Hi. No matter where the volume setting is for the speaker or in call settings it is always at the loudest setting; the "vibrate" and "off" settings still work properly. Please Help!
Thanks.
I'll switch phones with you ... every time I go for a call, I find myself turning the volume ALL the way up.
Related
I tried to set the volume on the title bar of the today menu to something other than the lowest volume (nothing). I close it, then reopen it, the indicator resets it to the lowest volume.
Has anyone seen this before? I've tried searching but found mostly bluetooth volume isssues.
Yep, BT will do it if you have the volume off when your turn BT on. Also, if you have HTC Home make sure that in the profiles tab it's not set to silent or vibrate.
It turns out to be some weird feature. If I tap on the speaker image part, it will make the phone silent. If I tap on the sound part, the 3 lines to the right of the speaker image part, it will turn on sound. I didn't even know I had that feature.
I'm having this exact problem with my Mogul. I tried tapping on the "sound lines" like you said to fix it but that doesn't do anything. I'm stuck.
I have tried to find a thread on this issue, but to no avail.
I use HTC Home with the new ATT 6.1ROM.
With Bluetooth activated I will often use HTC Home to change ringer settings. When I have the phone on Ring & Bluetooth and all volume up everything works fine.
After I switch to Vibrate or Off then back to Ring I find that the Phone Volume is not off. It shows as Ring enabled but the volume is turned off.
Is this due to Bluetooth? Is there any way to stop this from occuring as I dont always have my bluetooth in and the phone wont ring even though i put the Ring option on because the volume is turned off and I keep missing calls.
My work around so far has been that instead of just hitting the HTC Home Ring button, I have to do that and check the volume control. I would like to cut out that last step.
Thanks
Hi,
I have been having this problem for the last couple of days, for some reason the volume of my ringer has dramatically decreased to the point where i can't hear the phone ring when it's in my pocket (wasn't the case before). When i try to play the ring tone (it's a wave file by the way) using the media player the volume is normal and very loud, the same applies to when i play it from the settings->sounds¬ifications the volume on the ring tone is perfect, but when i receive a phone call the ringer volume is cut down by more than half, i checked the ringer volume and it's set to the max, I also did a hard reset then restored my files using the sprint backup but the problem didn't get fixed, I tried using a different ring tones and the same happens. any help would be greatly appreciated.
There are three volume controls: System, Ring and In call Volume.
Have you checked the System Volume?
If you press up on the hard volume key, you'll see arrow on the top right to switch to the next vol control. Check there.
HTH
ringtone problem
yea all 3 volumes are set to the max level
ringtone volume problem
the phone has the original stock rom from rogers (canada) hope this helps in any way
Have you got any profile managers installed (G-profile, Phoneweaver etc)?
ringtone volume problem
no i dont have a profile managers installed... so i just noticed that when the phone start ringing and i dont pick up, a second before the phone stops ringing the volume of the ringtone increases to the normal level (then stops ringing), the increase of the ringtone volume happens for like a split second after the caller hangs up and the phone stops ringing. hope this helps in any way. Thank you
Sounds like you have a Ringtone delay problem, there are a couple of solutions.
1. Disable HTC dialer (and use the Winmo one instead), can be done using Advanced Configurator 3.3.
2. Try the CAB I've attached, remember to only use WAV as ringtone though.
I would also recommend adjusting Call Forwarding timing to 30seconds. Settings/Phone/Services/Call Forwarding and get settings.
Disabling the HTC dialer is probably going to be the best solution as the HTC dialer is a hungry resource eating monster but I would just try the CAB and adjusting Call Forwarding time. There are some other REG setting as well but I never found them useful.
i have a sound problem with my X1
i have the original rom
it have sound when i play music from the speaker.
it have sound when i try my ringtone but when someone calls me i get only vibrations!!!
plz help!!!
what is the setting in notifications section of the phone, it could be set to viberate only.
go to settings, phone, notifications and check the settings tro see if it is on vierate only.
if you carry the phone in pocket or purse without a case, the volume could be lowered every time by something in your pocket or purse. If the volume is lowered to the lowest setting, it will automatically switch to vibrate mode.
So, I have an S10, and evert time I make or receive a call, the volume is full blast! I turn it down, and it just don't remember the volume level. So there most be a setting for it somewhere, but ic an't find it. Where is the setting to change "default call volume"
Now, I do use a different Dialer "Drupe" however, there is no setting in there either.
lil help?
I'm using Tasker app to automate volume levels.