Most of my day I am in a location near a 2G tower, but within range of a 3G tower. My phone seems to bounce around between 0-2 bars on 3G (when it is 0 bars on 3G I mean that it switches to 4 bars on 2G).
If I turn on "only use 2G networks" then I am consistently 4 bars. I'm tempted to just lock-in the 4-bars, but I don't know much about cell technology.
Well your battery will last longer not switching between the two all of the time.
Even a 1 Bar on 3G will be many times faster than 4 bars on 2G. So it depends if you want temporary speed or not.
i recently unlocked, rooted and s-off my htc one, on stock i used to get around 5/4 signal bars and now i only get two/three.
im currently running trickdroid 7.5 rom 4.2.2.
so im looking for a radio which would work for orange/EE in the UK.
please can someone help, or point me into the right direction
this is the one for the 4.2.2 firmware
http://forum.xda-developers.com/showpost.php?p=42139108&postcount=18404
Are you sure that it is not the same level? Don't be fooled by the bar looking different, remember that it might show 2 bars of LTE but that could still be better than 5 bars of H+ (as an example).
So if you used to get 5 bars of 3G but your now getting 2 bars of H or H+ then you are better off even though its less bars.
Please do not take this as me treating you as if you are stupid, I am not, I have come across a lot of people recently who thought the same, and it turned out to just be a different type of signal.
fixed
okk i just flashed 1.29.401.12 Radio and it's back to normal.
i found it here http://forum.xda-developers.com/showthread.php?t=2245615
Lennyuk said:
Are you sure that it is not the same level? Don't be fooled by the bar looking different, remember that it might show 2 bars of LTE but that could still be better than 5 bars of H+ (as an example).
So if you used to get 5 bars of 3G but your now getting 2 bars of H or H+ then you are better off even though its less bars.
Please do not take this as me treating you as if you are stupid, I am not, I have come across a lot of people recently who thought the same, and it turned out to just be a different type of signal.
Click to expand...
Click to collapse
thanks for the input but!
i never said i was using my data connection,
Same principle applies even with data off.
Sent from my HTC One using Tapatalk 4 Beta
Lennyuk said:
Are you sure that it is not the same level? Don't be fooled by the bar looking different, remember that it might show 2 bars of LTE but that could still be better than 5 bars of H+ (as an example).
So if you used to get 5 bars of 3G but your now getting 2 bars of H or H+ then you are better off even though its less bars.
Please do not take this as me treating you as if you are stupid, I am not, I have come across a lot of people recently who thought the same, and it turned out to just be a different type of signal.
Click to expand...
Click to collapse
So if I have 5 bars when set to "GSM" only but 2-3 when set to "GSM/CDMA" .. that's as good?
I'm being serious btw, I normally set mine to just GSM as I seemed to have more signal but if there isn't any point then I won't bother lol ..I'm in the UK btw and on a network that doesn't support LTE (I think)
AllAboutTheCore said:
So if I have 5 bars when set to "GSM" only but 2-3 when set to "GSM/CDMA" .. that's as good?
I'm being serious btw, I normally set mine to just GSM as I seemed to have more signal but if there isn't any point then I won't bother lol ..I'm in the UK btw and on a network that doesn't support LTE (I think)
Click to expand...
Click to collapse
You can confirm the 'type' of signal you are getting at any time in the menu > settings > about part of the phone.
Your phone will automatically switch to whatever the best signal is available at any time, you don't really need to change your GSM/WCDMA settings, unless you really want to force it away from 3G connections (again this does not mean you have to have data turned on).
Cool, I'm not too fussed about what data type it uses as I rarely have data turned on, I just naturally assumed that by switching it from GSM'CDMA Auto to just GSM, meant that I'd have better reception, being that the signal bars went from 2/5 to 5/5 ... You learn something new everyday lol
EDIT: I checked my signal, and I mean my reception, not the data connection type, when switched between GSM/WCDMA Auto and GSM Only and there is a huge difference. I found this guide:
dB Signal - A basic guide
-50 to -60 (very strong, near a cell tower)
-60 to -70 (extremely good, rare)
-80 to -85 (normal downtown)
-90 to -95 (getting on the weak side)
-95 to -98 (weak, dropping calls)
-98 to -100 (bad, hard to stay connected)
-100+ (basically no usable signal)
When I set my phone to GSM Only I hover around -70, which is good, when I switch to GSM/WCDMA Auto it is a different story. I know it changes and finds the best signal, which I might add drains more battery on an already power hungry beast, but I was hovering at -100 which is terrible and often calls were dropping or people were saying it was engaged when infact I hadn't used it.
It's clear to me that in my case, GSM Only is the far better option if I actually want to use my phone to make calls ... Data speeds I'm not arsed about so EDGE is just fine with me.
I've seen some people post regarding less/lower signal bars when updating to the new radios which come with 4.3 and you have LTE.
At first I said "WTF" but then I realized... the bars are now sort-of working as intended...
Let me explain,
If you're connected to LTE, the bars are now based off your LTE signal strength. I noticed even at roughly -110 to -100 I only get one bar. I believe the bars start going up dramatically once you have a signal strength greater than -100 (for example, -95db, -85db) And we all know -130db is the cutoff before we lose LTE.
I figured this out once I turned the phone to "CDMA only" to test. Once on "CDMA only" I had almost full bars, (-70-75db for 3G/1x)
To conclude, if you're on LTE and only have 1 bar, you most likely/probably have great cell phone coverage as that 1 bar is determining signal strength for only LTE. When connected to LTE, you're also still connected to 1xRTT which is used for voice. LTE is only used for Data at the moment.
If you really want to test your cell phone coverage, you can get one of those programs to tell you both your 1x signal and 4G signal simultaneously.
Edit: I forgot to mention, Considering the LTE radio and 1x/3g radio are seperate, you're going to get mixed results depending on signal penetration through walls, trees, etc. From what I've seen so far, as of right now 1x/3g penetrates a bit better than LTE. But, really depends on your surroundings
Thanks for the info. Someone else tipped me off about this, and a few SpeedTest checks confirmed it. In fact, 1 bar with the 4.3 ROM produced slightly better results than the 4.1 ROM with 5 bars.
ED2O9 said:
Thanks for the info. Someone else tipped me off about this, and a few SpeedTest checks confirmed it. In fact, 1 bar with the 4.3 ROM produced slightly better results than the 4.1 ROM with 5 bars.
Click to expand...
Click to collapse
Yup, which makes sense because when connected to LTE on 4.1 the 5 bars are based off your voice coverage, not LTE strength.
Still seems kind of dumb. I'd rather know what signal I have to make a phone call rather than what kind of data I can expect.
Thanks for info !
Sometimes just 1 bar but internet working well, but 4-5 bars it is not working/slower !
Hello everybody.
I recently bought a HTC One M7. I'm satisfied with it, except when it comes to 3G connectivity and signal strength. I only have from 1 to 3 bars when connected in 3G, while with my chinese phone I was having complete bars.
Here is a little comparaison :
Code:
3G
chinesephone -91 dBm
htc -101 dBm
EDGE
-79 dbm (chinesephone )
-77 dBm (htc)
Sometimes with my HTC, it can go down to -107 dBm, without touching it (just by looking at the screen) !
I put in attachment a screenshot showing the dBm variation over time. Sometimes it can get a pretty good signal and suddenly having a bad signal and stays there. Please bear in mind the chinese phone doesn't have the same problem...
I did all the updates, I'm on 4.4.3 and Sense 6.0. What should I do ? Should I send it back for reparation ?
Thanks you!
I am looking to pick up a Note 4. I am wondering how the device would perform in fringy signal areas. For example my iphone 6S on T-Mobile can hold onto 1-2 bars 4G, mostly 1 bar 4G, but usable in my office, periodically picking up 1 bar LTE. Would the Note 4 do the same?
Thanks