Hello boys and girls,
So I recently got me a CN Realme x2 pro and after much trouble I unlocked the bootloader. I updated to the latest firmware (RealUI2 F16) and installed TWRP 3.4 and as soon as I booted into recovery I made a full Nandroid backup. Then tried to boot back into system and I got into a bootloop. So I decided to install a custom ROM, since that was the original plan. After wiping the system in TWRP, I got some error about some partition, formated data, repaired it, formated to ext2 and back to ext4.
I tried LOS 17.1 , LOS 18.1 , crDroid 7.2 and AOSiP 11 . crDroid and AOSiP drop back into bootloader/recovery, both LOS are stuck at the boot animation (I waited for over 4 hours).
I also tried TWRP 3.6 (which is currently installed) and OrangeFox 11 (which results in the red error about destroyed boot/recovery). The strange thing is that when connected to PC, the phone mounts /data to PC instead of /storage (is that normal?)
Any idea?
Related
I'd like to install lineageOS, on muiu 8 now, twrp and rooted. When i was on muiu 7 twrp said system was encrytped, now it says its succesfully decrypted in twrp with default password. Can i now just flash normally the lineageOS zipfile from twrp or do i need additional steps to install it ?
My TWRP has said "Successfully decrypted" since MIUI 8 (can't remember what it said in MIUI 7)
I flashed Lineage after wiping system and it worked fine for me. Perhaps I got lucky though?
Hey Boys and girls,
I dont know why lineage os 14. 1 dont run on my s4active. Its a I9295.
First i installed twrp 3.1.1.0 recovery with heimdall 1.4.1 on ubuntu 16.04.
Then i flashed lineage-14.1-20171017-UNOFFICIAL-jactivelte from Sd Card in recovery mode
(with the same setup and method i flashed lineage os 14.1 on I9300 and I9500 without problems)
Next i can see lineage startscreen for hours
I tested it too with twrp 3.1.0.0 and two older builds of lineage 14.1. with and without gapps, everytimes I wiped Dalvik, System, Data, Internal Storage and Cache bevore flashing,
and wipe cache&Dalvik after flashing. Always whithout errors.
Thank you everybody and sorry for my scool english
Unfortunately I can't offer help, because I suffer from the exact same problem. Tried to flash tsvetkov_vlad's CM14.1 once some time back in spring already and the behavior has not changed since.
It remains stuck showing the boot animation and does not even arrive at the screen to input the encryption password.
There are no errors in the TWRP log.
Ok, I found the solution (for me). I stumbled accross some blog post claiming that most of the time when the boot animation shows infinitely long, there is a problem with mounting some partition. For me, that was /cache, which I had previously formatted as f2fs. After changing it back to ext4 again, booting works as expected. This has never been a problem with any of the older versions of CM I used before, though.
Maybe this helps?!
Oh yes this was the solution for me too.:fingers-crossed:
I had to formate /cache in f2fs then back in ext4 for four times.
Then booting was completely normal.
Longpu you have changed my live My gratitude will haunt you forever and ever
hi, i accidentally updated to miui10 global beta 8.7.12 (i thought is was stable since it got to the miui mix download page)
i am using twrp 3.2.1 with a mouse for upgrade (since that version have touchscreen issue)
and i can not upgrade with 3.0.2 smarty which i usually use it shows eror 7
after i have sucessfully upgraded to miui 10 global beta 8,7,12
i flash the 3.0.2 smarty twrp and then i realized it had 0mb internal
i just wanted my mi mix to be rooted and do NOT want the factory wipe (since i read that fixing the 0mb problem is to factory wipe)
i am using this phone for work and do not want to lose any data on this phone.
can anybody please give me a suggestion?
i am flashing the 3.2.1 twrp via fastboot
in my case, the twrp did not even ask for password, it just wouldnt read the internal.
does rolling back to miui 9 9.5.60 via flashboot will do the trick? because i tried to roll back once via system update to 9.6.10
at the first it had notification that my data would be lost(so i cancel itu). but when i try again, it recognise the official 9.6.10 as custom room.
update : i have upgraded to miui10 8.7.19 and flash with raupe-blunden 15.1 TWRP
the after the fasboot reboots to twrp, it works fine and the internal is fixed.
so i install superSU, and it worrks
BUT after reboot to system, the root is gone and the recovery reverts to stock miui recovery
since i have able to enter internal storage (even if it is only the first time)should i revert to miui9 9.5.60 (the last stable rom for nougat)? some say taht the oreo miui can not be roll back, it will brick your device
please advise,
warm regards,
ziggy
Each time you Run MIUI it will encrypt the device again.
Try installing the no-verity-opt-encrypt and try......
If u switch to a different ROM it doesnt encrypt the phone so hence allowing you to use the TWRP again.
I recommend the RR rom / Pixel ROM
I was running a custom ROM (Skydragon) earlier. I simply booted into TWRP, did the basic wipe then flashed the official zip file. Then after booting, its stuck on the boot animation for more than 20 minutes now. Any ideas how to resolve this?
I too faced the same issue. formating the data partition and flashing community beta build booted successfully for me. before you do this, completely back your phone contents to pc
You must flash with TWRP 3.2.3.0 or older!
i had the same issue. formated data had 3.3.0 twrp but still bootloop so i used unbrick tool to put my phone back to stock and then updated to last build though stock recovery and then unlocked bootloader, installed twrp, magisk and done.
Have a xiaomi mi8 with lineage os on it (official build) and twpr. Did have encryption working before but had to wipe the phone and lost all is and encryption and can't remeber for the life of me what twrp version I used to get encryption working and what steps I took to get there. I try encrypt the phone now and it gets stuck on lineage boot logo. Switch it off after hours of being on the lineage logo and get to twrp and it does not ask for a password but says it can't Mount my partition when j try browse file or factory reset (has to be format option to start again)
Any ideas what twrp version I need and what steps in what order I need to take to get encryption back