can any one help me?
i have mda III and when i try to use sd card i can´t read or save , i can´t use sd card
I'm not sure if this is the problem however I had a problem with my xv6600 and it was the connector pins on the SD card. I had to open it up and bend the pins back down to make better contact. After that I was able to read the SD card just fine and I decided to try another card that I couldn't use before and it worked great too. Hope this helps for you.
Related
Hi XDA Gurus,
Recently when i was trying to install TomTom 5 on my O2 XDA IIi, suddenly my XDA stopped recognizing the external Memory Card. I tried with different memory card still it doesnt recognize. What could be the proble is it something to do with plugins? have i lost any plugins. Earlier i used to have Storage Card folder in my device but its no more exists. Please help me sorting this out. Do i need to format my external Memory Card.
Cheers,
Suresh
I had the same problem with storage cards and alpine. I noted that Kingston cards are easier to be recognized by alpine and Dane-elec are the hardest. Just try to remove and reinsert the card several times. It's anoying but works. after each reinsertios you can wait some time since the device lasts some time to recognize card.
no use
I have tried it so many times. so far trying to insert different memory cards. still it doesnt recognize any.
Have you tried soft resetting the device?
I had that problem and after soft resetting the card can be recognized again.
I use Transcend 2GB SD.
No use mate.
Thanks for your comments. But no use mate. i have tried it 100 times. still it doesnt, it seems like there is some problem with my Set. Memory card is working fine. I dont know if anything stuck in the memory card slot and its stopping from proper connection. Or i lost the drivers. How to upgrade the software on my xda IIi. or reinstall the drivers. Please help me in fixing this problem. Its all happened when i tried to install Tomtom on the system. damn softwares.
Cheers.
Suresh
Does this SD card work in a card reader. I have found that some of the cheaper SD cards dont last very long especialy if removing and replacing them alot.
Been using transcend 80x slc cards for a whiel and had no problem with them.
I use tomtom, also constantly writing video and mp3s to the cards so far they have outlasted any other make I have had.
Yes.
Yes. i am using this in my camera. I can read and write to the card using other devices. The card which i received from O2 is also not being recognizing.
Cheers,
Suresh
Hi,
just clean the SD card slot thoroughly,it might help.
hi there
i had a sandisk sd card 512mb for a while, then i had broken the touchscreen. anyways. its fixed, but it had to be disassembled many times. anyways after those the card didn't work on device nor on my computer. so i thought it must have been the sd card. So:
i've bought trascend 150x 2gb sd card, formatted with fat(fat16) and when i am trying to put it into my pda it doesn't easily fit. i have to push it little harder.
after that windows prompts me whether i want to format it now. i've tried numerous times either formatted or not, my pda just does not recognize the sdcard. its not shown under explorer nor under settings.
what could be wrong? the sdcard works perfectly when i hook it up to my computer...
hmm very wierd. i tried again and again, it read the card and said that its 1.12gb after couple of seconds, i lost all again..
(
i had a simular problem a while ago.i did a hard reset and upgraded my phone at the same time.this did cure my xda.as to if it will yours im unsure
hi
hello i did buuy a mmc card for my xda IIi but it didnt fit i dont what to buy?..what can you advice to buy? that it really fits i think theres something inside the slot that blocking the card to slip inside..
plz help me..so that i can put some more movies in my xda..
open up your own thread will u!
Hi All,
I have used Imate PDA2 for around 2 years never got any issue, recently (2 month ago) I found the issue that i can't write anything to SD Memory Card, Reading from the SD memory Card in Alpine is fine, the Card itself is fine (tested in PC).
Looks like to be an issue with it's pin's not getting connected while card is inserted in unlock state.
Does anyone know which pins on board can be solded togather to permanenlty make the Card Reader into write mode ? or any other hints ?
Regards,
Tipu
Hi Guys, I had a problem with my phone so i did a hard reset and lost all of the stuff i bought the phone with i got 99% of it back with the help of the threads here. Thanks Guys! but my memory card slot on the phone will not read the card through the pc or the phones software. please help!
Have you verified that the SD card is working? Try it somewhere else?
Yes i put my card into my brother in laws sidekick and he could play all of my files and i put his 2 gb micro sd (not hc) and my tilt read his card fine so i think one of my settings files is screwed im kind of a noob to winmo but im alright at windows
I would suggest that first you put the sd card into a PC, and check the file system on it for errors and repair them if any are found. That will often take care of the problem.
Otherwise, like my tilt, it could be a hardware problems. I can no longer read SD cards at all, even though the phone knows when I insert and remove a card, it won't recognize it as storage.
Hi i hope somoene could please help me here:
Normaly I can view all things that are on the micro SD card in the FILE Explorer on the phone or on the pc, like Notes, Music, Folders....
Today i got a big problem:
I couldnt view any Things on the micor SD card anymore. Just two emty folders are left . I tried it on the Phone and also on the PC. The surprising thing is that, the storage card shows that it is over the half full, like it was always with the things on it?
I have attached some screenshots for a better understanding of the problem:
Can someone please help me?
THanks Elzard
Looks like the card got corrupted -- this has happened a few times with my SD card, so I back it up once in a while.
You might put it into a card reader in a PC and run file check on it.