned radio on very very bad reception all i get is static, cant get any reception.
any way thanks again
for better signal you must remove this internal antenna cab and use headphones as antenna