discharge 100%? - Tilt, TyTN II, MDA Vario III General

is it safe to discharge the battery to 0% so that it will shutdown automatically? (at 0%)

yes its safe. won't hurt your phone. but, its not good for a lithium ion battery. What kills a battery is a build up of sulfites. When you run a battery all the way down it builds up sulfites and shortens the life of the battery.
you should always strive to maintain a full charge on the battery as this will give you the longest life from it.

It should be OK. But what I heard is you should not discharge the batterry too much (it turns off automatically, you turn it on and wait to turn off again and so on...) as Li-polymer batteries are "girlie" in such behavior and would loose capacity sooner than normally.
But it's just "one old lady said once..."

Related

Battery charge Control

Is there a software that control how your battery will be charged?
I know there is a tweak that allow your device to connect to your phone and sync without charging it.
However, I'm looking for a program that will let my battery drain till like 2% before it start charging. The reason I want this to happen is because it'll improve the performance of my battery. It's always good to drain out the battery before fully charge it again.
I don't know about any app that will do that for you, but no charging while syncing can be done in the settings:
settings/system/energy -> Don't charge while conected to PC
Interresting?
You said you want to discharge your battery to almost 2%
Mayby interesting to read the story about Li-ion batteries.
http://www.batteryuniversity.com/index.htm
They say that's it isn't always good to discharge the Li-Ion battery totally.
besides:
Low Maintenance - no periodic discharge is needed; there is no memory.
Good Luck,
Greeting
FritZ
Fred1987 said:
You said you want to discharge your battery to almost 2%
Mayby interesting to read the story about Li-ion batteries.
http://www.batteryuniversity.com/index.htm
They say that's it isn't always good to discharge the Li-Ion battery totally.
besides:
Low Maintenance - no periodic discharge is needed; there is no memory.
Good Luck,
Greeting
FritZ
Click to expand...
Click to collapse
That's interesting
Thanks
this is totally wrong
you drain the ni/cd batteries for better performance not the cellularphones.
you drain the cellularphones battery ,potentially kill some battery cells.
drain it to 2% more than 15 times kills half of it capacity and/or age.

CurrentWidget to ensure fully charged battery

So most people should have heard about currentwidget by now, most people talk about it and use it to see what battery drain occurs during standby mode or airplane mode.
Now I'm sure most know this but incase you didn't, currentwidget helps to ensure your battery is fully charged as well. This is good for people that complain about their battery dropping quickly after a full charge.
You can use currentwidget to monitor your charge, when the battery says its 100% and led is green, currentwidget still shows power going to the battery in form of "ma". I noticed my battery said it was charged and eventho at 100%, currentwidget still showed "ma" is being delivered to the battery . After two hours only it showed 0ma, now I'm sure that means that eventho my phone said its charged, it wasn't fully charged until 0ma were displayed in currentwidget. Since I noticed that, I've been charging my battery "fully" and did notice my battery stayed much longer in the 90-100% aisle when being unplugged.
So if you feel ur battery drops too quickly from a full charge, use this widget to help monitor your charge.
yep, tnx for the tip, im useing clarus battery and its do the same - and i like the widigt so...
the current widget always shows some value of mA . how do we know when the battery is really full ?
Well with me after 1hour at 100%, it shows 0ma. That's when I know the battery is completely full and reached its maximum capacity.
I don't think waiting for the battery to get to the 0mA level is good for the battery performance. Usually the green LED comes on when the widget shows 50mA.
A high-charge concentration for a long time in a Li-Ion battery is bad for the battery. Thats why mobile phones have a little buffer to stop the entire capacity to be full, and try to lose the first part of the full charge as fast as possible.
Since i use some RC Helicopter with li-po/li-ion that both have the same way to produce energy, I have learned how to use this kind of battery and how to ensure a good battery life/durability.
There is no reason to worry about the battery if you follow those few recommendation (given by a battery producer):
-Your battery has to be charged with a current of 1C max (1C mean 1230mA for a 1230mAh capacity).
-Your battery voltage must not be over 4250mV. If you go over, you may damage the battery and risk random explosion/fire. In normal use, it's better to not go over 4200mV.
If you charge the battery with your phone, you will never be able to go over 4200mV because the charge stop automatically before.
-Your battery must not be under 3300mV. Same risk as above. In normal use, it is better to not go under 3450-3500mV to ensure a good battery durability (numbers of cycle charge/decharge). I think the phone show 0% at near of 3450mV, but never check this cause i never wait my phone to be as close to the death.
-Your battery has to be drain at a current of 10C max, i.e for desire HD , 12.30A (1230mAh x 10).
impossible to reach that current with your smartphone so no worries about burning your cpu with heavy bench.
Whatever you do respecting this will not be harmful for your battery.

Battery Query

im just wondering if i should drain the battery of my nexus before i recharge the battery or is it enough to recharge if it prompts (like 15% battery life and below).
when is the best time to recharge to extend the battery life?
Just plug it in as and when really.
In terms of battery shelf life, I doubt it matters as long as you don't do a bunch of short charges that waste charge cycles. In terms of how much battery life you'll see from your phone, let it drain until it shuts off once every few weeks to keep the cells aware of their proper shutoff point.
its just that days ago my battery percentage still goes to 0 percent before it shuts off.. now after it prompts to recharge battery, about 15%, few minutes after it already shuts down.. maybe because i always drain the battery before i charge..
my app in my signature fixes the nexus battery if it dies early. need to be rooted though.
the "age" register in your battery needs to be adjusted to the proper value for your specific battery, which is done by a learn cycle. read the thread for details.

Consistently Incorrect Battery Percentage

Hey all,
I have had terrible misfortune in the realm of battery stats. Ever since CM7 (and maybe even before) my phone is unable to figure out how much battery is left. Here is a common scenario:
Charge phone overnight, use phone throughout day, battery dies after 6-7 hours of moderate-heavy usage. I plug it in, reboot, and then it reports ~60% battery left.
Another common scenario is that it will dwindle around 5% battery or less and go up and down until it finally dies.
I know that this is a misreading of the battery and not battery drain or a rogue app because when I flash a new ROM the battery life is amazing for 1 day. The day after I flashed Team Hacksung's ICS rom, I got almost 17 hours of battery life with 2.75 hours of the display being on and 30 minutes of Google Music. I was blown away! But even then it was dwindling around 5% not knowing when it would actually run out. The day after, it was back to its old tricks of misreporting the battery percentage.
Today I charged it to 100%, unplugged it, and shut it off. Then I plugged it in while it was off and let it charge to 100% again and wiped battery stats in Clockwork mod. I'm getting ok-ish battery with that, but it's not even close to how good it was when I first flashed ICS.
Anyone have any ideas what I could try?
Thanks!
When you wiped the battery stats did you let the battery fully discharge and shut off before charging again?
After wiping battery stats it is recommended to let the phone fully discharge to the point where it will automatically shut off.
Keep in mind with the age of our phones, it could just mean your battery is dying. Try the above method, but in my experience uncalibrated battery only last a few days. The phone will "fix" it by itself the longer you use it.
j.curtis.369 said:
When you wiped the battery stats did you let the battery fully discharge and shut off before charging again?
After wiping battery stats it is recommended to let the phone fully discharge to the point where it will automatically shut off.
Click to expand...
Click to collapse
That's what I'm doing currently. Battery life seems improved, but we'll see what happens. It's nearing death now, ~6%. At this point it will probably misreport it for a few hours until it finally dies. I left it unplugged overnight, so now it's at 19.5 hours uptime with 1.75 hours display time.
Definitely improving! I hope that it successfully recalibrates.
Battery stats have nothing to do with how the os calculates remaining battery...they are what is displayed in settings>about phone> battery use and are reset each time you charge to full.
You're just giving it a good bump charge...wiping the stats is just a placebo effect.
studacris said:
Battery stats have nothing to do with how the os calculates remaining battery...they are what is displayed in settings>about phone> battery use and are reset each time you charge to full.
You're just giving it a good bump charge...wiping the stats is just a placebo effect.
Click to expand...
Click to collapse
Seriously? Wow I didn't know that. Is there a way to actually reset how the OS calculates the battery?
Does this app do anything?
https://market.android.com/details?...xLDEsImNvbS5uZW1hLmJhdHRlcnljYWxpYnJhdGlvbiJd
Nope...that app is just perpetuating the myth of what the batterystats.bin file does.
Don't hate me for this but, Then how come Roms usually give me better battery life after a full cycle? not bump charging or deleting battery.bin just running it?
Because the system for tracking the remaining power is getting to know your battery. once it gets a feel for it, it's more accurate. In theory anyway
So the "give it a day" is still true, at least in theory?
Sure
10 char
battery gauge temporarily fixed by removal and replacement of battery
Ever since I rooted my phone, I've noticed that the battery gauge/meter is way off. I keep an eye on the charging voltage and try to pull the plug around 3.92 volts. Problem is, the gauge is always reading low until I pull the battery, wait a few minutes, and then reinsert and boot up. Then it's fine for a while, but I notice it creeping down even though I keep topping it off with a charge to keep it around 3.92 volts.
What's going on? Do I have to fully deplete the battery and charge to full to have an accurate (or somewhat accurate) battery gauge? Do I have a bad battery (this battery has been used only a couple months)? Is something else going on here? Recommendations, studacris? Doesn't the os use battery voltage to calculate state of charge (%)?

First charge - forming the battery

Haven't had a new phone in a while now and I can't find it anywhere wether I should format the battery on the first few charges and if so, what is the procedure?
You don't have to do it. You just remember to not to completely discharge your battery and you will be fine.
Lithium-ion battery or Lithium polymer battery doesent have to be formated, or formed !
Only Nickel–metal hydride battery (NiMH) have to be formed.
L-Ion on the other hand doesen't like to be drained to 0%, if you want to prolong the battery life, you shouldn't let the battery to get under 30% if you can manage to do that in real life.

Categories

Resources