Qtek stuck in splash screen - PDA2, XDA IIi, 2020i General

My Qtek is stuck in the Qtek splash screen. I am unable to soft or hard reset. If I remove the battery and charger for a few minutes then reinstall them it boots up then I get a message saying installing custom setting and a whole load of programs install and the device resets but does not get passed the Qtek splash screen. If I connect it to my computer using activesync I am able to open the device using explore. Any ideas what the problem could be.

Related

WM5-Device Will Not Load Operating System

I am having a problem that I hope someone can help me with.
I have an SX-66 with WM5 on it. The other day the device suddenly stopped booting. I can get the device to turn on, soft-reset, hard reset and get into bootloader mode, but whenever I try to boot the operating system it gets stuck on the colored stripe boot screen and just sits there showing the version numbers and nothing else. I have followed the instructions on the Wiki for downgrading but I still have the same problem. I have tried draining the battery fully and recharging but still no dice. I am even able to reflash the device with my laptop and it says it succeeds with the up/downgrade but then it just gets stuck again. If I try to install a 1.40 the device says that the flash is successful but then WM5 tries to boot again and I am stuck at the striped screen.
Can someone please help me out? Do I have a brick?

HELP. tried upgrading.. stuck at 98%

hey.. ive upgrade to new roms before.. however i tried going from the cingular 2.25 rom to summiters aku 2.3.. and it froze at 98% and was unable to finsh.. now I jsut tried downgrading and it froze again at 98%.. it won't complete anytthing.. help. please.
It's normal for it to seem to freeze at 98%, but it really will complete if you just wait a few minutes. No worries... just be patient.
If Stuck
hey if your phone is doesn't go through with the rom upgrade and doesn't push through and when you reboot you get stuck on the boot screen.
Put your phone into USB programming mode by holding the camera button down and doing a soft reset with the stylus. Then you will be able to load any rom you choose.
With regards to your frozen at 98 just give it time i would say don't unplug
same problem, still stuck
2nd time trying to load "Cingular_Custom_AKU2.3_Combo_Installer_V1.exe" ROM but still stuck at 98%...on the computer it says 100% and finishes but the phone is still stuck at 98%..tried to do a soft reset, but stuck at bootloader screen..
Help pleaseee!
Thanks!

Flashing ROM and SPL

Hello all,
first let me apologize for the long post, and my noobiness. I'm new to the smartphone world, I've sucessfully flashed my Kaiser (from work). Also, I would like to thank everyone who is cooking!
I have the HTC Mteor, which I'm trying to Flash to WM6.1.
When I got it (used), I did a hard reset, and it went back to WM5 in Russian.
I believe I successfully unlocked it, and can now get to the tri-color screen.
It reads:
BBEE100
IPL-0.90
BREE100
SPL-2.05
Every ROM (including the original from HTC) opens, forces the phone to the tri-color screen, and then dies. Error 260, 262, etc.
I've searched the forums, and read that the SPL should be 1.10, but I can't get that to install either.
Any help/suggestions?
Thanks,
Jeff
jjmorris100 said:
Hello all,
first let me apologize for the long post, and my noobiness. I'm new to the smartphone world, I've sucessfully flashed my Kaiser (from work). Also, I would like to thank everyone who is cooking!
I have the HTC Mteor, which I'm trying to Flash to WM6.1.
When I got it (used), I did a hard reset, and it went back to WM5 in Russian.
I believe I successfully unlocked it, and can now get to the tri-color screen.
It reads:
BBEE100
IPL-0.90
BREE100
SPL-2.05
Every ROM (including the original from HTC) opens, forces the phone to the tri-color screen, and then dies. Error 260, 262, etc.
I've searched the forums, and read that the SPL should be 1.10, but I can't get that to install either.
Any help/suggestions?
Thanks,
Jeff
Click to expand...
Click to collapse
install this official rom from HTC
http://rapidshare.com/files/66085556/RUU_BREE100_1.34.261.1_1.38.00.10_HTCRUS_SHIP.exe
Its for RUS QTEK_AO7.
Then you will have SPL 1.10
I have similar problem
I had ROM 6.1 from Futureshock...still problem with radio (my phone couldn´t accessble but signal icon shows good signal, radio version 1.38.0000), so I decided flash some original ROM. Aftet that my booting stuck on HTC logo or Windows Mobile logo. So I can´t use normal way to flashing. Only from SD card or first turn on phone to boot loader mode and than attach usb cable and start flashing. From SD card (where is renamed ROM BREEIMG.NBH) after enter into bootloader mode start loading and than just turn to trhreecolour menu where is BREE100 - IPL-0.90 and BREE100-1.10.0000 and doesn´t want continue. If I flash ROM via USB cable (first go to threecolour mode, than attach cable) than run ROMUpdateUtility.exe and flash process is being started but always die on 2%, than autoreboot and again stuck on HTC logo.
I tried soft reset, I tried lot of ROM versions HTCRUS, HTCEUR, QTEKEUR, FUTURESHOCK but still same problem during flash ROM stop on 2%...
Any ideas how to back life to my MTeoR?
Can I use application like MTTY? Could me help this program?
Thanks for any help...
hi, can any1 send me a link for a ger version of wm6.0pro ?
Wigo said:
I had ROM 6.1 from Futureshock...still problem with radio (my phone couldn´t accessble but signal icon shows good signal, radio version 1.38.0000), so I decided flash some original ROM. Aftet that my booting stuck on HTC logo or Windows Mobile logo. So I can´t use normal way to flashing. Only from SD card or first turn on phone to boot loader mode and than attach usb cable and start flashing. From SD card (where is renamed ROM BREEIMG.NBH) after enter into bootloader mode start loading and than just turn to trhreecolour menu where is BREE100 - IPL-0.90 and BREE100-1.10.0000 and doesn´t want continue. If I flash ROM via USB cable (first go to threecolour mode, than attach cable) than run ROMUpdateUtility.exe and flash process is being started but always die on 2%, than autoreboot and again stuck on HTC logo.
I tried soft reset, I tried lot of ROM versions HTCRUS, HTCEUR, QTEKEUR, FUTURESHOCK but still same problem during flash ROM stop on 2%...
Any ideas how to back life to my MTeoR?
Can I use application like MTTY? Could me help this program?
Thanks for any help...
Click to expand...
Click to collapse
I'm not sure that I understand well, but if you flash from SD, it finish in 100% and than go to three color boot screen? ....
Hi alebo caf Vašek ;-)
My problem is that always stuck on boot image HTC or Windows Mobile blue screen. I can´t use way copy necesseary files to root of phone memmory and than run sspl etc...I have to turn manualy to three-color mode, than connect USB cable and run upgrade utility but still froze instalation on 2%, If I use SD card methode with BREEIMG file uploading doesn´t start....
p.s.: Ak by si mal dáku radu tak možno lepšie vysvetliť po česky ;-). Moje ICQ 208-393-971
Dík
CZ Rom
I would like to install new ROM into my Mteor, but I have no experience doing it. I do not know which version to try, all I need is to be able to enter czech letters on HW keyboard as with original ROM. Any sugestion? I preffer personal answer in czech language ([email protected])

stuck at white bootloader screen

after several times trying to unsuccessfully install a hard spl. (it installs and on reboot keeps the version 3) i upgraded the radio and now its stuck on the htc loadup sreen with the version listed on the bottom . a hard reset just resets so i cant even run the repair utility
one more thing
Oh and one more thing because it wont boot full or go into hard reset mode the computer will not recognize it.

[Q] HTC sprint diamond will not boot past splash

Hi, I have an htc touch diamond that will not boot past the splash. It turns on, says htc diamond without red letters. I have tried soft reset & hard reset, doesnt work. also phone does not turn on by power button but only the reset button. Every time I try to flash or unlock it says "Error 262", I've tried soft reset and continuing the setup and the error comes up again. I've tried the whole thing of changing the driver from 2007 to 2003 and completed it and still has not fixed error 262. I've tried many different roms and the only ones that bypass 262 are the .exe file rom setups, but after installed still doesnt boot past splash screen. the farthest ive gotten with one .exe is going through the phone setup, but after the setup the phone turns off. the only way my computer notices the phone and the way i flash the phone is when it is in bootloader. have also tried the bootloader where you press the back button. I've been trying so hard to fix this phone but it just wont happen. please help?
ryan21x5 said:
Hi, I have an htc touch diamond that will not boot past the splash. It turns on, says htc diamond without red letters. I have tried soft reset & hard reset, doesnt work. also phone does not turn on by power button but only the reset button. Every time I try to flash or unlock it says "Error 262", I've tried soft reset and continuing the setup and the error comes up again. I've tried the whole thing of changing the driver from 2007 to 2003 and completed it and still has not fixed error 262. I've tried many different roms and the only ones that bypass 262 are the .exe file rom setups, but after installed still doesnt boot past splash screen. the farthest ive gotten with one .exe is going through the phone setup, but after the setup the phone turns off. the only way my computer notices the phone and the way i flash the phone is when it is in bootloader. have also tried the bootloader where you press the back button. I've been trying so hard to fix this phone but it just wont happen. please help?
Click to expand...
Click to collapse
If this happens, you can just soft-reset the device and run RUU again. The update process will then continue.
Note: At this stage, the Wince is destroyed; instead, it is in upgrade mode.
for official rom you can find at http://www.shipped-roms.com/index.php?category=windows mobile&model=Diamond

Categories

Resources