On my tilt i have a slight problem. When i place or recieve a phone call, i cant hear them regularly. I must put my phone on speakerphone to hear them. I dont have a back for my phone, but i dont think thats the problem. Any suggestions?
try this; once in a call turn the dial on the left hand side of the handset all the way up to make sure the volume of the speaker is at full. similarly if you touch the speaker icon on the top toolbar, two volume sliders appear. make sure these are both at 100%
I am having these same issues too. I have tried what u suggested and still not working. The phone was working fine but no longer. did a hard reset and still not working. If it means anything, I recently replaced the housing to the phone, but even then after replacing the housing, the internal speaker still worked and I could hear through it but now I have to take calls through the speakerphone. Anyone have any suggestions?
Related
Hi there
I've been having a few problems with TomTom and BTCoreIf.dll.
Since the last install - I had to re-do it because the Alpine reset itself following backup battery failure.
Anyway, since I did that, there is no sound from the earpiece, I can't hear a ringing tone or anything.
The actual phone's sound is OK, the applications are all making the sounds they should, including TomTom.
When I use the Bluespoon headset I have, I can hear a ringing tone through it.
I'm wondering if I have a file missing on it. Plus holding down the green phone key when I try and make a call doesn't bring up the speakerphone utlilty like it used to.
Any and all comments appreciated.
Anyone else had anything like this:
When the phone first boots up its perfectly fine, calls work both ways, it plays music no problem.
However leave it sitting on the side for 15-20 mins and then get a call, the phone receives it but makes no noise, answer call an the phone doesnt even sound like its picked it up it's just silent, can' hear person, they can't hear you. Same on outbound calls the phone is just dead i cant hear anything an receiver cant hear me. But the phone does no the call is connected as it rumbles when the person answers but i never hear the ringing before that.
Also once it is in this state, got to music on the phone and click play and there is no sound at all!
This has happened even after updating to newer official rom as well.
Any ideas???
Many Thanks
I am having exactly the same problem.... All sound from the phone just stops working, also the alarm, which means I can never trust my phone to wake me up in the mornings!
Another problem with the phone is that when the phone is called it takes a while for the phone to ring. I have tried to call my phone from a landline and it actually rings three times before the diamond makes a noise!
The latest Tweak 2k2 software solves the 3s ring delay problem...
Do you have a link for this?
Thanks
http://www.tweaks2k2.com/
Some users here were also tweaking the registry, but i solved the problem this kind of way...
Would anyone here know why all of a sudden the ringer and music speaker would quite working on my X1A? The headphones work fine as does the speaker when you are making a call. The phone was not dropped, I was sitting at the computer, noticed I missed a call and wondered why since I'd not heard a ring. Did hard reset, still nothing.
sounds like the headset detector is stuck so it think it's in headset mode all the time
people report inserting and pulling out the headset XX times sometimes solves it
Thanx for your reply, makes sense but just inserted and removed headfons at least 20 times and still no go. Any other ideas?
just press volume up button of the phone
that's not the issue, I have the volume turned up all the way, still nothing.
My samsung captivate is having sound issues.
When i am talking on a speaker phone, after 2-3 min. i cant hear any voice on the speaker, i have to turn off the speaker and talk. And some times when someone calls, the phone doesn't rings. it just show the incomming call( the phone is not in a silent mode). And even when i play any music, it plays for some time and later its just silent.
If the speaker of the phone is bad, i should be bad all the time.
if it is a software problem, i update the software regularly.
can any one please let me know what should i do. i will be very thankful to you
Try firmly pressing down on the speaker housing. It may just be a loose connection.
Hi there,
Not sure if my phone is a dud - has anyone experienced the V40's boombox speaker suddenly not working or else very quiet? I've tried to adjust the volume controls, but it either seems normal, or else it even seems like it's in a call (it says "call volume" when adjusting the volume rocker switches sometimes, even though I'm not in a call). The volume sliders are all full. The only cure is a reboot. But you can still hear screen taps and things too. It's sort of like a media playback issue, and it happens in other apps as well - like Youtube, WhatsApp, etc. It's not going to Bluetooth either...
I have done a factory reset and the problem crept back right away.
Thanks for any help.
Thx
Ken'
kenwchan said:
Hi there,
Not sure if my phone is a dud - has anyone experienced the V40's boombox speaker suddenly not working or else very quiet? I've tried to adjust the volume controls, but it either seems normal, or else it even seems like it's in a call (it says "call volume" when adjusting the volume rocker switches sometimes, even though I'm not in a call). The volume sliders are all full. The only cure is a reboot. But you can still hear screen taps and things too. It's sort of like a media playback issue, and it happens in other apps as well - like Youtube, WhatsApp, etc. It's not going to Bluetooth either...
I have done a factory reset and the problem crept back right away.
Thanks for any help.
Thx
Ken'
Click to expand...
Click to collapse
I am facing a similar issue with "call volume" showing up when headset is connected (even though am not on a call); This specifically happens if my V40 has been previously connected to a Bluetooth device which has a mic, and then has been disconnected from it. I have to restart my V40 everytime this happens as otherwise the audio is really inconsistent (it sounds cracked at lower volume, and tinny at higher volume).
When you say "the problem crept back right away", is it after some particular action (for instance connecting to some BT speaker or something?);
Also, did you try running it in safe mode (hold power button, press the "power off" icon in the screen, it should show an option to re-boot to safe mode), for me, it works on safe mode but the problem comes back even after a factory reset when i am in the normal screen.
BurningFlames said:
I am facing a similar issue with "call volume" showing up when headset is connected (even though am not on a call); This specifically happens if my V40 has been previously connected to a Bluetooth device which has a mic, and then has been disconnected from it. I have to restart my V40 everytime this happens as otherwise the audio is really inconsistent (it sounds cracked at lower volume, and tinny at higher volume).
When you say "the problem crept back right away", is it after some particular action (for instance connecting to some BT speaker or something?);
Also, did you try running it in safe mode (hold power button, press the "power off" icon in the screen, it should show an option to re-boot to safe mode), for me, it works on safe mode but the problem comes back even after a factory reset when i am in the normal screen.
Click to expand...
Click to collapse
Hi there, yeah, I can't exactly pinpoint when the problem crept back after the reset. I had been using Google Maps but I can't imagine how that would affect audio. The next time I used Google Maps, I couldn't here the navigation cues, and then I checked Youtube and "behold!"...the sound had got cut out again. Had to reboot. Would the phone be routing audio to some bluetooth channel or something, like my Samsung Gear S3? Why it would, I don't know. I do remember seeing the "in call" display once when this was happening which clearly is a different bug and not bluetooth related. I did try to connect to a bluetooth device, and then disconnect, and the problem has not resurfaced yet but I feel that I don't have much confidence in it at the moment.
I'll look into Safe mode; thx for the tip.
Ken
I know this has happened to me as well but I know what is causing it on my phone. Whenever taking a video call in Facebook messenger then my phone stays locked in the call volume also. Only way I have found is to restart the phone also. I am not using Bluetooth at all for the call either just the phone speaker so it's not a Bluetooth issue on my end. Having to restart the phone definitely sucks.
rx7boy22 said:
I know this has happened to me as well but I know what is causing it on my phone. Whenever taking a video call in Facebook messenger then my phone stays locked in the call volume also. Only way I have found is to restart the phone also. I am not using Bluetooth at all for the call either just the phone speaker so it's not a Bluetooth issue on my end. Having to restart the phone definitely sucks.
Click to expand...
Click to collapse
Well i found one more case - when doing a FTP through WiFi from PC (to transfer files); once FTP connection is closed (after transferring), and then if the earphones are plugged-in, phone says "call volume". Had to again restart. I was trying to find any app that can just refresh the UI/settings/system without doing a restart every time but haven't been successful. LG definitely need to fix it.
Thx for the replies, I have no clue as to why this problem is happening, but I've traded my phone for a new one in the 10-day purchase period and so far it is working correctly. Fingers crossed.