Hi guys,
Recently I just rooted my phone and had philz kernel installed on my phone.... Everything went very well and smooth until some time, the phone just hangs and I tried to shut down but it cant so I enter recovery mode... made a reboot there and it stills go back to the recovery... so I try to remove data and all... it gets booted up agn but all my data lost (like a new phone). After that I tried to flash CM11 Kit Kat rom to my phone and it failed and stuck in recovery again.. Now it stuck at samsung boot up screen. What is the problem with it? Is it soft bricked? Please help and thanks in advance!~:good::fingers-crossed:
flash it via Odin and try to see it as well
Related
HI, im sort of a noob at this but i have been using the Custonexus rom for a cuple of days now and it have been running very good But yesterday when i tried to unlock the phone, the lockscreen didn't show up, the backlit buttons turned on as usual.
I turned off the phone, and did a factory reset. The phone booted up as normal with no problems. When i was up and running again, i booted into recovery to flash back to the stock rom from my backup just to be sure it didn't happened again. I did a factory reset and navigated to the backups but the backup was gone I rebooted the phone but it got stuck on the CN boot screen. What should i do? i have tried many times to reboot it but it always get stuck on the boot animation.
Install original lg kdz and redo everything.
You have to install the Stock (original) Firmware. Here is a HowTo: http://forum.xda-developers.com/showthread.php?t=2069723
Hi guys,
Today I flash with Odin a Stock ROM for i9001. The process goes well buy when I started the device, it stays in the boot animation (the Galaxy S Plus animation). I tried to enter to the recovery to do a factory reset but it reboots the device.
What I can do??
Thank you!!
Solved... Sorry
Hi everyone!
After installing new ROM ''ViperOne4.2.0'' from previos ver.i got in trouble , all installing was orite, but after reboot the system, its starts non-stop rebooting, its not even getting until Viper One logo, and restarting again... i tryd go to recovery , its not possible at all, not even factory reset, cuz then its go to recovery and faild again... everything what can i do, is only Fastboot USB, and Bootloader.... any versions to fix this... thanks
intarsz said:
Hi everyone!
After installing new ROM ''ViperOne4.2.0'' from previos ver.i got in trouble , all installing was orite, but after reboot the system, its starts non-stop rebooting, its not even getting until Viper One logo, and restarting again... i tryd go to recovery , its not possible at all, not even factory reset, cuz then its go to recovery and faild again... everything what can i do, is only Fastboot USB, and Bootloader.... any versions to fix this... thanks
Click to expand...
Click to collapse
What version of viper did you have previously? which one right now? (Kitkat?)
Which recovery did you have?
Are you s off? or s on?
Earlier i flashed my S3 with Odin to cyanogenmod 12.1
Because i want to sell my phone, i did a factory reset.
But now, nothing is working anymore. Only the downloadmode is working. Recovery mode gets to black dead screen :s
I tried to flash another recovery and cyanogen again, but no boot.
Am i doing wrong? Or what can i do to make the phone work again?
Thx!
fixed with parameter flash, and then stock recovery
Working again now
my phone suddenly started this problem with the mic and was frozen too
last week my phone was out of battery but when i charged it up and wanted to boot it, it went on bootloop (couldn't access recovery either)
So i kinda wanted to install TWRP (which I did) and tried a new custom rom.
but now even after a clean stock rom flash using Odin, phone wont boot at all. its stuck on samsung logo to Galaxy A71 logo back and forth. any solutions? please.
Thank you
If flashing full stock isn't working, then it could be a dead motherboard