Hello, My Moto G 2014 has a weird issue. Pressing the power button basically kills and shuts down the display. The display cannot be turned on by pressing the power again.
Turning on the phone also does NOT show the display.
Only way i can see the display again is -
power off the phone.
get to bootloader
select reboot option
Then phone turns on nicely.................... untill i hit the power button again, then display is dead again.
Last couple of days, i'm not even able to get the bootloader. I tried pressing the power + vol buttons but no use.
I cannot use the adb option as i cannot turn on the developer options on the phone without display.
Really appreciate any help. Thanks
Related
I used droid turbo normally for 3 weeks (but I am not joining the verizons as I bought from a friend who got it from verizon)
Yesterday, the screen was still, so I pressed power button.
But when I pressed again, it did not turn on as usual.
I pressed and hold, still not work.
So I did the rebooting by pressing the power button + volume down for 15 seconds.
Since then I tried many ways - recovery mode, back up data and reset factory setting and then reset all accounts...
The results are the same:
When the screen is off after idling it for several mins, i couldn't turn it on, and need to reboot it and after more than 10 mins (every time different time) after the droid word, it came to the front page.
And when it is turned on, the camera and phone dialling don't work.
What should i do?
Try the power button again. Press and hold for 30-seconds, then let go and see if it powers-up.
Dear Xiaomi Mi3 users,
I'm sorry if this question has been asked before.
Basically my touch screen is totally cracked and unresponsive. I need to replace my screen. I ordered a screen and repair kit from China, and it has arrived. However the instructions say that I should switch off my phone before attempting to replace the screen. The problem is, the screened is cracked and I can't press any buttons. Holding the power button for a long time simply reboots my phone, it doesn't shut it down.
What should I do???
Thanks!!
Dc
dc984 said:
Dear Xiaomi Mi3 users,
I'm sorry if this question has been asked before.
Basically my touch screen is totally cracked and unresponsive. I need to replace my screen. I ordered a screen and repair kit from China, and it has arrived. However the instructions say that I should switch off my phone before attempting to replace the screen. The problem is, the screened is cracked and I can't press any buttons. Holding the power button for a long time simply reboots my phone, it doesn't shut it down.
What should I do???
Thanks!!
Dc
Click to expand...
Click to collapse
1) when your phone reboots at that time press the volume up button , the phone will enter into recovery mode and from there you can turn of your phone without even touching your screen
2) you can plug in a PC Mouse t your phone sing a OTG cable and can access all the functions without touching the screen
ZenR2 said:
1) when your phone reboots at that time press the volume up button , the phone will enter into recovery mode and from there you can turn of your phone without even touching your screen
2) you can plug in a PC Mouse t your phone sing a OTG cable and can access all the functions without touching the screen
Click to expand...
Click to collapse
Thank you so much. So simple yet I wasn't able to figure it out!!
dc984 said:
Dear Xiaomi Mi3 users,
I'm sorry if this question has been asked before.
Basically my touch screen is totally cracked and unresponsive. I need to replace my screen. I ordered a screen and repair kit from China, and it has arrived. However the instructions say that I should switch off my phone before attempting to replace the screen. The problem is, the screened is cracked and I can't press any buttons. Holding the power button for a long time simply reboots my phone, it doesn't shut it down.
What should I do???
Thanks!!
Dc
Click to expand...
Click to collapse
After restarting, when you see the MI LOGO, hold power & volume down button, it will execute the fastboot and just wait for a second your phone will automatically shuts off.
dc984 said:
Thank you so much. So simple yet I wasn't able to figure it out!!
Click to expand...
Click to collapse
Is it not "Volume Up" and "Power Button"? iso just "Volume Up" button.
I just had to do this too.
Hold power button for ten seconds to reboot.
Immediately switch to power + volume up to get to fastboot
But the fastboot screen does not automatically shut down. And holding down the power button for ten seconds reboots again. And because of my broken screen, i can't see the fastboot menu.
In the end I plugged it into a computer, installed adb, and did adb shell and adb reboot -p (-p for poweroff)
Now, back to replacing my screen, being very careful not to press the power button this time.
Hi,
Today I had the same problem. Xiaomi Redmi 4x with broken screnn and I could not shut it down to replace its display. After a few tries I found the solution.
Just press Power button and Volume Down and DON'T RELEASE THEM UNTIL THE SMARTPHONE IS COMPLETLEY SHUTDOWN. After about 8 seconds the smartphone will reset . Don't release the Power and Volume Down buttons , wait and the smartphone will boot again in another mode. Continue to keep both buttons pressed and after about 10-15 seconds it will really shutdown.
Good luck!
my moto x 2014 display is broken ....it wont show anything just black screen but the phone still works ..i get messages ...since its on marshmellow
ill have to unlock it and change the usb options from charging only to media storage but display is broken and i cant do that however is there any way i could access the files through pc ..its not rooted but usb debugging is on and also its connected to the wifi ..i tried adb but it wont show any devices because the phone is on charging only mode ...is there anything i can do about this??? any help would be appriciated
Have you tried adb while the phone is at the bootloader? To get to the bootloader, turn off the phone, then press and hold the power button and the volume down button at the same time for about 5-7 seconds. Then release the power button, but continue to hold the volume down button for 3 more seconds. You should then be at the bootloader. I am not sure if adb will work then, but it's worth a shot.
Had a error saying that power monitor? (default app I assume, not downloaded) had stopped, dismissed the popup but it kept returning, i.e. couldn't do anything so held power button to force power off.
Nothing happens, have the power off, restart option window on screen but phone is locked up, no response.
Any method to restart or am I left waiting for the battery to run out?
Tried usb power connect/disconnect and removed sim tray but nothing.
Try this, http://www.hardreset.info/devices/nokia/nokia-8/
But you will loose data from your device
Sent from my Nokia 8 TA-1052 using Tapatalk
Thanks for reply. It won't power off, that is the problem, just frozen on the power menu, long pressing the power button does nothing.
Read this
http://nokiamob.net/2017/07/26/how-to-un-freeze-and-factory-hard-reset-nokia-android-devices/
Sent from my Nokia 8 TA-1052 using Tapatalk
Well bleeding hell! so they use two button combo for hard off rather than just the power button alone.
Time to cancell the return and the re-buy from elsewhere then... d'oh!
Cheers matey, very much appreciated.
Hi everyone,
I really need some help with my Mi 11. I was on FB Messenger when the screen suddenly shut off on its own. I've tried a bunch of stuff already but the screen refuses to turn back on, though I think the phone might still be on: I have Whatsapp Web on my computer and I can still send/receive messages: according to Whatsapp, the application doesn't work if your phone is off or does not have an internet connection. I've tried:
charging the phone
pressing and holding the power button for >30s
pressing and holding the power button and volume up for >30s
pressing and holding the power button and volume down for >30s
pressing and holding all three buttons for >30s
plugging the phone into my computer(computer did not recognize that the device was plugged in)
and after all of these, the phone still hasn't turned back on. Does anyone have any ideas as to how I might be able to fix it?
Do you have CN or global version? Was the device hot?