hi its long time now that i hav been trying to get my xda iis working but no success. my xda iis is stuck in bootloader mode when i place it on cradel its display changes from serial to usb but my pc cant detect it. i hav tried all kind of roms but they say connection failed. i hav tried sd card method but getting update is not allowed section 1 error. will any one help me to sort this out. is there any other way to programmed the xda and make it working. i hav tried xda iis nb1 file downloaded from net but got sectoion 1 error. PLZZZZZZZZZZZZZZZZZZZZZZ help meee.
thanks
I had the same problem...
Yes, I had read all of wiki but could not find the solution for me. Then while I was reading some other posts I came across someone that said they had removed their battery and then held the hard reset sequence for over 1 minute and then replaced the battery. Since I was desperate I thought it couldn't hurt so I tried it.
Strangely enough, that was the solution!!!!
I'm now successfully upgraded!!!!
Help
Since it is showing Bootloader ...the device is alive...WHat you hv to do is download the suitable ROM say UK or Asian for yr 2s and just Flash yr device...may be that help
Related
Hi everyone, I earlier today tried to upgrade the official firmware on my Galaxy S though Keiss and it seemed to go well, it said that when the phone finishes rebooting the upgrade will be successful but the phone never did finish rebooting, all it does now is show the S logo for a minute or 2 then the screen goes blank and every 30 seconds or so it vibrates.
Unfortunately my phone is one of the ones that does not have the 3 button recovery option and Keiss no longer recognises the phone so I haven't got a clue what to do to sort out this mess..
Please please please help me.......
Thanks,
Gareth
Yea.
Can you get in root menu. Search in the forums for bricked phone fixes
I hope you find a solution for it.
If not well just send it back to the shop and tell about it. DOnt worry,
Its not your fault since its official update
A old member
Sent from my GT-I9000 using XDA App xD
Sent from my HTC Wildfire using XDA App-put out a post about half hour ago but I never stated my problems...got sim free,unlocked sgs I bricked it I could only d/load via jig,so I flashed it using odin but I must've done it wrong as I got no network connection, incoming + outgoing wasn't viable,I tried flashing it again (infinity),then it bricked again,as of now my galaxy is "dead",if any 1 can help me it would b appreciated,I do not have much knowledge apart from basics so please don't be smart as I am only asking for help here,oh I have to use a jig as I can't get 3 button mode,also I formatted my internal + external memory (8gb + 16gb)....that was the last advice I got + think this Is where my problem started from?thank you....
pmb6177 said:
Sent from my HTC Wildfire using XDA App-put out a post about half hour ago but I never stated my problems...got sim free,unlocked sgs I bricked it I could only d/load via jig,so I flashed it using odin but I must've done it wrong as I got no network connection, incoming + outgoing wasn't viable,I tried flashing it again (infinity),then it bricked again,as of now my galaxy is "dead",if any 1 can help me it would b appreciated,I do not have much knowledge apart from basics so please don't be smart as I am only asking for help here,oh I have to use a jig as I can't get 3 button mode,also I formatted my internal + external memory (8gb + 16gb)....that was the last advice I got + think this Is where my problem started from?thank you....
Click to expand...
Click to collapse
OK so if you can get into download? If you can then its a matter of getting Odin to see the phone - which really means getting windows to recognize the phone. This would mean that odin does not light up in one of the com ports.
If this assumption is right, make you have the latest drivers (see other posts - I had a link in another post so if you look for my posts you'll find it), reinstall kies (but do not have it open), clean the usb port/cable on the phone and computer with alcohol just to be sure (that was my old issue and it takes forever to troubleshoot), then put into download with jig (I assume you start with a battery pull?). If you've done the kies/drivers thing (good chance if your asking on this forum - just try the cleaning).
You can also try various different usb ports - the theory is the one at the back of a desktop work best but my laptop ones seem fine (now - see cleaning above).
I know this is not that step by step it sounds like your trouble is the connection not the steps as you have already attepted the flash.
If still not working , try to vary the connect order (odin first, then connect or reverse etc).
From there follow a good odin guide and flash a full stock firmware to start (presumably your official one).
I believe you are only truly dead when you cannot get to download mode.
Good luck!
Thank you for taking the time to send that post ; one last thing ... any thoughts on getting my sgs to "day 1" , like before all the trouble I was stock eclair 2.1,Vodafone,blah,blah ; how do I get back after formatting both my internal + external , I'm presuming I've erased my stock FW?
Sent from my HTC Wildfire using XDA App
I think you also got similar advice to mine on another post. Don't worry about going to day 1 with eclair. If you flash a stock froyo firmware with odin you'll have a phone like it came out yesterday. Now, it will also likely be unrooted and maybe locked (I'm not unlocked so I'm not sure about that part).
So once you get to the stock firmware you'll need to root again and maybe unlock (stock is stock after all). You may want to just try Darky's resurection rom (for Odin use)
, link here, which should make your phone faster and keep you rooted and unlocked.
If you don't care about root etc, then I think stock is fine as long as it doesn't lock the phone to another provider (use the search function in the forums). One warning is once you know how to change things (and recover) you might spend hours trying to play with the custom roms just because you can .
Good luck in the AM
Hello everybody,
Ive tried to root my Razr I, but i stucked with unlocking the bootloader.
Ive done how its written in this forum threat --> http://forum.xda-developers.com/showthread.php?t=1928551
My problem is now, that Im getting always this error massage (Attachement)
Then the phone turns off, vibrates 2 times, and goes on, until the battery is empty.
Can somebody help me?:angel:
Greeting from Germany
dertortenguss
Have you tried getting into the bootloader with power button and volume down button if you can then I suggest you then connect it to your PC and flash stock software again for your country and region via rsd lite ...
And the image you posted isn't an error it's the moto bootloader warning telling you that you have unlocked your bootloader and now your device has no warranty..
Sent from my XT890 using XDA Premium HD app
There is a german forum with german step-by-step discription, how to unlock and many more.
You can find it here www.android-hilfe.de
So maybe you are interested to have a look at this.
via Xoom 2 & Tapatalk 4
Hello Guys,
@dog121: Ive already tried it, but it didnt work. RSD lite says, it cant enter the Flash Mode. Maybe Ive chosen the wrong Firmware, but I actually dont know which is the right, there is so much.
I knowed that, but after the message occures, nothing more comes and after a few seconds the System boots again.
@icual: Ive already have taken a look there, but after I didnt find an answer, all my friends said I should ask the XDAs. I just opened a threat there.
Greets
Which version of rsd lite are you using...
Sent from my XT890 using XDA Premium HD app
IT WORKS!!!!
Ive tried it often.
RSD 6.1.5
Everytime I had the message ''gpt failed''
Suddenly it did work.
Thank you for your time.
Greets
hi everybody,
I'm stuck!
I' tried everything I can think of, I've search hi and lo and I cant find a fix for my problem. My phone for the last several months has been working flawlessly with twrp/trickdroid but since there dosen't seem to be any more support for trick droid I decided to put another rom on the phone. Now I've never had an issue doing things this way but something is screwed up and I could use someone who is smarter than me help. I wiped the phone and now I cant get my phone and pc to communicate. Everytime I try to adb sideload i get an error stating device not found. twrp recovery is still on the phone and i can still boot into the boot loader if needed. I just cant put my new rom on the phone. I've done everything i can think of, searched everywhere i think possible. this isn't my first android that iv modded but it is the first time i haven't been able to find a solution for my problem. please help!
Run a ruu exe
Sent from my HTC One using Tapatalk
Hello im a newbie on the lumia front, i used the Windows insider app to update to win 10 but after the install the fone was left in boot loop so i used the thread install 1024? In lumia to fix the mess. However acter the flash i got the "successful flash" message but when the fone rebooted i was left with no imei number & cant leave flight mode. I hope somebody out there knows of a way to fix this problem. Thanks in advance to anyone that can help. Dave.
mrdavetarthur said:
Hello im a newbie on the lumia front, i used the Windows insider app to update to win 10 but after the install the fone was left in boot loop so i used the thread install 1024? In lumia to fix the mess. However acter the flash i got the "successful flash" message but when the fone rebooted i was left with no imei number & cant leave flight mode. I hope somebody out there knows of a way to fix this problem. Thanks in advance to anyone that can help. Dave.
Click to expand...
Click to collapse
First try Hard Reset, if that wont help, the go back to stock 8.1 update 2 (with Windows Device Recovery Tool), then with slow ring update it to 10586.11. For now use only what Microsoft offers, dont experiment for now, because you'll have a problem again. There is a lot of bugs on no official builds.
Hello Opus Dei, ive followed your instructions to the letter but still cant leave flight mode. Do you have anymore ideas on how i can releave my problem? I dont know if this info will help you any - I'm using a Microsoft Lumia640 LTE, i was on stock rom then i installed the insiders app & updated my phone but i used the "fast" method. The first update was fine then a couple of days later i had another update note so i did that but when the update was finished & the fone went to reboot itself it just kept boot-looping, i left it doing this overnite but still no joy so i used the "install 105##" but when the fone rebooted it was stuck in flight mode & i cant get round it & i'd bought the fone for my sons birthday which is this week so im willing to try any of your instructions to solve the problem. Im hoping you or anybody else has a solution to get me out of this situation. Thanks to all the helpers - Dave.
Ive noticed that in the "extras & info" section it says "Mobile Operator 000-GB" which ive found to mean open network but my fone was bought locked to Vodafone & when i turn it on its branded with Vodafone. Could this be anything to do with my problem?