I installed a new preview update that bricked my phone - I'm stuck in a very early boot loop (Windows logo; never gets to the Samsung logo). Can I reflash using either Wolf's MBN creator or another tool?
See link below for tools and rom.
http://forum.xda-developers.com/windows-phone-8/development/taylors-super-rom-tool-dump-sgh-t899m-t3037789
Whoo you are my hero! Will download and flash tonight...fingers crossed everything works!
Related
I rooted my mums ace using this method. However I didn't install CWM, I just went straight ahead and stupidly installed the .zip straight from the recovery mode utility. I'm trying to install this ROM.
Now I'm stuck at this step and I think I may have softbricked it.... Youtube clip below:
http://youtu.be/gB-mfeePNRA
Basically it turns on, the sammy logo comes up and then it goes red and lines out. Then it just sits there with the backlight on.
I have a download jig at hand if I need it, so I can access download mode and I have the SD card to use.
Update: installed CWM through the .zip recovery file. i then installed the ROM above and it's now just stuck at the boot logo, with the cyanogenmod blue circle swirling around.
djdanster said:
I rooted my mums ace using this method. However I didn't install CWM, I just went straight ahead and stupidly installed the .zip straight from the recovery mode utility. I'm trying to install this ROM.
Now I'm stuck at this step and I think I may have softbricked it.... Youtube clip below:
http://youtu.be/gB-mfeePNRA
Basically it turns on, the sammy logo comes up and then it goes red and lines out. Then it just sits there with the backlight on.
I have a download jig at hand if I need it, so I can access download mode and I have the SD card to use.
Update: installed CWM through the .zip recovery file. i then installed the ROM above and it's now just stuck at the boot logo, with the cyanogenmod blue circle swirling around.
Click to expand...
Click to collapse
Did you factory reset in recovery?
Sent from my GT-S5830 using Tapatalk 2
Yep, it did nothing. I'm guessing that when I flashed the CM10 ROM it cleaned out the factory reset.
Ok, panic over!
I managed to get this ROM working.
Hello, I'm new here, so I don't know if I posted this in the right forum, but I have a big problem. So today I rooted my GT-N7000 and everything was fine, but then I replaced the digital clock with the digital clock of the Galaxy S4 (I found the apk here: http://forum.xda-developers.com/showthread.php?t=2208158) but something must have gone wrong because when I rebooted my Phone, I wasn't able to enter my PIN-Code, because my screen didn't respond anymore. Then I rebooted my Phone and it got stuck at the "Samsung" Screen. Every time I now reboot my phone it gets stuck there. When I rooted my Phone I did it by installing PhilZ 4.93.6 signed Kernel through stock recovery. So I went into recovery mode and did a factory reset. Then I rebooted my Phone and went trough the set up manager, but when I wanted to finish the set up manager my Phone shut down and restarted, then it got stuck on the Samsung Screen again.
Before rooting my phone was on stock ROM XXLT4.
Is there anything I can do to fix my Phone? Please, I need your help :/
Also: sorry for mistakes in my Post, but I'm from germany
You could install the rom again using odin. This will overwrite any bad flashed flashed during mod installation.
nokiamodeln91 said:
You could install the rom again using odin. This will overwrite any bad flashed flashed during mod installation.
Click to expand...
Click to collapse
Thanks for the advise It worked!
Hello,
I am having a problem, after rooting / unlocking, i have tried to install recovery using method given here: http://forum.xda-developers.com/showthread.php?t=1826378
I have boot the phone, install this recovery... boot recovery - then the problem came... it starts booting, LG logo is finished, start animation and stops... need to remove battery. The problem is that my version was 4.1.2. which ain't supported by this methog which i have seen to late.
I have tried to do everything LG User Support Tool, LG FlashTool, etc. - nothing helps.
Any idea? Is there a way to unbrick the phone - or it's finished? I have no ideas anymore.
Thank you in advance.
my phone stuck in samgung logo, i was in lolipop 5.0 then my phone bricked trying to flahs a custom recovery project bus i flash the stock room 4,4,2 and when star boot it stuck in samsumg logo. help me please
joaostanly said:
my phone stuck in samgung logo, i was in lolipop 5.0 then my phone bricked trying to flahs a custom recovery project bus i flash the stock room 4,4,2 and when star boot it stuck in samsumg logo. help me please
Click to expand...
Click to collapse
Not sure if this is what you're looking for. Tried flashing rooted 5.0 and got stuck on same screen. Try flashing this file using odin.
www(dot)androidfilehost.com(slash)?fid=23622183712464416
Youtube video where I found link: watch?v=VzqQw9PI7z0
Hi everyone,
I've had numerous problems with OTA updates with my AT&T SM-G900A since I got it. I'm not in the US anymore and my phone was unlocked, so I thought "hey, how hard could it be" and tried to flash it.
I used the following binaries that were posted here a couple of days ago: http://forum.xda-developers.com/att-galaxy-s5/general/g900aucs4cpa2-odin-files-em-hot-t3372388
I ran them through Odin3 3.09, and got a PASS - but the phone is stuck at the boot logo screen ("Samsung Galaxy S5 Powered by Android" screen).
Download mode still works, but normal booting, recovery booting and safe mode do not.
Any suggestions on what I could do?
EDIT: I used the stock image located here: http://forum.xda-developers.com/showthread.php?t=2714455 to reflash it using Odin again. It seems to have worked, though all sorts of apps were crashing. I've just done a factory reset and am in the process of restoring it, but it seems promising for now. Never trying to update AT&T crap again.
Hey man, are you still having troubles? I just rooted my Sm-G900A, and then decided to use Odin to flash it with the 5.1.1 files. So this is what happened to me:
1: Flashed AP with the 5.1.1 file, passed but stuck at the Samsung Logo- Powered by Android.
2: rebooted into download mode and flashed "BL" or Bootloader with the 5.1.1 file and I got passed that screen. Now I'm waiting for it to optimize my apps.
My guess is after we flash the AP file we then have to flash the bootloader as well. So if you haven't tried that I'd suggest it to see what happens.