fixed
boot into recovery and flash the rom again , dont wipe data , because its the same rom you should be able to keep everything
reflash the ROM?
Related
Hi all,
Today I installed Jewe SmartEdition on my phone. Everything went fine but suddenly it crashed while running Quadrant. Now it's in a boot loop and I'm not possible of getting in CWM. Does somebody know a fix for this ?
Thanx
Hi.
I don't know if there is a better solution. But if you can put it in download mode you can flash new rom with odin. But you lose your downloads etc.
I hope this help you! : )
Factory reset if you can followed by deleting Quadrant .
jje
unless you have resolved this already....
Pull the battery... put in to recovery mode...
wipe the cache partition and go into advanced CWM options and wipe the dalvik cache... then try rebooting the system....
any difference? or did you just install another ROM over it?
Hello !!! i'm Vietnamese, my English is not good !!!
i flash rom LCMFroyo
wipe data, wipe cache, wipe ext.
then flash rom & kernel , reboot
My device does not boot, i can't try to recovery mode.
please help me !!!
Are you low on battery? Flashing a rom and kernel won't brick the device..
jianC said:
Are you low on battery? Flashing a rom and kernel won't brick the device..
Click to expand...
Click to collapse
battery 70% , how to flash rom & kernel, could not try to recovery mode !!!
hey guys,
which is the best method to clean your phone before flashing a new rom, or maybe bringing your phone to the state it was just after flashing a new rom. i tried data factory reset, wipe cache , wipe dalvik with kernels we have here and i found remainents of zip files i had flashed after setting up my rom and using newer mods. i dont want to format system, preload all the time.
which is your perfect, effective method ? speedmod kernel and its recovery or phillz , then which version ?
thanks
rraaka said:
hey guys,
which is the best method to clean your phone before flashing a new rom, or maybe bringing your phone to the state it was just after flashing a new rom. i tried data factory reset, wipe cache , wipe dalvik with kernels we have here and i found remainents of zip files i had flashed after setting up my rom and using newer mods. i dont want to format system, preload all the time.
which is your perfect, effective method ? speedmod kernel and its recovery or phillz , then which version ?
thanks
Click to expand...
Click to collapse
why you dont want format system and preload before flashing rom?
what I do before flashing any rom is:
flash philz kernel
wipe data / cache / dalvkk cache
format / cache / system / data / preload
and then flash new rom
and thats it, with this procedure I have never faced any issue with any rom I have flashed.
usualy I use this method even befoe restoring my nandroid backup.
above methods I using with philz and speedmod, but i prefer philz when wiping and flashing and making backup, because it has nice cwm for doing that. but after I flash new rom I immediatly flash speedmod because it is the better than philz if you drive your new rom, and you are not in cwm at the moment
hope this helped
Sent from my GT-N7000 using xda app-developers app
completely agree with you djoni, but when you are flashing continuously, experimenting a lot ...you know ...this and that,
isnt a data factory reset , wipe cache, wipe dalvik supposed to bring you to that condition just after booting up after a new rom flash ? why were there remanents from a mod i had flashed after using the rom for some time ?
Hi all,
give some information first.... at the beginning, i used rom manager to flash clockwork recovery 6.0.1.2, later i hv flashed cm10.1 rom, but i found that the resolution has some problem, so i want to flash back to stock rom... And then i go to this site http://forum.xda-developers.com/showthread.php?t=1901191, to install PhilZ-cwm6 (which is safer for installing stock rom?? i dont know).... After i hv applied the zip in the recovery mode, i found that i cant boot into the system (btw i hv wipe data and cache)
besides, i hv tried odin v1.87, but my pc cant connect with my phone (in download mode)...
what can i do Is my phone bricked?
Sorry for my poor English.
Thank You Guys!!
Problem fixed!!
after i hv installed samsung kies, odin can detect my phone!
Everything is fine now!:laugh:
kclam730 said:
Hi all,
give some information first.... at the beginning, i used rom manager to flash clockwork recovery 6.0.1.2, later i hv flashed cm10.1 rom, but i found that the resolution has some problem, so i want to flash back to stock rom... And then i go to this site http://forum.xda-developers.com/showthread.php?t=1901191, to install PhilZ-cwm6 (which is safer for installing stock rom?? i dont know).... After i hv applied the zip in the recovery mode, i found that i cant boot into the system (btw i hv wipe data and cache)
besides, i hv tried odin v1.87, but my pc cant connect with my phone (in download mode)...
what can i do Is my phone bricked?
Sorry for my poor English.
Thank You Guys!!
Click to expand...
Click to collapse
For the future:
Philz kernel is used for TouchWiz ROM's (based off what samsung gives us). You flashed a TW kernel onto a CM 10.1 ROM. If you still want to try out CM, then boot into recovery, do a full wipe, flash CM and gapps. After that is done perform a data wipe (factory reset) through recovery
Hi guys, i need your help..
I was tried to install a custom ROM and i use CWM v6 to install it (i'm on stock ROM | JB 4.3 | FW .205 | locked bootloader | recovery installed : CWM & TWRP), first step i format the /system and is successfull, then the next step wipe data/factory reset but i get stuck process on:
--- wiping data ---
clear /data done.
clear /cache...........
I don't know why, but i've been waiting for 20 minutes and still stuck like that than i decides to turning off the phone with tiny button at bottom of battery (not power button), i turn on the phone again and then i've got bootlop ( what.... where is my recovery ) i didn't noticed the recovery still in there because there is no LED notify when i turn on the phone, just SONY logo :crying:
Is that happen because wiping data didn't completed and causing my recovery also gone ?
So what should i do ? can i get the phone back again ? I have the stock ROM backup on my sd card and on my laptop because before i try to install a custom ROM, i've created current ROM backup with CWM.
please help me guys..
beespoison said:
Hi guys, i need your help..
I was tried to install a custom ROM and i use CWM v6 to install it (i'm on stock ROM | JB 4.3 | FW .205 | locked bootloader | recovery installed : CWM & TWRP), first step i format the /system and is successfull, then the next step wipe data/factory reset but i get stuck process on:
--- wiping data ---
clear /data done.
clear /cache...........
I don't know why, but i've been waiting for 20 minutes and still stuck like that than i decides to turning off the phone with tiny button at bottom of battery (not power button), i turn on the phone again and then i've got bootlop ( what.... where is my recovery ) i didn't noticed the recovery still in there because there is no LED notify when i turn on the phone, just SONY logo :crying:
Is that happen because wiping data didn't completed and causing my recovery also gone ?
So what should i do ? would i get the phone back again ? I have the stock ROM backup on my sd card and on my laptop because before i try to install a custom ROM, i've created current ROM backup with CWM.
please help me guys..
Click to expand...
Click to collapse
You wiped /system so your recoveries are gone.
On older Recoveries using the wipe to install new rom can take ages so just leave it and eventually it will finish, latest version of Philz (in Bagyusz/Nexus ROMs) seems to fix this issue.
Use DSSMEX triple recovery and use philz not cwm as its a much nicer recovery (but the clean still takes ages as its an older version)
Use flashtool to flash stock rom and start from scratch to re-install custom rom.
Oblox said:
You wiped /system so your recoveries are gone.
On older Recoveries using the wipe to install new rom can take ages so just leave it and eventually it will finish, latest version of Philz (in Bagyusz/Nexus ROMs) seems to fix this issue.
Use DSSMEX triple recovery and use philz not cwm as its a much nicer recovery (but the clean still takes ages as its an older version)
Use flashtool to flash stock rom and start from scratch to re-install custom rom.
Click to expand...
Click to collapse
Oh god, i don't know about that, because this is the first time i've got bootlop..
Where is i can get the latest version of Philz, would you like to give the link ?
Triple recovery ? maybe 2 recovery is enough
Flashtool, okay i'll try to save my phone..
beespoison said:
Oh god, i don't know about that, because this is the first time i've got bootlop..
Where is i can get the latest version of Philz, would you like to give the link ?
Triple recovery ? maybe 2 recovery is enough
Flashtool, okay i'll try to save my phone..
Click to expand...
Click to collapse
You have bootloop because your phone is essentially empty of any OS or recoveries.
Flashtool to stock, find dssmex triple recovery and install that in stock when rooted, load into Philz, clean to install a new ROM and then just wait, it will take a while usually dont worry unless it takes over an hour.
Then flash the custom ROM of choice.
beespoison said:
Hi guys, i need your help..
I was tried to install a custom ROM and i use CWM v6 to install it (i'm on stock ROM | JB 4.3 | FW .205 | locked bootloader | recovery installed : CWM & TWRP), first step i format the /system and is successfull, then the next step wipe data/factory reset but i get stuck process on:
--- wiping data ---
clear /data done.
clear /cache...........
I don't know why, but i've been waiting for 20 minutes and still stuck like that than i decides to turning off the phone with tiny button at bottom of battery (not power button), i turn on the phone again and then i've got bootlop ( what.... where is my recovery ) i didn't noticed the recovery still in there because there is no LED notify when i turn on the phone, just SONY logo :crying:
Is that happen because wiping data didn't completed and causing my recovery also gone ?
So what should i do ? can i get the phone back again ? I have the stock ROM backup on my sd card and on my laptop because before i try to install a custom ROM, i've created current ROM backup with CWM.
please help me guys..
Click to expand...
Click to collapse
Can I know what Custom ROM are you trying to install?
Sometimes wiping could take time, and I am not sure why. If happens again in the future, just let it be.
As you are using LBL, I am unable to elaborate nor understand how recovery has gone. (WARNING: FOREIGN LANGUAGE) Recoveries for LBL are stored in the ramdisk OR the FOTAkernel. This is due to the fact that Xperia SP does not has an exclusive "recovery" partition in the rootfs. I dont know if wiping data would trash them.
You can easily recover your phone by flashing a stock ftf. You may follow this guide: http://forum.xda-developers.com/showpost.php?p=56717587&postcount=4
Oblox said:
You have bootloop because your phone is essentially empty of any OS or recoveries.
Flashtool to stock, find dssmex triple recovery and install that in stock when rooted, load into Philz, clean to install a new ROM and then just wait, it will take a while usually dont worry unless it takes over an hour.
Then flash the custom ROM of choice.
Click to expand...
Click to collapse
Thanks for your explanation sir :good:
Flashtool to stock means i need .ftf file to restore the stock rom ? is it possible to restore stock rom through nandroid backup file that i've created using cwm ?
Well, the problem is solved. My phone back again and a custom rom has been installed.
beespoison said:
Oh god, i don't know about that, because this is the first time i've got bootlop..
Where is i can get the latest version of Philz, would you like to give the link ?
Triple recovery ? maybe 2 recovery is enough
Flashtool, okay i'll try to save my phone..
Click to expand...
Click to collapse
Dont use flashtool..... Youre wasting time.
Just flash Williams kernel using fastboot and flash the custom rom you want.....
Furrydaus said:
Dont use flashtool..... Youre wasting time.
Just flash Williams kernel using fastboot and flash the custom rom you want.....
Click to expand...
Click to collapse
Thanks for your advice, but my phone has been repaired