HELP!!!! - G1 Q&A, Help & Troubleshooting

I install Danger SPL on my G1 but when the process go to reboot the device for complete the installation of Danger SPL i remove the battery i don't know why and my G1 freeze in the logo but i can get to de Recovery RA and fastboot, HBoot nothing what i can do.

Nothing. You have a brick.

Related

bricked hera100 need help

Hi
I have HERA100 which is stuck on start up logo and can not complete booting, for flashing I have to put the phone on boot loader mode, it gives me the following data:
IPL 4.11.0002
SPL 4.11.0000
need advice on which files should be used to revive my phone?
WBR.
enter bootloader(hold camera and poke hole on side)
then get the official ROM(if its a tmobile wing) then flash it.
p.s. i dont think you need the official rom. ive bricked my wing and just reflashed a different ROM
I already tried that, but the upgrade process stops at 2% and the phone reboots with same condition (stuck on start up logo).
By the way, the start up logo is O2 and not Tmobile.
WBR.
hmm are you trying the same rom that bricked your phone?
I tried more than three different roms, most of them stops at 3%, one of them stops at 2%.
is there any special procedure should be done?
WBR
i dont know what else.
try reading this: http://forum.xda-developers.com/showthread.php?t=345411
This happen to me before u have to use the RUU and enter the boot loader through the process u were given in the previous post
your phone is an o2 xda terra. there is no ruu for the terra.
Put your phone in bootloader and use USPL or HardSPL to flash a custom rom to your phone. You will have to HardSPL your phone as it is not yet HardSPL'd if you choose to take that path. In any case, USPL is preferable until you're out of warranty
but the phone can not work in normal mode, how can I use the hardspl or uspl in my case ( phone works only in boot mode)?
for USPL: This will work in bootloader
Download it, put it in the right directory, slap in the .nbh file, FLASH-IFY!
for Hard-SPL: This MIGHT work in bootloader
Download it, press the button
a bit vague, but thats the gist of it. Use USPL

Flashing without getting past the G1 splash screen?

So basically, I just got through doing the SPL update (I was re-rooting my phone) and now it just hangs at the G1 splash screen.
I've tried booting into the Recovery (I've already applied Cyan's 1.4 recovery img) using (Pwr+Home) and the other things (Pwr+Camera) and still, there's nothing.
Now, I don't have a phone.
And I'm starting to /rage...
Is there anyway I can reflash the R29 without being able to access anything on my phone? just so my phone works atm?
AnarchyCow said:
So basically, I just got through doing the SPL update (I was re-rooting my phone) and now it just hangs at the G1 splash screen.
I've tried booting into the Recovery (I've already applied Cyan's 1.4 recovery img) using (Pwr+Home) and the other things (Pwr+Camera) and still, there's nothing.
Now, I don't have a phone.
And I'm starting to /rage...
Is there anyway I can reflash the R29 without being able to access anything on my phone? just so my phone works atm?
Click to expand...
Click to collapse
Did you flash the radio before the SPL? Because if ya didn't then you bricked your phone... If you can't boot into recovery or get the SPL to come up.. you're toast. double

Need help with ADP1 stuck in the SPL mode

Long story short, I've received this ADP1 from a friend, this ADP1 will only boot into a SPL mode when you turn it on.
But at the time, it still has the ability to boot into a fastboot mode, so I mount the RA1.5.2 recovery img to see if it will take CY rom, it successful booted into the recovery mode, and flash the new radio, 1.6 rom along with the CY rom no problem, but when reboots, still goes into the SPL mode.
So here comes the stupidest move...
I've accidentally flash the NBH file(RC29), and was hoping to have a fully restore the phone, but it didn't, and made it worst, now, it still goes to the SPL mode when you turn it on, and now, I lost the ability to access the fastboot mode, and recovery mode only shows the icon, nothing else.
I would like anyone's advise, anything I can try?
Appreciate your help!
Hmm that's a very odd situation. Without being able to boot the phone after flashing RC29 you have no way to gain root again. Sorry to say it but I think you have a semi-unrecoverable-brick :-/

bricked - need help

hi,
I have a G1 that I got with unrooted 1.6
I followed instructions at http://wiki.cyanogenmod.com/index.php/Full_Update_Guide_-_G1/Dream_Firmware_to_CyanogenMod to get CM 4.2 on the phone, that worked without any problems
I then installed DangerSPL and followed instructions at http://forum.xda-developers.com/showthread.php?t=672992 to get CM 5.0.7 installed, and that also worked.
When I installed ROM Manager to partition SD card for apps2sd, the phone would not boot any more, it kept getting stuck at the G1 / T-mobile screen
I then entered fastboot and reinstalled RC7 (DREAIMG.nbh)... that booted without a problem... I then re-flashed cm-recovery-1.4, went into recovery and installed cm 5.0.7 and gapps... I'm not sure but I may have skipped radio and danger this time around
since then the phone won't boot or enter recovery or enter fastboot... any attempts to boot into any of those results in the phone getting permanently stuck on the G1 / T-mobile screen
I'm out of ideas here, so any help would be greately appreciated.
thanks,
allixsenos
allixsenos said:
hi,
I have a G1 that I got with unrooted 1.6
I followed instructions at http://wiki.cyanogenmod.com/index.php/Full_Update_Guide_-_G1/Dream_Firmware_to_CyanogenMod to get CM 4.2 on the phone, that worked without any problems
I then installed DangerSPL and followed instructions at http://forum.xda-developers.com/showthread.php?t=672992 to get CM 5.0.7 installed, and that also worked.
When I installed ROM Manager to partition SD card for apps2sd, the phone would not boot any more, it kept getting stuck at the G1 / T-mobile screen
I then entered fastboot and reinstalled RC7 (DREAIMG.nbh)... that booted without a problem... I then re-flashed cm-recovery-1.4, went into recovery and installed cm 5.0.7 and gapps... I'm not sure but I may have skipped radio and danger this time around
since then the phone won't boot or enter recovery or enter fastboot... any attempts to boot into any of those results in the phone getting permanently stuck on the G1 / T-mobile screen
I'm out of ideas here, so any help would be greately appreciated.
thanks,
allixsenos
Click to expand...
Click to collapse
Why would you unroot just because a ROM wouldn't get past the G1 screen. Too bad you didn't post about that instead of completely unrooting and trying again.
Oh, you probably didn't miss danger spl the second time around and forgot to flash radio and now you're soft bricked. Sorry, there's nothing we can do.

[help] g1 not booting after hboot wipe

I WIPED HBOOT because Clockworkmod wasnt downgradable and radio and spl not downgraded either so i wiped hboot then the device didnt boot
Does it get past the G1 screen? Can you boot into the Bootloader or Recovery?
the g1 screen doesn't appear i fixed bricked ones before but its not burned out but it wont boot i deleted the Hboot spl
>fastboot erase hboot
>fastboot reboot
How to undo this
The phone turn on but no g1 screen and when it turns on it doesnt vibarate so idk if it gets onto the system or not

Categories

Resources