Xperia T Sudden Death on KK. - Sony Xperia T, TL, TX, V

Hey,
Firstly, I want apologize for the bad language.
My Xperia T have a big problem. When I install any KitKat ROM after few hours later my phone is dead and i must open it and pull out baterry to run. Power+VolumeUp is NOT working, charging too.
I tested: Dirty Unicorns, Carbon Rom, Cyanogenmod. On Every ROM is this same failure. On stock 4.3 with DoomKernel is OK.
After ROM flash I install: Xposed. Viper4A, SuperSU, Spotify, Xperia Home, Youtube, Xperia Keyboard (via CWM), Pimp My Rom (Bravia Engine only).
Running on Dalvik.
Two week's ago i get Facebook Message, LED was blinking blue all night. Morning, when i woke up LED was still blinking normally, but phone was dead.
Please help me.

Related

Bootloop, no CWM, no Flashtool = Z Lost ?

Hello dear Community,
the prehistory ... about 2 weeks ago I get rid of my S2 and switched to the Xperia Z and I`am completely satisfied.
Because of my pre-"experience" with the S2, various Customrom's, Root and CMW I chose this day for these steps in the Xperia Z .
Got this in the course of the day and I Rooted the Phone and installed the latest CWM Recovery (bootloader locked). So far everything is working fine right after installation, I done a backup of my current StockFirmeware, if something goes wrong to have a backup ready.
After the Backup I Flashed this ROM
[ROM] [XZ] [07/03] Xperia KA02.2 Z Revolution ™ |
... via CWM, before the installation of course I wiped the Z, that nothing can go wrong ... I thought (backup?) ... The installation went smoothly, rebooted from the recovery and all i got was a .... Bootloop.
And here I am hanging tight since noon today.
Phone starts ... xperia logo appears, restart ... xperia logo appears, restart etc, etc. I thought I might still'm coming back into CWM, but None, no green LED on boot, if this is so, one should press on to the Volume + button to get into CWM ... doing nothing but looping again and again.
So i waited all day long until the battery was empty. After that i connected the Phone for hour to the charger. After an hour of loading time i tried to turn the phone back on ... But still no green LED .... Bootloop continue.
So i let the battery empty iself again. This time I connected the Phone via USB without switching on. Started the Sony Flashtool pressed the Volume- key and the Xperia connected to the Software, but due the Locked Bootloader i can´t to nothing.
That´s what i have been tried to bring this thing back to Life ...
Hope that anybody can help me get rid of this Silly situation
and BTW: SORRY FOR MY BAD ENGLISH !!!
julianoo said:
Hello dear Community,
the prehistory ... about 2 weeks ago I get rid of my S2 and switched to the Xperia Z and I`am completely satisfied.
Because of my pre-"experience" with the S2, various Customrom's, Root and CMW I chose this day for these steps in the Xperia Z .
Got this in the course of the day and I Rooted the Phone and installed the latest CWM Recovery (bootloader locked). So far everything is working fine right after installation, I done a backup of my current StockFirmeware, if something goes wrong to have a backup ready.
After the Backup I Flashed this ROM
[ROM] [XZ] [07/03] Xperia KA02.2 Z Revolution ™ |
... via CWM, before the installation of course I wiped the Z, that nothing can go wrong ... I thought (backup?) ... The installation went smoothly, rebooted from the recovery and all i got was a .... Bootloop.
And here I am hanging tight since noon today.
Phone starts ... xperia logo appears, restart ... xperia logo appears, restart etc, etc. I thought I might still'm coming back into CWM, but None, no green LED on boot, if this is so, one should press on to the Volume + button to get into CWM ... doing nothing but looping again and again.
So i waited all day long until the battery was empty. After that i connected the Phone for hour to the charger. After an hour of loading time i tried to turn the phone back on ... But still no green LED .... Bootloop continue.
So i let the battery empty iself again. This time I connected the Phone via USB without switching on. Started the Sony Flashtool pressed the Volume- key and the Xperia connected to the Software, but due the Locked Bootloader i can´t to nothing.
That´s what i have been tried to bring this thing back to Life ...
Hope that anybody can help me get rid of this Silly situation
and BTW: SORRY FOR MY BAD ENGLISH !!!
Click to expand...
Click to collapse
You can try Sony Update Service.
Thank´s for your fast reply,
git my Problem solved
Wrong version of Flashtool was installed, so i downloadet the beta2 out of the Forum and now .... my Phone is back Alife
For those who have the same issue, try too re-flash the firmware following the procedure below :
1/ Follow the procedure for flashtool
Tick erase data if it still does not work
2/ Wait for flashtool to tell you to conned your Xperia Z
When it does get ready to connect it (step 3)
3/ Wait for you bootloop cycle end
--> Wait for the screen to turn black
--> Once it's black press and hold volume down
--> Connect your Xperia Z to PC
Step 3 must be done really quickly before the bootloop cycle restarts.
Hope this helps !
if it does press thanks button
Thank u
I did this procedure and it worked
My xperia z connected to pc in flashmode in step 3
And i flashed kernel and rom after that
Thank u very much

[Q] Brick/Frozen/Loop after failed to downgrade ICS from JB using flashtool

Hi guys, I'm having a problem like title stated.
This morning, I used flashtool to flash an ICS stock rom to my Xperia TX running JB.
Everything were good until end of installation. When I finished flashing, I tried to boot up
my phone, but it kept repeating to show:
SONY logo > A triangle with "!" inside, there's a phone icon beside it > off
I had searched all over the internet whole day but without a clue.
Flashtool is not helping as well, whenever I plug in and wanted to flash again, the same thing just
happened over and over again.
Please help me before I need to send it for someone to fix it.
Thank you in advanced!
Just leave it for a while, it will eventually boot up
It could take a few hours
I have had that problem, I just left it over night and it was fine

[Q] Xperia TX boot loop after system restart

Hi!
I have been using Xperia TX for a few months, and I have experienced freezing problems for about 4~5 times, this all happens while I was updating apps in the Play store.
The phone gets a bit laggy as soon as it started updating apps, and it freezes soon. I am not sure if it is considered "freeze", since the download/installing progress bar is progressing, however I was not able to give any input at this time, so after one minute, the screen turn off as the screensaver is set to one minute.
I can't do anything else since it is not accepting inputs, so I removed the battery and inserted it back, and power on the phone, then I will get a triangle with a screwdriver icon, just wait for about 15 seconds and it will get pass there and boots normally. Sometimes I don't even have to pull off the battery, the phone restarts automatically.
Above were my past experience, however my TX freezes while updating apps in the Play store again today, and it restarted automatically. It boots past both SONY and Xperia logo, but got stuck in the "flow" animation, and restarted itself, doing this over and over again, it seems that it have got into a boot loop.
Note that I am using stock Android 4.0.4 firmware, I can't remember the exact firmware version now.
Is there any troubleshooting I can do before trying to hard reset the phone?
Also I would like to know if someone have the same experience (system freezing while updating apps, and does not accept any inputs, requires a reboot) with me before?
Thanks!
even if you get out of the bootloop, there no guarantee that the issue of freezing will be gone.
i suggest you repair using pc companion and then upgrade to the latest JB rom.
Else download the latest JB .ftf and flash it using flashtool.
Thanks for your feedback!
Just flashed the phone with Sony Update Service, and it is working fine now.

Xperia Z C6603 doesn't boot properly, need help

Hi folks, i have a Xperia Z C6603 with unlocked Bootloader. I installed the latest 4.4.4 Stock Rom (.292) via Flashtool. The only thing it shows after it boots up, is the black screen with the back button (take a look at the pic) and it reboots after a couple of seconds. I've also flashed a 4.1.2 Stock Rom (.253) it boots up normally, but there is no WiFi or cellular connection. It also shows me IMEI unknown I've also tried the Emma program, with the same black screen and instantly reboot Anyone knows what i can do ?
I've had this exact same problem for the last couple of weeks, but today I installed the ftf files from this thread (C6603_10.5.1.A.0.292_RU.ftf) and everything seems to be working. I've no idea how, and I'm not sure whether I should dare to put the phone back to where it was before all this happened, but so far, so good.
Edit - Well it lasted a few hours, then froze and rebooted, and now it's back to broken again.
Thanks man, ill give it a try and report.

I messed up my phone; Phone is showing kernel logo for some 20 minutes and shut down.

Hi,
I was trying to install stryflex rom (http://forum.xda-developers.com/xpe...-stryflex2013266073-lp-official-sony-t3180637) on my xperia yesterday. I already tried stryflex in November but it had some bugs so I had to move to 4.3 rom at that time. I successfully installed stryflex yesterday but touchscreen was not working even upon multiple restarts. I thought to re-flash whole thing. Don't know how but I think I accidentally flashed some other files in kernel via flashboot software and after that phone was not taking any charge. Showing red led even after charging for more than 1 hours. I checked few kernels and installed William kernel using that .elf file and flashing as 'flash kernel' option in fastboot mode.
After that, phone is starting but showing William kernel for some 15-20 minutes. I tried doomkernel and it also showed it's logo for some 20 minutes and shut down and restarts again. Phone is still not taking charge and showing red led. I think it is not taking more that 1-2% charge.
I don't know what to do. Please tell me solution in schematically way.
Also, how installing custom roms works? Which process (installing rom, twrp etc) comes first and which last.
Any help would be highly appreciated.
Thank You
destiny4life said:
Hi,
I was trying to install stryflex rom (http://forum.xda-developers.com/xpe...-stryflex2013266073-lp-official-sony-t3180637) on my xperia yesterday. I already tried stryflex in November but it had some bugs so I had to move to 4.3 rom at that time. I successfully installed stryflex yesterday but touchscreen was not working even upon multiple restarts. I thought to re-flash whole thing. Don't know how but I think I accidentally flashed some other files in kernel via flashboot software and after that phone was not taking any charge. Showing red led even after charging for more than 1 hours. I checked few kernels and installed William kernel using that .elf file and flashing as 'flash kernel' option in fastboot mode.
After that, phone is starting but showing William kernel for some 15-20 minutes. I tried doomkernel and it also showed it's logo for some 20 minutes and shut down and restarts again. Phone is still not taking charge and showing red led. I think it is not taking more that 1-2% charge.
I don't know what to do. Please tell me solution in schematically way.
Also, how installing custom roms works? Which process (installing rom, twrp etc) comes first and which last.
Any help would be highly appreciated.
Thank You
Click to expand...
Click to collapse
if you can flash kernel via flashtool its great, but doomlords or William kernel looks like dont support offline charge so if you have at leats couple percent of battery try to flash some costum roms ,
i recommend this few steps:
1. flash doomlord kernel ( .elf) or lates cynogen recovery ( .img) via flashtool
2. if you flash it , try to put phone on charger if you have low battery (0-10 %) , or if you have over 10 %
ps. Lastest cm recovery should support offline charging
3 .just flash costum CM 12.1 form sd card
ps 2.( "Phone is still not taking charge and showing red led. I think it is not taking more that 1-2% charge. ")
its seams you have couple percents of battery , so installing cosutm rom should not be a problem
anyway let us know what happend

Categories

Resources