Hello guys, I have a problem, the phone every time I press the button to turn goes into fastboot mode, how do you do it without going to the fastboot boot normally?
emigianno said:
Hello guys, I have a problem, the phone every time I press the button to turn goes into fastboot mode, how do you do it without going to the fastboot boot normally?
Click to expand...
Click to collapse
Have you flashed something through fastboot?
Try
Code:
fastboot oem fb_mode_clear
doppelhelix said:
Have you flashed something through fastboot?
Try
Code:
fastboot oem fb_mode_clear
Click to expand...
Click to collapse
Yes, I restored the stock firmware. thanks anyway, the command you gave me worked.
Related
MOD please CLose
Try fastboot reboot-bootloader
dgtiii said:
Try fastboot reboot-bootloader
Click to expand...
Click to collapse
nothing happens
DizzlePro said:
nothing happens
Click to expand...
Click to collapse
So what is the status of your phone right now?
dgtiii said:
So what is the status of your phone right now?
Click to expand...
Click to collapse
#
no status
no listed devices in adb
Phone is just stuck with the picture above
Your firmware flash was successful, so don't panic. It is normal for the green bar to not go to 100% in RUU mode. The command I gave you is correct: fastboot reboot-bootloader, not fastboot reboot as you typed it. If it doesn't work, reboot manually to bootloader by pressing power and volume down at the same time until it reboots.
dgtiii said:
Your firmware flash was successful, so don't panic. It is normal for the green bar to not go to 100% in RUU mode. The command I gave you is correct: fastboot reboot-bootloader, not fastboot reboot as you typed it. If it doesn't work, reboot manually to bootloader by pressing power and volume down at the same time until it reboots.
Click to expand...
Click to collapse
Thanks it's all good now my phone has booted up,
It wasn't successful... For some reason the OP did not flash properly. He only issued the flash command only once for 4.3 firmware. Then for a different firmware he controlled+c'ed before letting the 2nd flash complete... Then tried flashing a third time right afterwards which failed.
Needs to do a clean boot and flash the same firmware twice and this time let it finish all the way...
dgtiii said:
Your firmware flash was successful, so don't panic. It is normal for the green bar to not go to 100% in RUU mode. The command I gave you is correct: fastboot reboot-bootloader, not fastboot reboot as you typed it. If it doesn't work, reboot manually to bootloader by pressing power and volume down at the same time until it reboots.
Click to expand...
Click to collapse
Glad to hear it my friend, you are most welcome!
I´m using Windows 7 X64, installed moto G2 drivers, unlocked bootloader, used ADB to bootload and successfuly restored stock ROM to lollipop 5.0.2 , BUT EVERYTIME I TURN OFF/ON (power button used only) DEVICE TAKES ME BACK TO AP FASTBOOT and have to select NORMAL POWERUP to start using my device.
What do i do so device doesn´t take me to ap fastboot screen all the time when i just click on power button?
I apologize if there´s a thread about this topic but couldn´t find it.
HELP PLEASE
THANK YOU GENTS.
To boot straight into the ROM just type this in the fastboot mode
Code:
mfastboot oem fb_mode_clear
Hit thanks if it worked..!
Stay Crazy
THANK YOU!!
It worked!, I appreciate your help
Paradox♀ said:
To boot straight into the ROM just type this in the fastboot mode
Code:
mfastboot oem fb_mode_clear
Hit thanks if it worked..!
Stay Crazy
Click to expand...
Click to collapse
rpardoi said:
It worked!, I appreciate your help
Click to expand...
Click to collapse
Welcome
My moto g2 4G xt1079 was stucked in fastboot mode whenever i power on it,, and i flashed the custom stock rom and its working fine but i lost my IMEI.
Its showing IMEI NULL
and the BASEBAND VERSION is UNKNOWN..
Can anybody provide me a solution.
Sent from my GT-S7582 using Tapatalk
I'm having an issue where whenever I reboot my device it brings me to TWRP instead of rebooting the system. Rebooting system through TWRP just reloads TWRP. The only way for me to start up my device is by loading the bootloader and selecting the "Start" option. This is very annoying Any suggestions?
TWRP I'm using: twrp-sanders-r20 (other versions don't seem to work)
ROM I have installed: PixelExperience_sanders-8.1.0-20180224-1508-OFFICIAL
jlarock said:
I'm having an issue where whenever I reboot my device it brings me to TWRP instead of rebooting the system. Rebooting system through TWRP just reloads TWRP. The only way for me to start up my device is by loading the bootloader and selecting the "Start" option. This is very annoying Any suggestions?
TWRP I'm using: twrp-sanders-r20 (other versions don't seem to work)
ROM I have installed: PixelExperience_sanders-8.1.0-20180224-1508-OFFICIAL
Click to expand...
Click to collapse
Fastboot oem fb_mode_set
Fastboot oem fb_mode_clear
Sent from my Moto G5S Plus using XDA Labs
Adi5 said:
Fastboot oem fb_mode_set
Fastboot oem fb_mode_clear
Sent from my Moto G5S Plus using XDA Labs
Click to expand...
Click to collapse
Issue solved. Thank you so much!
jlarock said:
Issue solved. Thank you so much!
Click to expand...
Click to collapse
Tell me how you did it
SATYAWAN SHARMA said:
Tell me how you did it
Click to expand...
Click to collapse
Make sure USB debugging is enabled, go into your bootloader, connect your phone to your PC, go to your adb folder, shift then right click, open command prompt or powershell, and enter
fastboot oem fb_mode_set
fastboot oem fb_mode_clear
then reboot
i was trying to install twrp in my rog 2 but while installing twrp from fastboot and adb i got stuck in fastboot mode and cannot boot into main OS PLEASE HELP ME
Check current slot and then switch to other slot and boot.
First try
fastboot devices (make sure your device is listed)
if it boots to fastboot again
fastboot getvar current-slot
fastboot --set-active=a or fastboot --set-active=b
fastboot reboot
rabunz1105 said:
Check current slot and then switch to other slot and boot.
First try
fastboot devices (make sure your device is listed)
if it boots to fastboot again
fastboot getvar current-slot
fastboot --set-active=a or fastboot --set-active=b
fastboot reboot
Click to expand...
Click to collapse
Have the same problem. Did all that you say but keeps restarting.
ED_STUFF said:
Have the same problem. Did all that you say but keeps restarting.
Click to expand...
Click to collapse
I had this problem, and I had to download the RAW firmware files and run the "flashall.bat" file through fastboot.
ED_STUFF said:
Have the same problem. Did all that you say but keeps restarting.
Click to expand...
Click to collapse
Did you manage to solve this issue? I have the same problem.
rabunz1105 said:
Check current slot and then switch to other slot and boot.
First try
fastboot devices (make sure your device is listed)
if it boots to fastboot again
fastboot getvar current-slot
fastboot --set-active=a or fastboot --set-active=b
fastboot reboot
Click to expand...
Click to collapse
I was in csc fastboot mode then i mistakenly did some fastboot adb commands from github rog phone 2(am having rog 3, works same) try those and you will get into fast boot mode from csc fastboot mode after than try above for any query contaact me on my mail [email protected]
Thanks xda love you
rabunz1105 said:
Check current slot and then switch to other slot and boot.
First try
fastboot devices (make sure your device is listed)
if it boots to fastboot again
fastboot getvar current-slot
fastboot --set-active=a or fastboot --set-active=b
fastboot reboot
Click to expand...
Click to collapse
Flash fastboot Raw firmware
My phone is stuck in a bootloop. Original firmware, rom, everything, not rooted, bootloader locked. It just restarted by itself randomly and has been stuck in a bootloop ever since. I've flashed raw firmware but it didn't help. Help please
shinnsan said:
My phone is stuck in a bootloop. Original firmware, rom, everything, not rooted, bootloader locked. It just restarted by itself randomly and has been stuck in a bootloop ever since. I've flashed raw firmware but it didn't help. Help please
Click to expand...
Click to collapse
Have you fixed your issue? if not, have you tried flashing both slots, _a and _b, using the same raw rom? use fastboot cmd's to set either slot_a or slot_b to active so you know you're flashing each slot
Hey all. I'm trying to relock my V40 so I can sell it, and I'm having trouble getting into fastboot mode. It still loads up the stock rom alright, but when I try to enter fastboot mode from either command line or buttons, it appears for half a second and then reboots to the rom. Can anyone help me figure out how to get this working properly? Thanks!
cavcagamgee said:
Hey all. I'm trying to relock my V40 so I can sell it, and I'm having trouble getting into fastboot mode. It still loads up the stock rom alright, but when I try to enter fastboot mode from either command line or buttons, it appears for half a second and then reboots to the rom. Can anyone help me figure out how to get this working properly? Thanks!
Click to expand...
Click to collapse
Which varient?
cavcagamgee said:
Hey all. I'm trying to relock my V40 so I can sell it, and I'm having trouble getting into fastboot mode. It still loads up the stock rom alright, but when I try to enter fastboot mode from either command line or buttons, it appears for half a second and then reboots to the rom. Can anyone help me figure out how to get this working properly? Thanks!
Click to expand...
Click to collapse
To relock the v40, use lgup to have a 100% stock rom installed. Then use qfil to flash the eng abl to your active slot abl partition. Exit qfil and go directly to fastboot. Then 'fastboot oem lock'. (and then of course flash the original abl back with fastboot).
u have to have a completely stock rom, no mods of any kind, and u have to use the eng abl, not the 'laf nuked fastboot'.
cheers