Hey guys, yesterday i turned on stamina mode, the screen somehow crashed, purple lines from all sides. Turned of the screen and every was good. Then in the evening i connected my magnetic charger, didn't work. But the same thing appeared with display, turned it off and everything was again okay.. But now i am a bit worried. Did that happen to somebody? Thanks
donscarface said:
Hey guys, yesterday i turned on stamina mode, the screen somehow crashed, purple lines from all sides. Turned of the screen and every was good. Then in the evening i connected my magnetic charger, didn't work. But the same thing appeared with display, turned it off and everything was again okay.. But now i am a bit worried. Did that happen to somebody? Thanks
Click to expand...
Click to collapse
Seems that you may have a defective display or could be the heat..
How long did you had the phone for? And try to do a factory reset. Maybe its a software issue
For thr magnet charger, I use one myself as well. I don't think it has anything to do with it
Sent from my D5803 using XDA Free mobile app
Related
Well im pretty good with electronic, dis assembly and reassembly... however I may have bit the farm here. I replaced my digitizer for my device and the adhesive I purchased wasnt good enough so it was causing touch screen issues... So I took it all apart again and put it all back together to find OMG it wont turn on? Fully charged battery so I know thats not the issue and everything seems to be put in the right place (as if there is any other way to re-assemble this phone)....
So I did some trouble shooting... I tried switching to an original charger, attempted hard reboot assumed maybe the device was confused... left it on the charger as if god himself removed the remaining battery life all to no avail... However one thing I did notice is that for a while when the device was unplugged and sitting there the LED light would periodically blink red... hmm couldnt find anything on that ... Also when I remove the battery leads and plug it in the LED light illuminates green and stays that way regardless there still is no function to the phone literally a blank screen... I checked the screen and digitizer for damages both on its leads and the devices themselves and found there to be nothing wrong with them...
Im pretty sure I know the answer Im just hoping that Im wrong..
Also heres something Ive noticed as well, that when I plug both the phone in and leave the battery in it gets dangerously hot like battery about to explode hot after about 10 minutes or so
Berrabus said:
Also heres something Ive noticed as well, that when I plug both the phone in and leave the battery in it gets dangerously hot like battery about to explode hot after about 10 minutes or so
Click to expand...
Click to collapse
I buy broken Atrix HDs off of eBay all the time so I may be able to help. I've noticed that even though the battery is fully charged, when replacing the digitizer, the phone will think it's dead until it hits 100%. I usually have to hold the power button a Lil longer than normal, and when it turns on it will say 1% bat, remaining. It will charge the remaining battery and instantly jump to 100% when it's full.
Tl;dr: hold power until it turns on, charge to 100%
Markyzz said:
I buy broken Atrix HDs off of eBay all the time so I may be able to help. I've noticed that even though the battery is fully charged, when replacing the digitizer, the phone will think it's dead until it hits 100%. I usually have to hold the power button a Lil longer than normal, and when it turns on it will say 1% bat, remaining. It will charge the remaining battery and instantly jump to 100% when it's full.
Tl;dr: hold power until it turns on, charge to 100%
Click to expand...
Click to collapse
Well heres the thing. I already have been using the phone since Ive replaced the digitizer and its functioned relatively properly (aside from the adhesive not holding the digitizer down) the thing that concerns me is when I hook the battery back up to it and plug the phone in it gets dangerously hot like literally to the point where I question weather or not its going to explode also it doesnt show any LED function with the battery connected.
Go through and double check all of your connections. Also, connect it to your computer and see what device manager says.
Sent from my MB886 using xda premium
darknessrise1234 said:
Go through and double check all of your connections. Also, connect it to your computer and see what device manager says.
Sent from my MB886 using xda premium
Click to expand...
Click to collapse
Checked, rechecked and triple checked the connections as you know with the MB886 the connections only go one way and they either are in or not theres no middle-man. Unfortunatly my data-cable is not functioning so I cannot hook it up to the PC at the moment however I assume that if there is no function or charge with it just being plugged into the power cable then likewise would result from a PC connection. Not to mention the unexplained heat... like Im saying its almost to hot to hold kinda heat..
Well, last one I bricked it would be green light anytime it was plugged in and it had a specific register on the device manager.
Sent from my MB886 using xda premium
darknessrise1234 said:
Well, last one I bricked it would be green light anytime it was plugged in and it had a specific register on the device manager.
Sent from my MB886 using xda premium
Click to expand...
Click to collapse
When I plug it into my computer it says USB INPUT DEVICE RECOGNIZED DRIVERS INSTALLED CORRECTLY! To me that all sounds posative! Question is where to from here?
Thats with the battery out... When I hook the battery up it immediatly begins to get warm and recognizes as a Motorola USB Composite Device then starts disconnecting/reconnecting... Also during this process I noticed that the aluminum battery chassis is cracked right where the battery connects to the unit...
Do you have a second battery? If so, test the other battery. Otherwise, I am out of thoughts.
Sent from my Atrix HD using xda premium
My Z1 has started playing silly games, it no longer charges properly! It will be fine for a while, typically ten minutes or so, then it will pop up a warning message saying the connected power source isn't charging the battery. It will then drain faster than it can charge. Last night for example I put it on charge around 7pm with 67% and took it off at 8am this morning, but it's dropped to 3%. I've tried various chargers and cables, the dock, all 3 of my magnetic cables (how I normally it charge anyway) and tried all the usual methods of reset such as holding the red button under the SIM port down. Nothing works. It started around two weeks ago, since then I have flashed another firmware but the problem persists.
My phone is currently plugged into a 2 amp capable magnetic dock plug with the Sony plug that comes in the box. Just typing this message it's drained the battery 9% while on charge, wifi on and network off, screen brightness down and no other apps open.
I've spoken to Sony and they won't do anything, my rear glass is cracked so they won't even look at it and they seem to think it's water damage! The phone hasn't ever seen water so that's a load of BS from them.
What can I do?
Sent from my C6903 using XDA Premium 4 mobile app
Use the normal USB charger
gregbradley said:
Use the normal USB charger
Click to expand...
Click to collapse
That doesn't work, the problem still persists. That's the first charger I tried when the handset started not taking a charge.
Sent from my C6903 using XDA Premium 4 mobile app
Looks like you need a new device as it could be when the back cracked the battery got moisture (not direct) infected
Sent from my C6903 using Tapatalk
AndroidDan said:
Looks like you need a new device as it could be when the back cracked the battery got moisture (not direct) infected
Sent from my C6903 using Tapatalk
Click to expand...
Click to collapse
Greaaaaaaat. That's the last thing I need :-S I've just tried my girlfriends iPhone charger and it seems to charge it, very slowly. I will have to dig my Blackberry out as a back up and see how the Z1 goes.
Sent from my C6903 using XDA Premium 4 mobile app
I have the same problem after updating to KitKat. I'm using dock station too, but not the one that came with my phone (I didn't got any with it).
I put my phone to charge, and after 5-10 minutes it starts to show the message. One time I found my phone drained till 0% in the morning. So, I found a simple solution for my phone. Before I put the phone to charge, I turn it off, wait 2-3 seconds then turn it on. I immediately put the phone to the dock in the boot process. That's the only way I can properly charge my phone.
Hope this will help you...
Vengeance66 said:
I have the same problem after updating to KitKat. I'm using dock station too, but not the one that came with my phone (I didn't got any with it).
I put my phone to charge, and after 5-10 minutes it starts to show the message. One time I found my phone drained till 0% in the morning. So, I found a simple solution for my phone. Before I put the phone to charge, I turn it off, wait 2-3 seconds then turn it on. I immediately put the phone to the dock in the boot process. That's the only way I can properly charge my phone.
Hope this will help you...
Click to expand...
Click to collapse
Excellent! I will have a go and see if it works for me, Thankyou!
Sent from my C6903 using XDA Premium 4 mobile app
Hey guys, one day i connected my magnetic charger and something happened with my screen.(shown in screenshots bellow)
So i thought it's because of the charger, i bought another one and the same happened.
Then few days later it happened when i put my phone in stamina mode.
I just turned off the display, then turn on and everything was good.
Did this happen to anybody?
donscarface said:
Hey guys, one day i connected my magnetic charger and something happened with my screen.(shown in screenshots bellow)
So i thought it's because of the charger, i bought another one and the same happened.
Then few days later it happened when i put my phone in stamina mode.
I just turned off the display, then turn on and everything was good.
Did this happen to anybody?
Click to expand...
Click to collapse
Hi, just an idea: plz try to turn off NFC and check if the problem still exists..
trickymoon said:
Hi, just an idea: plz try to turn off NFC and check if the problem still exists..
Click to expand...
Click to collapse
I am not using it., it 's always off....
Also, i tried to turn on and turn off the stamina mode about 10 times in a rok. The problem happens all the time.
Can somebody please try it?
Thanks
Hi everyone, yesterday I used NeMa's battery calibration to reset the batterystats on my Xperia Z3 Compact running the latest Cyanogenmod. I had done it when the phone was charged at 100% and noticed that the battery instantly dipped to 99% afterwards. I took note but I wasn't worried at the time. Last night I left the phone on its charging dock and slept for about 5 hours and 30 minutes. When I woke up I picked up the phone and noticed it was hot. The screen was fine at the time so I checked the battery percentage, saying it was stuck at 99% which leaves me to believe that the battery was stuck in a charging loop from a bad calibration. I texted someone and also noticed that the Swype keyboard was laggy and unresponsive, but with my lock password, etc. it seemed to be fine.
I powered the phone down and slowly tried to dissipate heat with warm water and later colder water. When I tried to power the phone on, it had shown normal booting until the end when the screen gave out. Currently, it will show normal LED lights up top and calls will still register, but the screen is dark and doesn't seem to have promising digitizer input because I can't answer the call even though I know where to touch the screen to answer it.
Has this happened to anyone? This is my first encounter dealing with this. Any fixes (screen response or proper calibration), or would I just have to get it repaired?
Hello, check this things out
only 2 ways to find out if the screen is working or not working at all
a) a very dark place... start the phone.. maybe the screen is not iluminted proprey ! and maybe the screen is visible ...but very limited.
b) buy a mhl to hdmi cable.. to connect from phone to a smartv.
And see if the touch respons.. if yes the only the screen i out.. if not the screen +touch is out ( dead)
Yeah the screen and digitizer are fried. I'm going to try and return it to the seller stating a defective battery. Has this happened to anyone else? I just need to know if there are any fixes to this if I were to get the same phone.
FactionsOfArt said:
Yeah the screen and digitizer are fried. I'm going to try and return it to the seller stating a defective battery. Has this happened to anyone else? I just need to know if there are any fixes to this if I were to get the same phone.
Click to expand...
Click to collapse
Poor seller, you blew up your phone with bad software and water and you want someone else to pay for it.
FactionsOfArt said:
Hi everyone, yesterday I used NeMa's battery calibration to reset the batterystats on my Xperia Z3 Compact running the latest Cyanogenmod. I had done it when the phone was charged at 100% and noticed that the battery instantly dipped to 99% afterwards. I took note but I wasn't worried at the time. Last night I left the phone on its charging dock and slept for about 5 hours and 30 minutes. When I woke up I picked up the phone and noticed it was hot. The screen was fine at the time so I checked the battery percentage, saying it was stuck at 99% which leaves me to believe that the battery was stuck in a charging loop from a bad calibration. I texted someone and also noticed that the Swype keyboard was laggy and unresponsive, but with my lock password, etc. it seemed to be fine.
I powered the phone down and slowly tried to dissipate heat with warm water and later colder water. When I tried to power the phone on, it had shown normal booting until the end when the screen gave out. Currently, it will show normal LED lights up top and calls will still register, but the screen is dark and doesn't seem to have promising digitizer input because I can't answer the call even though I know where to touch the screen to answer it.
Has this happened to anyone? This is my first encounter dealing with this. Any fixes (screen response or proper calibration), or would I just have to get it repaired?
Click to expand...
Click to collapse
This: water
Hey guys, two days ago I found my htc picking up dust and decided to buy a battery and a screen replacement, that means the whole front with screen and digitizer, the battery works fine(creation date was from this year!)but found out that the new screen was with the led broken. So I went back with the old one which still works, suddenly after screwing every screw, I connected to charge and the screen didn't turn on, the notification light was the red charging status. Weird. After that I tried to turn on the phone, I received the vibration but not the screen welcome, didn't turn on, tried to turn off and saw both bottom buttons flash repeatedly. And that it's. What could it be?
Sent from my iPhone using Tapatalk