Good day
I was trying to update my 2014 Moto G XT1068 from (Kitkat) 4.4.4 to 5.0.2 (Lollipop)
from following this link
http://forum.xda-developers.com/moto-g-2014/general/official-lollipop-indian-ota-captured-t3002674
Now forgive cause I am new to rooting etc, when I did try and root the phone using the global firmware, my sim was disable. So I decided to use differnet firmware with resulted in sim card not getting signal. So I end up using the Brazilian update for the firmware, and ended up having the phone in AP Fastboot Flash Mode with the error is " Error Failed to Validate System Image"
I have tried using different firmware to get back the phone to work, but to no luck, I am asking what steps can I take now to try and fix my problem.
Related
I have a Consumer Cellular XT1064 running 21.11.17.titan_retuaws.retuaws.en.US.na with an unlocked bootloader and am having trouble applying the lollipop ota upgrade patch. When I attempt to apply the patch in stock recovery, I get an error durning "Patching system files". The error reads "assert failed: apply_patch(*/system/framework/framework-res.apk" followed by a series of letters and numbers, and ultimately ending with "installation aborted".
I previously successfully applied the ota and was running Lollipop using this guide. While attempting to root, I couldn't get twrp to persist after a full boot nor could I successfully install supersu, so I decided to start from scratch (probably a bad move) and followed those same steps again, but this time ran into the assert failed error described above. I tried re-locking the bootloader, thinking that may help, but got error messages during the process, so that's a no-go. I've scoured the forums and web for another solution, but haven't come up with anything so far.
Maybe there are some files/settings that aren't being completely restored to 4.4.4 stock through the manual flashing process? I can't get RSD Lite to recognize this phone (even though it recognizes my Droid Maxx just fine).
Any other thoughts or suggestions would be much appreciated.
Solution for XT1064 assert failed errors when applying Lollipop ota
After much trial and error, I successfully found a way to get rid of the assert failed errors and get back to Lollipop. Thanks to diamondjoker5, I obtained the original retail firmware 21.11.23 and used fastboot commands to flash it over the 21.11.17 firmware. I then let the phone fully boot into 21.11.23, powered off, then followed the original ota update procedure once again, without any errors.
Hi, it initially rooted my XT1068 and a day before I received the notification for software update to Lollipop, I opted in for the update, but when I started the update the Recovery mode booted by and when I tried to install from the Recovery by selecting the downloaded file "Blur_Version.21.11.23.titan_retaildsds.retaildsds all.en.03" it gave me error saying:
"Package expects build fingerprint of motorola/titan_retaildsds/titan_umtsds:4.4.4/KXB21.85-23/19:user/release-keys."
Your device has "motorola/titan_retbr_dstv/titan_udstv:4.44/KXB21.85-18/24:user/release-keys".
I got the above message after trying to restore to the stock version from the files in this post :http://forum.xda-developers.com/mot...windows-tool-moto-g-2014-xt1068-dual-t2983295
Prior to the restore which is when I rooted the device, I got the error as "Your device has "motorola/titan_retaildsds/titan_umtsds:4.4.4/KXB21.85-14/9:user/release-keys"
Can someone help me how can I restore the exact firmware?
Hello can any senior member plz help me out.
I have unlocked and rooted moto g2 2014 mobile it was working fine.
But I done a stupid thing by editing system file and overwriting it.
Then my phone stuck in boot loader
I can access recovery TWRP i tried to wipe Delvic and cache and factory resetting but it did'nt worked.
Therefore buy following the link i tried to flash with orginal frimware
www droidviewsmoto g 2014 to stock and lock the bootloader
it was not successful again it strucked in boot loop with Android dead symbol in recovery
------>> Then tried to install TWRP recovery it was successful, but unable to install super user.
There fore I tried to repeat the process buy using both sdk windows platfom tools and vfastboot
buy typing command in cmd as mfastboot.exe oem lock begin
and noticed error saying
hab check failed for boot
failed to verity hab image boot
failed to validate boot image
Plz sir can any one help me out plz
I did not face this exact error, but have faced error like image verification failed and my phone was bricked. Installing stock Lollipop didn't help. So I installed stock Kitkat via fastboot, and it worked, my phone booted successfully to Kitkat. Later I upgraded to Lollipop. Try this and let me know if it works.
Thanks for replying to my post
As it was a soft brick
I was searching so many links in xda
.... At last one link worked for me I got back my stock Lolly pop version back
XDA forums really helped me :good:
I was trying to flash custom rom to my phone but keep on getting "error executing updater binary in zip" . Trying out the options I accidentaly wiped internal storage and with it the recovery. Now i am not having any OS in my phone
I have downloaded couple of rom from Cyanogen for MOTO X (ghost) but each of them give same error ,using twrp 2.8.7.0 as recovery (haven't tried by changing with other because its the only thing left there)
Also tried
flasing custom ROM
but here the problem is "downgraded security version update gpt_main version failed"
Was running on Android 5.1 before this all happened
PLEASE HELP DONT WANT T HARD BRICK MY PHONE
You have to flash stock rom using Rsd lite and u will be good to go
can't find a stock rom asia retail android 5.1
and can't flash 4.4 it shows downgraded security version update gpt_main version
Use the TWRP here (thanks to @rrvvrr) - http://forum.xda-developers.com/attachment.php?attachmentid=3171698&d=1424260997
Its 2.8.5.0. it resolves the script error on xt1052 which official verions have.
Here's the XT1052 IMAGE https://mega.nz/#!U9lRFBgD!POchMYI96ZTy16M_PGSZ4aIjo6ktpaHKaJAmp6XBUR4
while flashing the new recovery to my device using cmd is there any risk for hard brick(when I wont be able to open custom recover or bootloader)
Shivam248 said:
while flashing the new recovery to my device using cmd is there any risk for hard brick(when I wont be able to open custom recover or bootloader)
Click to expand...
Click to collapse
I recommend you flash the factory image through RSDLite once and then proceed to flash CM if you want
rsd dosen't recognize device
I just have the firmware of android 4.4 for my device but lastly it was running on 5.1 so i need that and i cant find that for my device
Can you please describe the step by step procedure to do
Thanks
athulele said:
Use the TWRP here (thanks to @rrvvrr) - http://forum.xda-developers.com/attachment.php?attachmentid=3171698&d=1424260997
Its 2.8.5.0. it resolves the script error on xt1052 which official verions have.
Here's the XT1052 IMAGE https://mega.nz/#!U9lRFBgD!POchMYI96ZTy16M_PGSZ4aIjo6ktpaHKaJAmp6XBUR4
Click to expand...
Click to collapse
My phone wiped everything and is bricked atm. I'm trying to flash the image you posted here but it fails every time at the partition and system stages. It won't work in RSDLite so I tried doing it in cmd but fails at those two points. Do you know why this might be?
Thanks
My phone is Moto G 2014 XT1068 Dual SIM with 5.02 Lollipop. The phone is unlocked but unrooted. I received the OTA notification for upgrading to MM. The process failed. Recovery mode was "no command available" (in Italian). So I installed TWRP recovery instead. The OTA prompt aimed at updating to MM reappared. After have Launched the updating process, the phone entered in TWRP recovery displaying the following error message:
"Package expects build fingerptint of motorola/titan_retaildsds/titan_umtsds:5.0.2/LXB22.99-16.3/5:user/release-keys or motorola/titan_retaildsds/titan_umtsds:6.0/MPB24.65-34/31:user/release-keys; this device has Motorola/omni_titan/titan:5.1.1/LYZ28J/2:eng/test-keys.
Updater process ended with ERROR: 7
Error installing zip file '/cache/Blur_Version.22.56.3.titan_retaildsds_retaildsdsall.en.03.zip
Done processing script file
MTP Enabled".
Any suggestion to allow OTA update to work properly?
Thank in advance.
---------------------------
I have solved the problem reinstalling Stock Lollipop 5.0.2. I now guess that the problem derived from the fact that I had changed the logo to avoid the annoying warning about the risks of having the phone unlocked.
Hope this may be helpful for those that have done a similar change in their phone.