4g icon even when on 3g - AT&T Samsung Galaxy S 5

The 4g icon is on whenever I'm connected to 3g. H, H+ how do I fix this?

Related

Disable "3G" while enabling "H" - possible or not?

My carrier has bad 3G operation, whilst HSDPA works fine. The problem is that phone sometimes switches between 3G and H, and when it does switch to 3G, there is no internet until it swithes back to H or down to E. I'm almost sure that this is caused by carrier, and I can't fix it with firmware. So I would like my Tab to avoid 3G mode at all, while using H and E. Can I set it to do so?
3Flight said:
My carrier has bad 3G operation, whilst HSDPA works fine. The problem is that phone sometimes switches between 3G and H, and when it does switch to 3G, there is no internet until it swithes back to H or down to E. I'm almost sure that this is caused by carrier, and I can't fix it with firmware. So I would like my Tab to avoid 3G mode at all, while using H and E. Can I set it to do so?
Click to expand...
Click to collapse
Unfortunately, it's impossible, you can either choose "H" & "3G" with wcdma/umts or "G" & "E" with GSM in Mobile Networks. You can't choose to leave out 3G when it's doing H, cause both of them are under wcdma mode.
Of cause, if you leave your "Network mode" to auto, it will jump around gsm and wcdma when it see fit. By choosing it to run GSM mode only, will keep your network connect to "E"/"G(gprs)" ONLY; Or WCDMA for "H"/"3G" ONLY.
helo
3Flight said:
My carrier has bad 3G operation, whilst HSDPA works fine. The problem is that phone sometimes switches between 3G and H, and when it does switch to 3G, there is no internet until it swithes back to H or down to E. I'm almost sure that this is caused by carrier, and I can't fix it with firmware. So I would like my Tab to avoid 3G mode at all, while using H and E. Can I set it to do so?
Click to expand...
Click to collapse
im from malaysia also,im using samsung g5..in my opinion its the the phone or tab firmware or rom problems..because im using maxis and digi broadband..both network are having problem..3g and hsdpa both switch on and back 3g h 3g h..not stabil and anoyying..

4G LTE icon for Trinity Sensation XL 4.0

I made another simple icon mode to override 3G, 3G+, 3G LTE, H, H+ icons with 4G LTE icon
I also attached battery mod with Trinity's ICS fold effect, hope you'll like.
p.s. flash in recovery (no need for backup 100%)
> if someone needs I can manage to make with LTE icon only instead of 4G LTE

[Q] boyppc rogers lte 4G

I have boyppc installed and everything works well except the 4g LTE connection doesn't appear in the status bar. I can boot the phone and not have any apn selected and the connection still works but with no notification in the status bar (3g, 4g, hsdpa). When I point the phone to the rogers LTE apn it gives me the the 3g notification in the status bar. I've taken a brief look at the build.prop and can see that LTE is enabled.
Is anyone else having troubles getting the 4g connection with rogers on the boyppc Rom for the HTC raider x710a?
Are you in an LTE area?
Does your SpeedTest come in at LTE speeds?
If it is connected to LTE, it should have a LTE instead of the 3G on the notification bar; that's peculiar.
Perhaps try another ROM?

[Q] Any way to force 3G instead of H or H+

Guys I have an odd problem.
Where I live, the signal on the HTC One switches erratically and constantly between H+, H and 3G. At every switch of course the data connection goes offline. It's driving me crazy.
Is there a way to force the phone to one of the three: 3G or H or H+?
Please see image 01.
I've tried going into *#*#4636#*#* but the choices baffle me (see image 02). I've tried a few of the available choices but it seems that 3G, H and H+ fall into the same category.
It's probably a dead end, I can't imagine what else to do ..... has anyone else had the same issue?
The 3G logo means it's on voice only, and H+/H means there's data incoming/outgoing. They're using the same radios and frequencies, it's more like an idle state when it shows 3G. 3G will still periodically go up to H+/H to check for any incoming data then goes back to sleep at 3G.
I have the same problem with my connexion. It is only stable when I have the "3G" symbol. I did not find a way to force "3G". It seems the switch to "H" is on demand...
mrechte said:
I have the same problem with my connexion. It is only stable when I have the "3G" symbol. I did not find a way to force "3G". It seems the switch to "H" is on demand...
Click to expand...
Click to collapse
It's normal behaviour, if you have a good H connection it will switch to this when there is data traffic but when there isn't it will switch between 3G and H

[Q] Cell Data Icon is not displaying correctly

After using Xposed Ex-Themer and GravityBox at the same time, now my Cellular Data Icon in the Notification Bar always shows E (edge) even when I a connected via 3g, HSPA, 4g LTE. I cannot seem to get it to reset to stock icons. Any help is much appreciated.
Thank!

Categories

Resources