I am having difficulty with connecting 3g. i am using hellybean rom.. Others are getting 3g signal. but y i9000 is not showing 3g signal. it is still in 2g network.. i unticked the use 2g only option. How to force the phone to use 3g signal ?
ashishji12 said:
I am having difficulty with connecting 3g. i am using hellybean rom.. Others are getting 3g signal. but y i9000 is not showing 3g signal. it is still in 2g network.. i unticked the use 2g only option. How to force the phone to use 3g signal ?
Click to expand...
Click to collapse
hey in which region and network you are using.
I am using it on 3G and no issue it fast and good.
Related
My carrier has bad 3G operation, whilst HSDPA works fine. The problem is that phone sometimes switches between 3G and H, and when it does switch to 3G, there is no internet until it swithes back to H or down to E. I'm almost sure that this is caused by carrier, and I can't fix it with firmware. So I would like my Tab to avoid 3G mode at all, while using H and E. Can I set it to do so?
3Flight said:
My carrier has bad 3G operation, whilst HSDPA works fine. The problem is that phone sometimes switches between 3G and H, and when it does switch to 3G, there is no internet until it swithes back to H or down to E. I'm almost sure that this is caused by carrier, and I can't fix it with firmware. So I would like my Tab to avoid 3G mode at all, while using H and E. Can I set it to do so?
Click to expand...
Click to collapse
Unfortunately, it's impossible, you can either choose "H" & "3G" with wcdma/umts or "G" & "E" with GSM in Mobile Networks. You can't choose to leave out 3G when it's doing H, cause both of them are under wcdma mode.
Of cause, if you leave your "Network mode" to auto, it will jump around gsm and wcdma when it see fit. By choosing it to run GSM mode only, will keep your network connect to "E"/"G(gprs)" ONLY; Or WCDMA for "H"/"3G" ONLY.
helo
3Flight said:
My carrier has bad 3G operation, whilst HSDPA works fine. The problem is that phone sometimes switches between 3G and H, and when it does switch to 3G, there is no internet until it swithes back to H or down to E. I'm almost sure that this is caused by carrier, and I can't fix it with firmware. So I would like my Tab to avoid 3G mode at all, while using H and E. Can I set it to do so?
Click to expand...
Click to collapse
im from malaysia also,im using samsung g5..in my opinion its the the phone or tab firmware or rom problems..because im using maxis and digi broadband..both network are having problem..3g and hsdpa both switch on and back 3g h 3g h..not stabil and anoyying..
is there a trick to force the phone to get an hi-speed connection ,instead of E ?
Of course,where the hi-speed connection is present...
The problem is that there are too much cellphones or wireless pc connected on ...
and is very difficult in same places to get good connection continuously...
I am from Italy TIM..
Regards...tnx
hmm.. i too face that issue sometimes when range is low. but mine keep changing between E, H+ and 3G. What is H+? is it faster than 3g or slower?
do not know ,but for me H and 3g are very good web connection
"E" connection is terrible...i remember 56k modem....
Goes like this, high to low
LTE>H+>H>3G>E
enobrec said:
is there a trick to force the phone to get an hi-speed connection ,instead of E ?
Click to expand...
Click to collapse
In general, your device should be connecting at the highest possible speed. If you are getting Edge, it's probably because your phone can't pick up a 3G signal.
Regards,
Dave
Sent from my GT-N7000 using Tapatalk
Try settings-wireless -mobile networks-network mode and choose wcdma only.
pezx44 said:
Try settings-wireless -mobile networks-network mode and choose wcdma only.
Click to expand...
Click to collapse
i'll try it ...thanx
pezx44 said:
Try settings-wireless -mobile networks-network mode and choose wcdma only.
Click to expand...
Click to collapse
This should work if the area does have a connection higher than 3G, I found this out when I was testing the pre-paid mobile internet connection from my provider and oddly enough it almost always prefer to connect to 3G till I forced WCDMA only and it connects to H just fine getting only about 260kb/s though.
Hi Guys,
I have been having a problem with Ho! No! ROM. I am in India on AIRTEL 3G. Whenever I switch to 2G Network I tend to loose signal and after sometime the signal gets completely lost (EMERGENCY CALLS ONLY is shown). If I remain in 3G only, everything works fine but battery usage is obviously more. Moreover, recently after HO! NO! CM 7.1.3 I am not getting 3G speeds while internet browsing while being on 3G network.
My Mobile Network Settings are like:
Data Enabled: On
International Data Roaming: On
National Data Roaming: Off
Network Mode: GSM/WCDMA(auto mode)
Use only 2G Networks: Off
Do I need to change my radio/baseband according to India (where to find the same and how to do it?)
I didn't have any such problems on CM 7!!!
Please help me out guys!!!
sherichander said:
Hi Guys,
I have been having a problem with Ho! No! ROM. I am in India on AIRTEL 3G. Whenever I switch to 2G Network I tend to loose signal and after sometime the signal gets completely lost (EMERGENCY CALLS ONLY is shown). If I remain in 3G only, everything works fine but battery usage is obviously more. Moreover, recently after HO! NO! CM 7.1.3 I am not getting 3G speeds while internet browsing while being on 3G network.
My Mobile Network Settings are like:
Data Enabled: On
International Data Roaming: On
National Data Roaming: Off
Network Mode: GSM/WCDMA(auto mode)
Use only 2G Networks: Off
Do I need to change my radio/baseband according to India (where to find the same and how to do it?)
I didn't have any such problems on CM 7!!!
Please help me out guys!!!
Click to expand...
Click to collapse
I used MiniMod to switch my base band and now the 2G Signal loss problem is solved. But internet speed is still all messed up on both 2G and 3G. It seems like that this is a problem with HO! NO! ROM rather than base band as my internet browsing was working flawlessly on earlier HO! NO! ROMs without switching the base band.
im on 4.1 and noticed it wasn't wanting to ring or text or connect to data on 2g but will on 3g
so I tried 4.3 didn't make a difference
what could be causing it not to work on 2g signal im using o2 uk I no spare sims to try another network
some strange reason if bars on 2g less then 3 it wont work could this be a issue with the antenna
I am having problem in turing on 3G on my Moto g2. Im on AOSP MM ROM with open gapps pico installed. i cannot switch to 3g as preffered network neither can i change to WCDMA preffered from network app thus im getting only "e" or edge network on my mobile despite having a 3G data pack and having my network sim in 1 slot. Not only on this ROM but even other CM13 roms . can someone help pls?
I also ran into issues after I switching to 2G. Cannot get it back to 3G.
I had to take the Sim out reinsert it back and select 3G.