Hi, everybody,
I have a Smartwatch Asus ZenWatch 3.
A couple of days ago I changed my android phone and when I tryed to setup my Watch again, I couldn't got it working because it got frozen in the screen below.
"Continue setup on the phone"
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
I followed a lot of procedures to try to fix it but I couldnt
Then I started to read how to do a firmware recovery and this is the reason why I am here now.
The buttons and the screen are no not responding, The only way to put it in "Fastboot Mode!", is opening the watch and put the battery out.
Then, i press the buttons and got the following screen:
Then, with the drivers installed in my Windows 10 ( and the command: fastboot oem unlock ) I got stucked on the following screen:
The screen is again not responding at all, the buttons neither. I suppose it is because I'm not able to put the Watch in the "USB debugging mode" from the begining. But it is really imposible form me, because the watch OS never start.
I hope someone could help me.
Regards from Argentina.
Hi,
I want to ask this in a more directly way:
It's possible, to make a recovery or flashboot if I can't access to the watch settings for setup the "USB debugging mode" ?
Hi, I fixed the issue doing the following:
Wait until the batery is empty, and the device shutdown.
Then put the power charger, ( you can confirm this by a short vibration)
After that:
1. Press the middle and the lower buttons at same time (The watch will boot on recovery mode with a green android).
2. Swipe away thew android and you will see a menu, then simply perform first a "factory reset user data" (or similar) then choose reboot the system and thas all.
Related
So recently I did a stupid and accidentally switched off my OPO during an update installation and completely screwed it all up. I tried switching it back on only to find that it was stuck in a recovery mode loop. I then hit factory reset in a last ditch attempt to save the poor bugger without flashing it and even that didn't work.
I've then had to resort to flashing it using the OPO toolkit software on my PC however when connecting to the PC, my OPO only shows up as an MTP USB Device and nothing else. I have tried installing recommended Samsung drivers for the phone but I wasn't able to as it the "update drivers" button was greyed out on the MTP USB Device properties window.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Basically, the OPO toolkit will not work as no android devices are recognised by the PC even though an android device is showing up in the control panel.
There is no way I can currently access the settings on my phone due to recovery mode loop obviously.
The last thing I want to do here is end up with being forced to use the OnePlus support which I hope most of you understand why.
Thanks for any suggestions!
Hi,
This thread is being moved to your own dedicated forum , where the experts may be able to help you better.
Good luck!
Put it in downloading mode and then use adb to use the toolkit since bow u don't have a os on the OPO happened with me too but I fixed it this way
Sent from my A0001 using Tapatalk
Hi everyone,
Seeking for idea(s) from a genius group.
I got a Nexus 6 with a broken screen ( really bad can't see anything , just black), want to get the data(photos) out of the phone.
the system debugging mode is not enabled, it's running on android 6.0.
here is what i have tried:
plug the phone into PC via USB, PC does not recognize any device, hold on power button and volume down for few seconds, the PC recognize the following: (fastboot shamu S)
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
can't post outside link
drive.google.com/file/d/0B3OMYlBbrdD2Ti1WSWpNdUEySjg/view?usp=sharing
/drive.google.com/file/d/0B3OMYlBbrdD2am92bUxWb0xuRkE/view?usp=sharing
not sure what can be done at this point.
also bought a used Nexus 6 in good working condition, swap screen did not work, the screen did not light up. ( some says the screen is locked to the motherboard, not sure about this).
googled some info, the last way would be remove the 32Gb NAND flash from the motherboard by un-soldering , and install to another motherboard, this may require some special tools and don't think it's a home DIY project.
Any shared idea(s) would be really appreciated.
Thanks.
James
hpmarsum said:
...., hold on power button and volume down for few seconds, the PC recognize the following: (fastboot shamu S)
Any shared idea(s) would be really appreciated.
Click to expand...
Click to collapse
http://stackoverflow.com/questions/...pull-all-files-of-a-folder-present-in-sd-card
The system debugging mode is not enable, will try to run the ADB. Thanks.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
[/IMG]I dropped by Asus ROG Phone II and the volume buttons are stuck inside. The phone is now stuck at the fastboot mode and if I keep the power button held then it still reboots into fastboot mode and for some reason I cannot select the start option too ( and cannot toggle options either because the volume buttons are smashed in ).
I attempted using minimal adb and fastboot but to no avail. It rebooted right into fastboot mode. I used the following commands -
fastboot devices
fastboot reboot
I cannot dislodge the volume buttons and cannot open the phone. Repairing it is not an option due to the quarantine. Need a fix very urgently, all my business is on my phone. Any help will be heavily appreciated.
Omg... it happened something similar to me, but with the time, the volume button it's going better. I was unlocking it just hitting it with my phalanx/midjoint of some finger (3rd, normally), and it worked.
Let us know how are you going. Try the hit in different directions/strength vectors... it sounds a joke, but it's true xD
uriii13 said:
Omg... it happened something similar to me, but with the time, the volume button it's going better. I was unlocking it just hitting it with my phalanx/midjoint of some finger (3rd, normally), and it worked.
Let us know how are you going. Try the hit in different directions/strength vectors... it sounds a joke, but it's true xD
Click to expand...
Click to collapse
Tried that already, not working, mine's smashed in for good. Need a software fix.
Hello,
I'm kind in trouble now, i've just power off my phone because he won't receive text message ( happen often, even before i root it, need to reboot him and get my text message instantly. ), so i start the phone back using the following combo-key :
hold volume up + bixby + power
( I've rooted my phone using Odin, Magisk and Smali-patcher. )
But now my phone keep rebooting, showing this image, then the bootloader warning thing, then this image again :
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
And then, after maybe 1 min of waiting, it goes into downloading mode. Each time, no matter what i do, i know how to do the reboot key-combo because i've rooted my phone maybe 3 months ago and i've rebooted him a couple of time, but today this happen and so i'm actually lost and don't know what to do ...
Any help is welcome,
I hope you guys could help me,
Thanks a lot !
Edit : I could go in recovery mode too, but that's all. Recovery mode or infinite "downloading mode" message :crying:
Why are you using those keys to restart the phone? That key combination only leads to the Bootloader/Download screen that yo describe. You say you rooted the device months ago and surely you've rebooted since then, is the method you always use? I know this is a late response but this just caught my eye.
I bought a used phone. The boot loader was unlocked from the beginning. I'm doing the steps to install Android 10, but something is weird.
I tried to go through the fastboot mode, but when I press the button, it doesn't respond, so I enter the computer through adb and there is no response, and then it returns to the system soon. When entering the boot loader mode to adb, a blue LED turns on. When I enter the recovery mode into adb, there is no reaction the same as when entering the fastboot. Also, when the power is turned off and plugged in, it automatically enters the flash mode.
When I first use the phone, the battery level is displayed when I plug it in, and it responds when I turn it on, but when I reinstall the stock rom of the same version with flashtool, nothing happens. There is no response even though I installed the 8.0 global version with the flashtool obtained from the deveploperworld homepage.
Strangely, the Android system works fine.
What should I do?
(I am Korean, and the sentences may be weird using Google Translate. Please understand.)
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
I installed the Google USB driver and updated it, but it looks like this..
problem Solved!
Inscartia said:
I installed the Google USB driver and updated it, but it looks like this..
Click to expand...
Click to collapse
Solved the problem! If the Google USB driver does not work when recognized as other devices, try updating with the Samsung USB driver. It is recognized as a samsung adb interface and is recognized as normal in the fastboot devices command. You can install twrp in this state!