stuck at white screen - MDA III, XDA III, PDA2k, 9090 Software Upgrading

my ba is stuck at white screen. i cannot hard rest because its all was at white screen but my phone do ring but i cannot see any thing plx help
thanx in advance

same problem, please help me !
first i tried to update to windows mobile 6, but it didnt even start then it stucked at boot loader screen, serial/usb V 2.07
then i solved it with mtty but not completely, it stucks now in white screen, and do a ring like 'be-eer' . i re flash with orginal 2003 pda2k firmware, but after a successful flash, it's still stucking at white screen !

wot do u think could it be a hardware prob

i can't really help you about that issue, the only thing i can do is point out a little something for you to look up:
http://forum.xda-developers.com/showthread.php?p=3816258
or:
this is regarding the universal but maybe it contains helpful ideas, what to check
http://forum.xda-developers.com/showthread.php?t=259003&page=3
and just a little bit of my own ideas:
- are you absolutely 100% certain, you are using the gsm model, the blueangel, and not the cdma harrier?
- what rom were you trying to flash, was it a custom made one and did exceed the size limit?
i think these are the most common reasons for being stuck in bootloader besides just bad luck. i feel with you guys, i would be completely helpless in that situation.

Related

Desperate help needed, I still cant bear to part diamond for Omnia

Hi All,
Sorry to ask for help like this, as I had tried reading through, but I really got more and more confused.
I got only next 2 days to give my diamond a last try.
Till now I still can't truely understand what is Hard SPL, I tot all Diamond should have.
If I wanted to try the following combination (like what Bro Radeon has), how to do it in the right sequence and step by step, I tried and stopped at 0% and error 262,
SPL - OliNex 1.40 Developer Edition
ROM - SwiftBL WWE Diamond ROM v4.0 (1.93.405.1)
Radio - 1.00.25.05
After flashing, if things goes through, how I revert back to original factory default, so that warranty and resale is not a problem.
Infor about my device is as follows,
Red Screen:
DIAM100 64M
SPL-1.35.0000
MicroP-Diam (LED) v11
Green Screen:
PSOC-Diam STAGE_PVT v0.x30
Blue Screen:
White Screen:
Serial
Device Information
ROM version: 1.35.871.5 WWE
ROM date: 06/06/08
Radio Version: 0.93.25.NS26
Protocol version: 52.26.25.09W
Desperately looking for help, sorry for being so novice about flashing, kindly of phobia, perhaps is generation gap I supposed.
Ke Pin.
SMS turns blank
Hi All,
I had to do a Hard Reset after my sms hanged up on me.
The screen turns blank whenever I need to compose new msg or reply.
When it is in blank screen, when I click on Menu, it says, can't encrypt or something.
Has anyone encouter such a problem.
Diamond has many nice things like, the best screen which I have seen so far and the best design, but battery and the hang ups are just too inhibiting to enjoy this unit.
I reluctantly contacted ppl who wish to trade their Omnia with my diamond, really can't bear to part ... Help help
check this modmydiamond.com. It has some guides as what to do and how to do it. It also links you back to the correct threads in this site.
Goodluck
its modmydiamond.info ....
kepin said:
Hi All,
I had to do a Hard Reset after my sms hanged up on me.
The screen turns blank whenever I need to compose new msg or reply.
When it is in blank screen, when I click on Menu, it says, can't encrypt or something.
Has anyone encouter such a problem.
Diamond has many nice things like, the best screen which I have seen so far and the best design, but battery and the hang ups are just too inhibiting to enjoy this unit.
I reluctantly contacted ppl who wish to trade their Omnia with my diamond, really can't bear to part ... Help help
Click to expand...
Click to collapse
those are pretty serious issues.. your diamond shouldn't be going blank.. have you tried returning it for a new set? and yeah, you should be able to follow the guides on my site if you want instructions.

HTC p3600 trinity boot problem

i started having this problem a month ago. after boot the PPC writes something in red and after a few seconds gets black
i recorded it so it would be clearer
http://il.youtube.com/watch?v=NAHqAZS2nZ4
i tried installing a few roms and even the original one from htc website
i would appreciate any help you can give me
Very strange. What SPL version doyou have? Have you used cooked roms? Anything else happend to the phone?
HTC trinity original ROM
Here is the original HTC Trinity ROM:
http://rapidshare.com/files/202845245/Trinity_HTC_WWE_1.15.405.5_6275_1.20.00.11_12201_Ship.zip
1. Press on/off button + camera button + reset (using the stylus)
2. You should now be in tricolor screen.
3. Connect the usb cable.
4. Make sure you have activesync runing.
5. Install the rom provided in the link.
In the link you will find rom+radio. (Radio version 1.20)
Here is a newer radio version 1.56:
Hey! My trinity have the same problem!!!
I habe all test: Without sim, without SD, with SD, with SIM (with SIM screen is grey)
What have you done?
Original ROM - same problem
Mine was doing this earlier
seemed that their was dirt stuck in the reset button hole causing it to stick in slightly
I got this problem too. My trinity would turn on and start to fade away. But mine was a liltle more artistic. Many times i saw a kinda round spot in the middle of the screen that become black, then half of the screen would black out and then the rest of the screen. Sometimes i even got colors.
I noticed if a had a fully charged battery the phone would work perfectly.
But most of the time it turn on, but the screen stayed black with the retro light on.
I was told to try the unbrick exploit.
me too !!! i have the same problem with my htc 3600 ? can someone help us to fix our htc's 3600 ?thanks in advance....
have you fix it ?
hi all
I have a small problem with my htc p3600. It's not starting. It's loading only the bios but it's freezing with the screen picture and is not loading the WM 5.0 I try to change the WM5.0 with a new one but I don't have a active sync. connection.Please help
has anyone found a solution to this problem ?
anyone have a solution?
Finally, what you should do?
Since the Trinity / P3600 is getting old now, I believe more and more people are going to face this strange problem sooner or later.
So I thought I should save your time and tell you what you should do when your trinity starts behaving like what was described at the beginning of this thread.
YOU SHOULD DO NOTHING !!
THERE IS NO QUICK FIX
THERE IS NO WORKAROUND
THERE IS NO CHEAP SOLUTION
I have searched and tried everything mentioned in this forum that might slightly be related to the problem and all solutions failed.
So after days and days of experimenting, I gave up and sent my device to HTC dealer who called me few days later to tell me that the mother board needs to be replaced.
The dealer told me the cost will be around $213, but they said they are going to sent it back as it is, because they don't have that board model anymore!!.
Even if they had, for an old device like this , I don't think it worth that mush money to fix.
**************************************************************************
*SO BASICALLY , DON'T WASTE YOUR TIME TRYING TO FIX IT AND BUY YOURSELF A NEW ONE. *
**************************************************************************
.
.
.
.
Hello,
I resolve the problem with this : Simultnous press Power and Camera buttons and softreset, you'll got bootloader, three colors mode. Perhaps a little error message like this WLAN error but if you plug usb, it's ok.
Hope this good for you (excuse my poor english)
I've had this same problem for about a year now and keep coming back to it.
Any forward momentum on solving the problem would be appreciated as I quite like this phone.
1. The phone will boot FINE without a SIM
2. It hangs like in the video (or other strange screens) as soon as I insert a SIM card (partially or fully)
3. I've tried 3 different SIM cards
4. I have no SD cards
5. I have installed 3.20.Olipro
6. An official ROM is re-installed
I must admit the phone has had a hard life (or is it just the cheap plastic coatings HTC use)
No sooner did I post this did I find a solution.
For anyone that is interested...I have managed to re-install the original HTC ROM but HAVE NOT managed to install a workable 6.5 ROM yet.
So, the answer I found was:
1. Put P3600i into bootloader mode (push camera+power+reset buttons for 2 secs and get triple colour screen)
2. Re-flash HardSPL 1.1 from my PC
3. Re-flash original HTC ROM (WWE_3.00.707.18_6275_1.46.30.11_108) by agian putting P3600i into bootloader mode first
I since tried several different radio stacks but haven't noticed any difference in reception so have left the original stack on (1.46.30.11) as it gives the best phone call quality
I love the UI of the latest WM6.5 but if the P3600i doesn't run them properly I'll just have to do without.
Good luck with your own unbricking.
it was working fine for me when i put a little piece of rubber between the processor and the metallic cover of it but after 3 months i have the same problem and the paper dont work anymore.... now when i press the power button the screen is black, only the backlight is working anyone have any ideas what to do?
OMG WTF, as soon as I saw this thread I switched my HTC P3600 on and it started doing it I reckon this is cursed, I will upload a video onto Youtube later and show you that is what happened.
I had this problem myself, didnt know what i was doing wrong, altho my tri color screen did this, not the boot one.
I removed memorycard and voila, everything went smoothly.
edited
sorry 4 my mistake

Please Help !

I got myself a big problem.Xperia is continuously restarting.It can`t be stoped.I tried factory reset but it keeps restarting.The restart happens right after the sony logo.I may got a virus or i don`t know.
If you got any ideeas please post !
Bless !
99.999999999% of wm users never had and never will get a virus on their phone
virus's have to be made specially for wm for them to work
there are 5 all more proof of concept
could be a bad rom in which case updating it could help
it could be a periodic defect piece of hardware in the x1 in which case service is required
Probably just a bad rom, did you flash it?
It dies after sony logo...Bios menu only appears for 2 second i can`t even plug the usb.
It may be something hardware (((
Thank you guys for the time.
It seems i can`t find any service to look at my xperia.I think it only needs a reinstallation of the software,but they don`t want to try.
try reflashing a new ROM via the SD card method. can you get to the tricolor screen or it still restarts?
The tri-color screen only appears for 2 seconds max.meaning I press the down volumea button and the power on and the tri-color screen appears only for 2 seconds,i can barely see the screen.
(
If you can't stay on the tricolour screen, its obviously a hardware issue. Warranty?
Yes,but for the warranty i have to go to Italy.I thought it`s only a software problem that i could fix,but it`s not isn`t it ?
Thanks for advices guys.

need help with G1

Ok I'll make it short My T-Mobile G1 boot normally I get the logos screen G1 & T-mobile then... nothing; the screen either stay on back light or if I remove the battery & restart the phone shows the logos & all & then a white screen with some random colored red all over the screen.
Please guys I need your help in this matter & thunk you in advance.
you need to tell us what you did to get to that point... did you just flash some firmware? battery ran out while running.... any number of things could be the issue, a little history on the phone would be helpfull indeed
In fact, we CAN'T help you without those details. Anything we "guessed" might be the problem, and provided you a solution for, could make the problem worse, possibly even brick your phone, if we don't know the details of how you got where you are.
When you hold home while booting, what happens.
And yes, please give more info.

[Q] G5 Nexus one clone

I have a G5 Nexus one clone with Dual sim, 1Ghz CPU,Windows mobile 6.5, GPS, 480*800 resolution 512Mb RAM & 512MB ROM.
I had edited the registry using Tweaks registry tricks for Windows Mobille & when it restarted it starts up with a screen that says 'SMART' and then goes to a black screen forever. When i try to hard reset using nexus one procedure, it comes to a screen with a green arrow pointing to the back of the same phone in the image on screen & at the bottom you have 'Downloading...' The phone does not respond after this, it just restarts after a while & ends up on a black screen as i mentioned above as if it were booting.
I need help with restoring the phone as quickly as possible with lesser effort or some technique to get back working and if possible with some new benefits. I'm sure im asking for too much but most importantly, i just want to get the phone working normally.
This phone says 'Made in Taiwan' at the back under battery, although i dont beleive it & i purchased it on ebay
I will be deighted and greatfull if anyone can help. If you need any other info, please let me know
g5 nexus 1 dual sim does not boot after startup logo "smart"
same problem here too. Is there any solution for this? Please help. I install sk tools . After that this problem started.
KKrraajjaa said:
same problem here too. Is there any solution for this? Please help. I install sk tools . After that this problem started.
Click to expand...
Click to collapse
Having the same problem. Need firmware. who has?

Categories

Resources