Hi all,
After rooting and flashing cwm with NVFLASh, my phone goes to a black screen just after LG logo and only battery pull makes it off. If I turn it on, same **** happens. I am on stock 2.3 and I also flashed stock partition table with nvflash (512mb SYSTEM). Don't know what to do...:crying
P.S: I have also flashed it with a package in which recovery and system imaged were present and I had to run flash.bat
Please help ASAP!!!
Regards
Related
EDIT: Can be closed, fixed it by going into recovery and wiping data/cache, never had to do that before in other flashes so didn't know it was needed
Hi guys,
first of all I'm not another first time flasher, I already succesfully put 4 other roms on my galaxy s but now I don't know what to do..
I came from jm5 and wanted to upgrade to jm8 today so I back upped everything and started the process, I thought I'd best follow richthoven's instructions so I first flashed the pit file + repartition, and then after pass, removed battery, back to download mode and put pda,modem,csc etc like always and started flashing.
Now my problem is from what I remember after the final reboot before odin sais pass the s logo dissapears and the phone boots into touchwiz, but now after the s logo dissappeared, my screen just stays black and after a minute or two odin sais passed, but there's nothing on my screen, and even after disconnecting and removing battery and try to boot it hangs on the s logo for a few minutes then a black screen with the backlight buttons highlighted.
Any help here would be greatly appreciated!
PS: I already tried the flashing procedure twice, same result
Hello!
I've got a little/big problem with my phone...
first of all im using this: http://forum.xda-developers.com/showthread.php?t=1748984 instead of cwm.
And yesterday i tried to flash a new ROM. First all went pretty good, but the play store was bugged. So i did a new wipe and flashed again, but ofc it was stuck in the bootanimation, so i plugged out the battery... and now all that comes up is first the LG-logo, then the teamwin logo, then it's stuck showing the temwin logo... So i can't flash a new rom, i cant get into recovery mode and when i try to use smartflash on my pc the S/W upgrade wont appear while pressing vol down + pluggin the usb cable, instead the phone is black, the lg logo appears and then it's black again, and it repeats.
Any help or suggestions would be so nice of you!
never use that recovery method, always use CWM non touch version. i think you should nvflash
Use NVflash, me same one time!
Before using rhe nvflash method, try flashing CMW to your phone again. Go to Rusty's CMW thread in the Development section and download it from there.
Sent from Arkam Asylum
alright so i installed Rom manager and made a backup on the internal memory. for some reason i tried to restore it soon after but now i just get the lg logo. then it goes blank and then lg logo again. i never get to the loading bar.
I can still boot into CWM. but no matter what i try i get the same boot loop situation.
help is much appreciated.
btw im running
stock gingerbread
cwm v6.0.1.5
I have rooted my lg thrill using ClockworkMod Recovery v5.8.4.3 a while back.I noticed the battery would drain fast.So I wiped the data on the phone thinking that would help I did not make a back up.When the phone booted back up i see the lg logo then it takes me straight into cwm. So I downloaded a rom to put on there.It said the rom installed. But when I reboot again I see the same thing lg logo then cwm.Is there any thing I can do now or is it like a concrete brick?
I also tried to install omap drivers and couldn't get them installed. Please help
http://forum.xda-developers.com/showpost.php?p=39693262&postcount=9
Hello everyone.
Recently i was using in my p880 Cyanogenmon rom based on 4.2.2 version and after getting bored of it i decided to come back to stock Lg rom.
After installing stock lg rom through KDZ installer my phone came in a boot loop. I tried to hard reset it through system recovery but when i select the factory reset
the only thing my phone does, is showing me the Dead Android icon with the red triangle. Is there anything else i can do to "wake it up" from the boot loop?
If you have CWM or TWRP installed boot it power + vol. Down.
Download the stock ROM for your region (flashable zip.) Copy to SD card
Then full wipe data/cache/dalvik/system
And flash ROM you downloaded and copied SD.
Sent from my Optimus 4X HD using XDA Free mobile app
babisdami said:
Hello everyone.
Recently i was using in my p880 Cyanogenmon rom based on 4.2.2 version and after getting bored of it i decided to come back to stock Lg rom.
After installing stock lg rom through KDZ installer my phone came in a boot loop. I tried to hard reset it through system recovery but when i select the factory reset
the only thing my phone does, is showing me the Dead Android icon with the red triangle. Is there anything else i can do to "wake it up" from the boot loop?
Click to expand...
Click to collapse
Use lg mobile support tool to re-flash stock ROM.After that, enter the recovery and do a factory reset.This as always fixed any problems I experienced.The main issue of bootloop after returning to stock ROM is a problem with data partition usually which can be fixed by doing a factory reset, however I don't know why you got that red triangle and I don't use kdz flashers on this phone as mobile support tool does fine job.
stuck in sw upgrade mode
HI im after some help. my p880 is stuck in sw recovery mode. i have tried to use the lg upgrade recovery and it always fails at 10% even with the modem disabled. i have also tried kdz flasher but with the same results. totally lost here. any help greatly appreciated