Hi everybody,
I upgraded my Xperia Z to Lollipop. Immediately after that I got the following problem in the order described:
- Phone was at 80% after upgrade.
- It was not charging after the upgrade, and I had no more connection to the phone via USB anymore. Also PC Companion did not see the phone anymore.
- The battery drained after some time so the phone went into "brick-mode" because connecting it to the pc via USB, nor connecting it to (different) wall chargers did not charged the battery.
- With the phone compeletely empty, I just left it connected one evening to my wall charger, and when I woke up the next day the phone was again completely charged to 100%.
- But no the circle starts from the front again --> no connection to PC and not able to charge the phone until it goes out completely, waiting for some hours connected to the charger, and only then it starts charging again until 100%. I also once booted the phone before it was at 100%,.. even then it will not go on to charge when the phone is on, NOR will it continue to charge when I shut it down again manually (so not let it drain to 0%).
Does anybody had/has the same issue? I think it is a waste not trying to fix this because the phone is still in a very good condition.
Any advise would be helpful, thanks, Pieter.
Related
Hi,
My kaiser has been running fine, i installed a couple of apps this morning and all of a sudden my battery drained from like 70 - 80 % down to 15 %. even though i have plugged the handset into the charger the battery continues to discharge. I have uninstalled the apps from this morning but i have no power left in my kaiser and awaiting some charge to check if this has made a difference. Does anyone have any ideas?
Thanks
Still no luck after uninstalling some programs. Any advise would be appreciated.
Thanks
Does the phone charge at all? Did the phone ever indicate that it was charging even though it wasn't? When you were attempting to charge it, was it through a wall charger or through the computer? If it was the computer, make sure that "When device is turned on, do not charge the battery when connected to the PC" check box is not checked.
I wouldn't rule it out as a software only issue. If you were doing everything correctly, and it still wasn't charging, then there could be an issue with the charger, the battery, or the usb connector on your phone. I had unknowingly damaged my connecter before, and when I went to charge it, it said it was charging but in reality it wasn't.
This problem just started last night and I can't figure out what's the cause of it. After a few hours into charging, the phone just turns itself on and charging stops!
I'm running stock rom with a few performance tweaks. I'm not sure whether this's software or hardware related and if a hard reset would fix anything.
Cheers.
Are you charging using a PC or directly from adapter?
if from PC, click on the battery icon when the device is on and make sure that "When device is turned on, do not charge the battery when connected to the PC." is unchecked
I use the adapter to charge, I did try to untick the option afterwards and now just osberving if it does it again.
May be this's another bug when it's supposedly only applicable when charged from USB.
Charging issue and low battery life
Hi, I have had my X1 for 4 days now and overall I am very happy with the features, and I have obtained a lot of very useful tips from the XDA forum, thanks. However I am experiencing problems charging the phone and also not happy with the battery life. Last night I left the phone plugged into the USB of the pc that I installed activesync on (pc was, of course, also on) I switched the phone off and ensured that the charging light indicators were flashing. This morning the charging indicators were off but the phone was only partially charged. I then plugged the usb cable into the mains charger and the phone charged to full in 1.5 hours. Does this mean that charging via the pc is inefficient? During the day I made no calls and sent 2 texts, I did have messenger and skype running although I put the phone into sleep mode. Its now about 8pm and the battery has died. I have plugged the usb into my laptop (which does not have the activesync software on it) the charging lights are flashing but I dont think that the phone is charging as the battery is draining. I read on this forum that you must have activesync installed on the pc that you want to charge the phone on, but why is this. Whats the point of that, the whole point of being able to charge via usb is that you can top up anytime you are near a pc, and looking at the battery life I assume I will need to top up a lot. Can I have your thoughts please.
i have been in the same position.
it's probably because your laptop / pc is in hibernate mode / power saving mode..hence it doesnt charge.
try disabling it and see how it goes
Thanks for the prompt reply Berlinberlin
Hi I can confirm that my PC is set to turn off monitor after 20mins and to never turn off Hard Disks and never go into standby and never hibernate. So I don't think that this is the problem but thanks for your thoughts
How long does/should it take to fully charge the phone via usb? How long does it take yours to charge? Since I wrote the post above I have had my phone plugged into my laptop but with the phone swithed off, the charging indicators lights are pulsating. I have now turned the phone on and the battery is 40% charged from being nearly totally depleted (about one hour of charging) . I do not have Activesync on this pc, so the phone will charge on any PC, I assume.
hello.
once i had one x1 charged via usb over night (with a pc with active sync)
the battery depleted the next morning and it doesnt turn on again
so maybe it's better to quit active sync before charging?
toucam said:
This problem just started last night and I can't figure out what's the cause of it. After a few hours into charging, the phone just turns itself on and charging stops!
I'm running stock rom with a few performance tweaks. I'm not sure whether this's software or hardware related and if a hard reset would fix anything.
Cheers.
Click to expand...
Click to collapse
The charging problem I've observed has a different effect:
when on charge using the adaptor, the battery charges OK to full and then charging ceases (as it should do)
BUT
if the X1i is connected to WiFi on my LAN, after a time (maybe 30 mins), it commences to recharge and never stops, so the battery can become dangerously overheated.
Disconnecting from WiFi and soft-reset seems to bring the system back to normal.
At this stage I don't know the root cause, but I have a new battery on order. When this turns up, I'll try the same routine and post results. Obviously, I suspect (hope, too) that the "smarts" in the battery are faulty.
x1 charging problem
I' have the same problem with my x1 charging.
The phone after i started charging, turn on and stop the charging.
In the mornig the battery is low.
Is there any solution that fix the problem?
ianl8888 said:
The charging problem I've observed has a different effect:
when on charge using the adaptor, the battery charges OK to full and then charging ceases (as it should do)
BUT
if the X1i is connected to WiFi on my LAN, after a time (maybe 30 mins), it commences to recharge and never stops, so the battery can become dangerously overheated.
Disconnecting from WiFi and soft-reset seems to bring the system back to normal.
At this stage I don't know the root cause, but I have a new battery on order. When this turns up, I'll try the same routine and post results. Obviously, I suspect (hope, too) that the "smarts" in the battery are faulty.
Click to expand...
Click to collapse
In your case I tend to think the problem is with Wi-Fi using more battery than what it's gaining through charging. I had similar problem with a generic mini-USB charger. Most charging problems are associated with either battery or charger itself.
Even i had a same issue,
But i luckily remembered the setting which i had changed,
Try this,
Setting`s->System-> Power-> Advanced Tab
{code}
Make sure u have selected this option and set it to minimum value,
"Turn off device if not used for"
{code}
Hope this solves issue
Edit: thanks to this post, my problem has been solved. Thanks!
So last night I went from stock motorola 2.2 to this wonderful-seeming version of CyanogenMod on my UK milestone - the install went flawlessly, but now I have a problem - my battery is not charging at ALL.
While the phone was on last night after I charged it, it was plugged in, first to my PC and then to the wall socket. In both cases, the battery indicator had a ? (question mark) on it.
I thought it might have been some weirdness with battery calibration so I left it and plugged the phone in from the wall to charge overnight. This morning, my phone was telling me to connect my charger (despite it being plugged in) and on removing the power cable, it died due to no battery power left within 10 minutes.
While plugged in from the wall, the battery indicator comes up but again just contains a ? on it. The little white light next to the power socket never lights up.
If I plug the phone in to my PC via USB then if the handset is OFF, the white light comes on and around 10 mins later it gets enough juice to boot up. The problem is that when the CM7 software starts, the little white light disappears, the phone stops charging despite the cable being present, and it then dies 2 minutes later.
I know the battery is fine because it was perfectly fine before I installed CM7.
Anyone else experienced this problem and/or know how to fix it?
One thing I did manage to do before it died was install a battery calibration app that I found on xda-developers - this told me that the battery was running at 3267 mV - any idea if that's good or bad?
(and yes, I'm using precisely the same cable/charger I was using before I put this version of CM7 on, so I know they are fine - they charge a friend's SGS with no problems)
thatbloke83 said:
So last night I went from stock motorola 2.2 to this wonderful-seeming version of CyanogenMod on my UK milestone - the install went flawlessly, but now I have a problem - my battery is not charging at ALL.
While the phone was on last night after I charged it, it was plugged in, first to my PC and then to the wall socket. In both cases, the battery indicator had a ? (question mark) on it.
I thought it might have been some weirdness with battery calibration so I left it and plugged the phone in from the wall to charge overnight. This morning, my phone was telling me to connect my charger (despite it being plugged in) and on removing the power cable, it died due to no battery power left within 10 minutes.
While plugged in from the wall, the battery indicator comes up but again just contains a ? on it. The little white light next to the power socket never lights up.
If I plug the phone in to my PC via USB then if the handset is OFF, the white light comes on and around 10 mins later it gets enough juice to boot up. The problem is that when the CM7 software starts, the little white light disappears, the phone stops charging despite the cable being present, and it then dies 2 minutes later.
I know the battery is fine because it was perfectly fine before I installed CM7.
Anyone else experienced this problem and/or know how to fix it?
One thing I did manage to do before it died was install a battery calibration app that I found on xda-developers - this told me that the battery was running at 3267 mV - any idea if that's good or bad?
(and yes, I'm using precisely the same cable/charger I was using before I put this version of CM7 on, so I know they are fine - they charge a friend's SGS with no problems)
Click to expand...
Click to collapse
Try plugging the phone into the wall charger, without the battery. Try and boot it up and let it boot. Once it's booted up, give it a bit and try and put the battery in and leave it to charge.
What happens if you turn off you phone and plug it in a wall charger? If the problem isn't in your battery it will charge fully.
When you phone comes up, try to disable the 1% battery steps in settings. I got a problem with it, and after disabled/enabled it worked fine for me.
Hope this helps.
On plugging it into a wall charger, the phone comes up with its special battery charging screen (i.e. a fullscreen battery level indicator) - no amount of pressing the power button seems to get it to boot properly (with or without the battery).
I'll see if I can get in and get rid of the 1% steps thing later, thanks for the suggestion
afonsolage said:
What happens if you turn off you phone and plug it in a wall charger? If the problem isn't in your battery it will charge fully.
When you phone comes up, try to disable the 1% battery steps in settings. I got a problem with it, and after disabled/enabled it worked fine for me.
Hope this helps.
Click to expand...
Click to collapse
Dude, that was PERFECT.
Managed to get enough juice into the thing to get into the menu for a moment and was able to disable the 1% battery steps option - soon as I touch that tickbox, the battery indicator switches from a ? to the charging symbol and the phone starts charging. Thanks a million!
Nop dude, you are welcome
Hi, I need urgent help.
After running my battery down to less than 5% at a friend's house, I turned my phone off, took out the dried battery and plugged a full charged one in. However I cannot get it to turn on again.
If I plug it in (with the fully charged battery), it might either flash a battery icon on the screen then turns off. Or it could start normally (shows the battery is fully charged, but doesn't recognize it is plugged in). But as soon as I unplug the cable, the phone dies.
did anyone experience this problem before? Is this a hardware problem?
thanks
Hi. I have a Xperia Z c6603 that suddenly started to charge only when turned off. And even that, only sometimes.
If I have the phone turned on, and connect the USB cable, the phone won't detect it, so it won't charge. And won't even be detected by a PC with ADB. Also, trying to charge it by using the side golden contact won't help, neither.
If I have the phone turned off, and connect the USB cable, the phone will always detect the USB cable, the LED will go red, the screen will show the SONY logo, and then will show the battery icon with the current charge level. And then, sometimes it will start charging. But I will have to try to connect and disconnect the USB cable several times until, maybe, it would do it.
The USB port was replaced sometime ago, and it has been working with no hassle at all. I don't want to get a new battery delivered, if I'm not 100% sure that the battery is the problem.
Can be an electronic trouble with the charging circuit? Has anybody been in this very same situation?
Thanks all.