Help with Multi Coloured Screen After Upgrade - Tilt, TyTN II, MDA Vario III Themes and Apps

I need some help,
I've installed HardSPL v3.56 and installed KaiserDiamond_V9 the install got to 16% and then reported error 262, I run the recovery no luck same error reported, I'm now stuck with mufti coloured bars when I switch on. Any ideas

Hello
the phone is stucked in "SPL"mode. try to flash with an original ROM

scudo94, I tried that a couple of times, still the same.
I removed the battery etc before each attempt.

Check THIS thread on how to recover from a bad flash...

Thanks for the info, I'll give it go later and let you know how I get on

Related

WM5-Device Will Not Load Operating System

I am having a problem that I hope someone can help me with.
I have an SX-66 with WM5 on it. The other day the device suddenly stopped booting. I can get the device to turn on, soft-reset, hard reset and get into bootloader mode, but whenever I try to boot the operating system it gets stuck on the colored stripe boot screen and just sits there showing the version numbers and nothing else. I have followed the instructions on the Wiki for downgrading but I still have the same problem. I have tried draining the battery fully and recharging but still no dice. I am even able to reflash the device with my laptop and it says it succeeds with the up/downgrade but then it just gets stuck again. If I try to install a 1.40 the device says that the flash is successful but then WM5 tries to boot again and I am stuck at the striped screen.
Can someone please help me out? Do I have a brick?

help

hi all ,
I tried to upgrade the device with new rom, and I make something wrong.
After Reset device stuck with the white screen and HTC logo in green, I tried to make HR a few times and it did not help, any creative solution?
ofer izhaki
what rom did you tried to install?
should be OK, if you can still get to the boot loader screen, you should be fine.
just try flashing a new ROM, or better, a stock ROM
Please post flashing issues in this thread
Thread closed

help needed please with possible brick fixed:D

hello all
yesterday i wanted to flash a friend tp2
when i flashed it it went to 100% and then it gave a rom code error
i restarted the phone in bootloader to flash a other rom and it wanted to read the image on the sdcard
wich resulted in red serie of digits on top of the screen 00058002
and the phone turned off
i deleted the image from the sdcard and tried it again
i came in bootloader and i saw threu the spl text rom upgrade error
now everytime i enter bootloader it turns off the phone in 5 sec
i managed to run a task 29 one time by resetting the phone multiple times
can some one help me
owww its not fixed
i managed to get stock rom on it again but during the custimizsation the phone turned off:S
and now i have the same problem again
edit: i dont know how but its fixed

Code Corrupt, HELP

hi guys, i got a milestone from my uncle and it was on the HO NO rom then i tried to come back to the stock rom, with RSD on Windows 7 and now my phone doesn't turn on and give me always the same message code corrupt on boot mode, and i can't turn it on or access to the recovery. with RSD i got the same error always: failed to flash...
GUYS HELP ME I REALLY NEED HELP
thanks in advance
UPDATE i managed to replace the boot menu but RSD give always the same error when i try to flash a rom: failed to flash... Guys help me
UPDATE: now i managed to flash a rom, to the end it says complete. i turn the phone on and... Motorola logo and then boot menu, i tried with many roms from many countries, i don't know what to do. help me

[Q] failed flashing CM11 -> result boot loop

Hi,
I tried to flash CM11 in my Phone with Odin but it gave a fail as result. So I tried it again with an other firmware but it wasn't possible.
Everytime I connect my Phone to my computer or to the charger is goes into a bootloop. It gives me a screen that says "firmware upgrade encountered an issue" for 2 seconds and it shutsdown, it restarts and give's me the screen with error back.
I think the problem is the CM11 I tried to flash is for an I8190 and I have an I8200 (I found that out to late
I have search google and this forum for 2 days but I didn't find a working solution.
I tried to get into recovery of dowload mode but that's impossible due to the boot loop.
Kies can't connect to my Phone. I checked my powerbutton and it's not stuck.
I removed the battery a couple of times for more than 2 hours, ...
Does someone know what I can do so get my Phone working again?

Categories

Resources