[Q] Bluetooth not releasing audio at disconnect? - Motorola Droid 4

Hi,
I'm running my Droid 4 on stock ICS, and I've noticed that sometimes I have no sound. This has happened for regular audio, but also phone audio. Sometimes switching off Bluetooth, and switching it back on again, restores the phone to normal, but sometimes I need to reboot to fix it.
The problem seems to come after I've been in the car, where the phone connects to my car stereo, and I wondered whether something is going wrong then the bluetooth disconnects from the stereo, and the speakers of the phone aren't being switched back on again.
Has anybody experienced the same problem, and is there a fix for it?
Cheers,
Steve.

Related

Having Bluetooth "Handsfree" and A2DP connected at same time causing severe skipping

Having Bluetooth "Handsfree" and A2DP connected at same time causing severe skipping
Hi....I know there are a lot of posts regarding skipping while playing MP3s over A2DP. My problem is perhaps a little bit different because I've narrowed my problem down to the handsfree bluetooth service.
Here's my situation with my unlocked HTC TyTN II using the stock HTC ROM and with no registiry modifications (bitpool, etc)
If I have only A2DP connected and streaming music to an external bluetooth receiver the MP3 playback is flawless. It sounds fantastic. I've tried Windows Media Player, PocketMusic, and PocketPlayer and they all work just great.
However, when I turn on my handsfree headset (which is a separate device from my A2DP receiver) and allow it to connect to my TyTN II, extreme stuttering immediately occurs through the A2DP music stream. When I shut off my handsfree headset the stuttering stops and the music stream returns to its usual fantastic sound. The problem can be replicated also by leaving the handsfree headset powered ON and simply enabling handsfree service on the HTC TyTN II to cause the stuttering to begin. The stuttering stops immediately when handsfree service is subsequently disabled.
Anyone else out their experience this? Any suggestions? For the time being I have to resort to disabling handsfree when streaming music to my A2DP bluetooth receiver.
Skipping/Cutting out/Speeding Up/Slowing down
Not much to add other than 'Me Too!' and thanks for tracking this down since i thought i was going nuts since I've had a couple of times where i thought i had it resolved only for it to crop up again.
Are you also experiencing your A2DP audio speeding up and slowing down along with the audio cutting out? since to me that is the most bizarre of all of the audio freakery going on.
I found my Logitech handsfree less likely to cause cut outs when on than my Jawbone does. but neither were trouble free.
Just an update for those that may experience the same problem as me. I've noticed that sometimes I have perfect audio even though I am connected to my handsfree car system while streaming music via A2DP. So this leads me to believe that bitpool settings and such are not the issue...since the perfect audio can occur with the default settings. I have also heard in other threads that flashing a new radio may help...but haven't gone to that measure yet.
What I have been able to determine is that this horrible skipping/stuttering occurs when my phone is changing cell phone towers.
That is, if
1) Streaming audio over bluetooth via A2DP
AND
2) Tytn II also connected to a handsfree device
then A2DP skips horribly when the phone needs to switch cell towers.
I have confirmed this by using the program PhoneAlarm to log the cell phone towers my phone is connected to. My A2DP stuttering/skipping problem coincides with every change in cell phone tower.
Now having said all this there is still one other factor that plays into it that I haven't quite figured out. If I soft reset my device and then immediately connect to my car and A2DP stereo then I do not get the stuttering problem when changing cell phone towers. However if I spend the day using the device, active-syncing and such at work, then on the drive home I will ALWAYS get the stuttering during every cell phone tower hand-over.
Frustrating. Anyway...hopefully I'll eventually figure out the last piece of the puzzle. I would rather not have to soft reset every time I get in my car just so that I can get good audio.
--------------------------------------------------------------------------------
hondophred said:
Are you also experiencing your A2DP audio speeding up and slowing down along with the audio cutting out? since to me that is the most bizarre of all of the audio freakery going on.
Click to expand...
Click to collapse
I do recall getting this behaviour when using Windows Media player...but I have started using the new Pocket Player and have since never experienced the audio slow down problem.
I found a work-around that works for me. It's posted here:
http://forum.xda-developers.com/showthread.php?p=1990783#post1990783
Yet another A2DP skipping problem
Rumball said:
I do recall getting this behaviour when using Windows Media player...but I have started using the new Pocket Player and have since never experienced the audio slow down problem.
Click to expand...
Click to collapse
I seem to have related but a different problem with skipping.
I have both Sony and goldlantern BT headphones which i tried (stereo profile).
Both severely skip audio when located on the left side of my belt. Silly but the reception/skipping problems improves a GREAT deal when i move it to the right side. It works flawlessly inside of the building where i have no phone signal but outside -- it skips horribly, even worse after 6.1rom upgrade.
Can anyone confirm that the BT signal going through the body worsens skipping? If so, I assume the signal strength/BT/wireless channel may be at fault, not the tower switching as for me, it happens even when I stay stationary.
Any help is GREATLY APPRECIATED!
TILT - R2 VEGA WM6.1 CE OS 5.2.19209 (Build 19209.1.0.2) ROM
I think part of the problem can be the A2DP device as well. I had a pair ofr HT 820 older bluetooth headsets with A2DP that were skipping and annoying. I went out and bought some s9s and the problem went away. I figured just for a test I would try the HT820 out again, still skipping. So for me it was not the phone but the A2DP device.
jallenclark said:
I think part of the problem can be the A2DP device as well. I had a pair ofr HT 820 older bluetooth headsets with A2DP that were skipping and annoying. I went out and bought some s9s and the problem went away. I figured just for a test I would try the HT820 out again, still skipping. So for me it was not the phone but the A2DP device.
Click to expand...
Click to collapse
i thought that too but i have two different headsets from two different manufacturers, both are skipping the same...
A2DP requires a lot of the bandwidth Bluetooth can provide. Having a 2nd connection open simply exceeds what the Bluetooth chip can handle, no surprise in that. If the BT headset keeps the connection open it's very likely to happen.
kilrah said:
A2DP requires a lot of the bandwidth Bluetooth can provide. Having a 2nd connection open simply exceeds what the Bluetooth chip can handle, no surprise in that. If the BT headset keeps the connection open it's very likely to happen.
Click to expand...
Click to collapse
what do you mean by a SECOND CONNECTION?
i have 2 different headsets because i thought that i have a poor headset, but both work similarly bad, which makes me think it is the tilt, not the headphones. i do not have 2 connections, never has it and not even sure if it is possible....
Lowering of bitrate did not help at all.....
Anyone have experienced these problems? anyone is using BT headset besides motorola s9?
On mine it does it when it picks up a wi-fi hotspot. When I'm driving the wi-fi is on when the screen is and whenever I pass a hot spot it drops out. Turning the wi-fi off solved it. Don't know if it does it with cell towers.
gs465 said:
what do you mean by a SECOND CONNECTION?
Click to expand...
Click to collapse
The thread was initially about skipping when BOTH an A2DP stereo headset AND a BT handsfree were connected at the same time, as the title shows. I was commenting on that.
Other than this, when I want to listen to music I can leave the Kaiser in my room and walk around in my entire flat with the headphones on without skipping (around 10-15m straight line, with some walls).
However, Wifi must not be active and communicating, otherwise either / both of them will drop. If I'm using Wifi and start streaming audio via A2DP, the wifi will slow down a lot and sometimes disconnect. In the same way if Wifi is communicating the audio will skip. If both of them are active but one is idle everything's fine. But that's also normal as both share the same frequencies and will step on each other. When usage is low it's not noticeable but when both are using a lot of bandwidth then they will disturb each other.
The cell radio doesn't seem to cause any problems for me.

[Q] Phone calls routed to internal speaker on wired or bluetooth headset.

Hi everybody. I have just got my new HTC One and I am really loving it. But I seem to have run into a major problem which I couldn't solve despite trying everything. Whenever I receive or dial a phone call while using a wired headset or bluetooth headset, I can hear the sound in the headset for a couple of seconds but then the call is routed by default to the internal speakers and mic. All this while the phone shows that the output is going to the headset. If I change it to the internal speaker and back again to the headset (wired or bluetooth), everything works normally and I can talk and hear through the headset. This problem only occurs with phone calls and I am able to listen to the music through headsets normally without any sound quality issue. I have searched on various internet forums but all in vain. A few more people were having this problem but no solution was in sight. I thought may be an upgrade would solve this problem but alas even after upgrading to the latest 4.3 update, the problems remains. Hope somebody here can help me with this problem.

HELP! - OP3T cut audio while playing on car bluetooth

Hello Everyone,
I'm having this issue for some time and was trying to solve by myself but my resources are done.
Scenario: OP3T 128Gb OOS 4.0.2 (no root) playing music using Spotify on a car Bluetooth device (Toyota Corolla - picture of the stereo attached).
Problem: Audio cuts during play. I can also listen some noise indicating problems on audio transmission. IĆ” attaching a 1 song recorded in the car where is possible to listen the audio cutting some times during just one minute. It's impossible to listen music with this problem. So annoying.
No problems listening to music on other bluetooth devices like earphones or a audio totem. No problems listening using audio jack.
Workaround: When I do a Network Setting Reset the problem goes for a while, normally for a day. The problem come back after some time and I need to reset network settings again. I'm basically resetting network settings every day.
My wife's iPhone plays without any issue. I had a Moto X Style (Pure) before and I had this problema after flash some CM13 based ROMs, solved by flashing the original fw some times. (Moto X Style have some problems and if u flash modem and other thing once it won't work)
Anyone else had this kind of problems? So I need some help to figure out what is happening.
HELP!!!!!
Well, my bluetooth connection is stable. But sometimes when connecting to my car's bluetooth it starts playing music through the phones speaker instead of transmitting it to the car. I have to disable and enable it again - kinda annoying when the party is in your lap, at least while driving in a car.

Bluetooth randomly switching output

I use a plantronics headset that's a couple years old but still works and charges up just fine. For the time that i have had the Note 8 along with the S8, i have been seeing an issue where ill be talking with someone on the headset just for the output to switch automatically back to the phone. It will then switch back if i haven't noticed and i will hear a beep from the headset indicating it is paired again.
Has anyone else noticed this? I don't have another device to try out to verify a bad headset.

Phone calls are going through phone speaker

My AA enabled head unit and Galaxy A52 have been working fine together but recently the audio from phone calls has starting coming from the phone speaker whereas before it came from the car speakers. Other audio, ie music, navigation directions etc all continue to come from the car speakers as before, its just phone calls that has changed.
There has not been a change to the hardware so I assume this has been caused by a software change somewhere, has anyone else experienced this and/or know of a solution?
Thanks.

Categories

Resources