hello people i need some help with fixing my htc so i can boot it back to normal i installed TWRP so i could flash superuser and then when i tried to reboot it booted only into bootloader the phone is not recognized by the computer but when typeing fastboot devices in cmd it is any help?
Related
Hi Guys ;
I have unlocked the bootloader of my HTC one and now inside fastboot it shows UNLOCKED. I have also tried to flash both TWRP and CWM recoveries using fastboot method and both finishes with success with no error messages.
but the problem is that I can not boot into recovery. I dont know what happens exactly but seems rebooting into recovery fails and phone reboots again into normal mode so I see the htc boot screen twice and then I am in normal mode.
Do you have any ideas ?
Regards
I finally managed to install TWRP. the trick was to disable fast boot in power settings , then turn off the phone completely and enter hboot and then fastboot.
I was entering fastboot directly through adb and it was not working ! it should be a bug inside bootloader. it should not matter how you enter fastboot , but in this case it does matter ! I hope it helps someone.
Ok I have an issue, I tried to install a ROM using TWRP and after it finished installing I rebooted and got stuck in a boot loop on the bootloader screen (the screen you get to when you hold down the power button and down on the volume). I read online somewhere that I have to relock and unlock my phone which I proceeded to do, but as you may know that deletes everything off of your SD card. Then I went into cmd and used the code
fastboot wipe cache
fastboot flash recovery recovery.img
I can now get into TWRP but I have no rom to restore to, no back up and when I go to Advanced Adb Sideload, then swipe to download it says
"Adb Sideload Complete" (at the top)
"Failed" (in red right below it)
I know I have to do something with adb or fastboot, but when I type Abd Devices into cmd I get the picture below which says:
List of devices attached
FA34PS901853 recovery
I cant adb push or install and I have NO clue what to do
But im pretty sure that I somehow have to reinstall Superuser so some help with that would be much appreciated as well
PLEASE O PLEASE can someone help me with this
Hey! So I rooted and installed cyanogenmod on my HTC One M7, and It was working fine for a while. Then recently it wouldnt turn on. I can access the bootloader, but my recovery - ClockWorkMod - was not working. I cannot enter recovery or factory reset my device. Also when I try to flash a new recovery via fastboot, it says that it failed to write, and my devices freezes on the fastboot screen. In fact any command I try via fastboot fails. I Hope to be able to restore my phone back to stock sense. Any help?
My sdcard is Fragmented
Glognaw said:
Hey! So I rooted and installed cyanogenmod on my HTC One M7, and It was working fine for a while. Then recently it wouldnt turn on. I can access the bootloader, but my recovery - ClockWorkMod - was not working. I cannot enter recovery or factory reset my device. Also when I try to flash a new recovery via fastboot, it says that it failed to write, and my devices freezes on the fastboot screen. In fact any command I try via fastboot fails. I Hope to be able to restore my phone back to stock sense. Any help?
Click to expand...
Click to collapse
My sdcard is fragmented:crying:
Hey,
My phone is stuck in the fastboot mode, without any OS, nothing works... no Recovery ,...
S-ON, no-debugging usb, Bootloader locked and can't unlock him... I already tried with htc-dev, everything works but nothing appair on my screen to confirm the unlocking.
I'm really stuck, searched lot of things on google, ....
I used fastboot, and ADB, the first one recognize my device, but the last one not. I can't boot on RUU mode neither.
Any ideas?
AzweL said:
My phone is stuck in the fastboot mode, without any OS, nothing works... no Recovery ,...
Click to expand...
Click to collapse
The very first thing I recommend you to do, is to download the right recovery and install it via command
Code:
fastboot flash recovery recovery.zip
Let me know if you run into any further troubles.
AzweL said:
Hey,
My phone is stuck in the fastboot mode, without any OS, nothing works... no Recovery ,...
S-ON, no-debugging usb, Bootloader locked and can't unlock him... I already tried with htc-dev, everything works but nothing appair on my screen to confirm the unlocking.
I'm really stuck, searched lot of things on google, ....
I used fastboot, and ADB, the first one recognize my device, but the last one not. I can't boot on RUU mode neither.
Any ideas?
Click to expand...
Click to collapse
Hi,
Frist in boot loader check your OS version it should be something like 2.19.401.2 or lower than this.
NB: ALWAYS TRY WITH MORE THAN 75% BATTERY, AND THAT FOR ANY CODE TO WORK PROPERLY, MAKE SURE TO SELECT FASTBOOT BY POWER KEY IN BOOTLOADER
Anyway, if you can enter fastboot, then you have some chance of recovering your device and because you have S-Off it is going to be a bit difficult.
First download this stock boot file : https://mega.nz/#!lEAVwRSL!wrP2hi6GEYLeJaPf2ssZo9wCtSi7E4yfyUHgh3Q3XSs
Then place this file in the ADB folder, then run command :
To flash boot file command is:
Code:
- Fastboot Devices (this command is important to know if the device is connected and accepting and responding commands)
- fastboot flash boot boot_signed.mg (assuming this is the name you saved the file with)
- fastboot reboot bootloader
Also download Stock Recovery: https://mega.nz/#!gVJE1Bxa!6SwXStAD8p-XlnQiPkRcdNo_ITFD1ykn-tN6wIBVi1I
Place this in ADB folder and run command:
Code:
fastboot flash recovery stockrec.img // (assuming that is the name you have saved the file with), only after flashing this you will know if the device has any OS, if OS exists it will boot up.
fastboot erase cache
Attempt and let us know how it went...Good Luck
Hello . A few minutes ago, I had a problem with the TWRP flashing on my huawei p8 gra-ul00 phone .the adb has command's the twrp is complety flashed on my phone , but it did not come up on my phone(after pressing vol+ and power button's the phone will automatiocally go to huawei erecovery). But I took a little initiative and came up with a solution to this problem. I'm share this.
NOTICE : IF YOU HAVEN'T A USB DATA CABLE , PLEASE BUY IT , OTHERWISE CONTINUING THE STEPS WILL NOT SOLVE YOUR PROBLEM .
Before completing all the steps, connect the phone to the computer using data usb cable, then try to enter the recovery mode (for Huawei phones, hold the power button simultaneously with the volume down button for at least one minute.) If the phone Entered custom recovery, no need to do other steps.
1_First Of All , Unlock the bootloader , then reboot the phone
2_Download the custom recovery . IF YOU HAVE ISN'T A CUSTOM RECOVERY FOR YOUR PHONE , PLEASE SEND A COMMENT AND ENTER YOU PHONE MODEL AND A NAME OF THE CUSTOM RECOVERY YOU WANT TO USE TO IT. IM WILL SEND A REGUESTED CUSTOM RECOVERY FOR YOU IN LESS THAN A HOUR .
3_connect the phone to computer and Enable USB Debugging from Developer Options(go to settings>about phone , then 7 times tap on build number , then go back to settings and select developer options , search for "USB Debugging" Option and enable it.)
4_, install the adb and fastboot drivers(such as minimal adb and fastboot) then install the phone drivers . after installing drivers , reboot the computer , then open cmd and enter the command : adb reboot recovery
5_if a window showed on phone(such as allow usb debugging) , click on yes and retry the level 4 again
If you have any questions or problems , commend here.
Hy Bysoft!
I'm new in XDA but i alredy flash some devices with TWRP, it seems that something went wrong with the installation of twrp. Did you try to boot into bootloader (adb reboot bootloader) and then flash the TWRP image with fastboot (fastboot flash recovery twrp.img) and then type fastboot reboot?
I find that list of command: adb reboot etc.. in your device page of TWRP (https://twrp.me/huawei/huaweip8.html). In this site you find the TWRP image for your device, you have to use this image when you flash with fastboot (fastboot flash recovery twrp.img where twrp.img is the image that you downloaded in TWRP site).
PrintHelloPeople
PrintHelloPeople said:
Hy Bysoft!
I'm new in XDA but i alredy flash some devices with TWRP, it seems that something went wrong with the installation of twrp. Did you try to boot into bootloader (adb reboot bootloader) and then flash the TWRP image with fastboot (fastboot flash recovery twrp.img) and then type fastboot reboot?
I find that list of command: adb reboot etc.. in your device page of TWRP (https://twrp.me/huawei/huaweip8.html). In this site you find the TWRP image for your device, you have to use this image when you flash with fastboot (fastboot flash recovery twrp.img where twrp.img is the image that you downloaded in TWRP site).
PrintHelloPeople
Click to expand...
Click to collapse
Hello .
I am also a newcomer
it's true . I also installed TWRP 3.1.1 on the phone in the same way
Thanks for sharing your opinion with me and other XDA users
Regards ,