magician bootloader gone while ugrading bootloader - MDA III, XDA III, PDA2k, 9090 Software Upgrading

hi i am stuck now i think i hav destroyed bootloader of magician. i hav tried to upgrade bootloader 1.0 to 1.02 using pnewbootloader.exe. but i failed in that and got message protection found. now i cant reset and cant go into bootloader. magician is working perfectly in windows. no problem in connectiong to pc but reset and hard resents r not working. when i try to rest it just goes dead than i hav to take battery out for few mins and insert it back. cant go into serial mode.
is there any method to change the rom when i try to install new rom it never turns on after first reset from upgarde proggrame and than i get conbnection error. sd card methos is not working becoze no bootloader. it is under waranty but cant send it back to orange because i hav t mobile rom in it. plz help me to sort this out.

Related

Flashing ROM and SPL

Hello all,
first let me apologize for the long post, and my noobiness. I'm new to the smartphone world, I've sucessfully flashed my Kaiser (from work). Also, I would like to thank everyone who is cooking!
I have the HTC Mteor, which I'm trying to Flash to WM6.1.
When I got it (used), I did a hard reset, and it went back to WM5 in Russian.
I believe I successfully unlocked it, and can now get to the tri-color screen.
It reads:
BBEE100
IPL-0.90
BREE100
SPL-2.05
Every ROM (including the original from HTC) opens, forces the phone to the tri-color screen, and then dies. Error 260, 262, etc.
I've searched the forums, and read that the SPL should be 1.10, but I can't get that to install either.
Any help/suggestions?
Thanks,
Jeff
jjmorris100 said:
Hello all,
first let me apologize for the long post, and my noobiness. I'm new to the smartphone world, I've sucessfully flashed my Kaiser (from work). Also, I would like to thank everyone who is cooking!
I have the HTC Mteor, which I'm trying to Flash to WM6.1.
When I got it (used), I did a hard reset, and it went back to WM5 in Russian.
I believe I successfully unlocked it, and can now get to the tri-color screen.
It reads:
BBEE100
IPL-0.90
BREE100
SPL-2.05
Every ROM (including the original from HTC) opens, forces the phone to the tri-color screen, and then dies. Error 260, 262, etc.
I've searched the forums, and read that the SPL should be 1.10, but I can't get that to install either.
Any help/suggestions?
Thanks,
Jeff
Click to expand...
Click to collapse
install this official rom from HTC
http://rapidshare.com/files/66085556/RUU_BREE100_1.34.261.1_1.38.00.10_HTCRUS_SHIP.exe
Its for RUS QTEK_AO7.
Then you will have SPL 1.10
I have similar problem
I had ROM 6.1 from Futureshock...still problem with radio (my phone couldn´t accessble but signal icon shows good signal, radio version 1.38.0000), so I decided flash some original ROM. Aftet that my booting stuck on HTC logo or Windows Mobile logo. So I can´t use normal way to flashing. Only from SD card or first turn on phone to boot loader mode and than attach usb cable and start flashing. From SD card (where is renamed ROM BREEIMG.NBH) after enter into bootloader mode start loading and than just turn to trhreecolour menu where is BREE100 - IPL-0.90 and BREE100-1.10.0000 and doesn´t want continue. If I flash ROM via USB cable (first go to threecolour mode, than attach cable) than run ROMUpdateUtility.exe and flash process is being started but always die on 2%, than autoreboot and again stuck on HTC logo.
I tried soft reset, I tried lot of ROM versions HTCRUS, HTCEUR, QTEKEUR, FUTURESHOCK but still same problem during flash ROM stop on 2%...
Any ideas how to back life to my MTeoR?
Can I use application like MTTY? Could me help this program?
Thanks for any help...
hi, can any1 send me a link for a ger version of wm6.0pro ?
Wigo said:
I had ROM 6.1 from Futureshock...still problem with radio (my phone couldn´t accessble but signal icon shows good signal, radio version 1.38.0000), so I decided flash some original ROM. Aftet that my booting stuck on HTC logo or Windows Mobile logo. So I can´t use normal way to flashing. Only from SD card or first turn on phone to boot loader mode and than attach usb cable and start flashing. From SD card (where is renamed ROM BREEIMG.NBH) after enter into bootloader mode start loading and than just turn to trhreecolour menu where is BREE100 - IPL-0.90 and BREE100-1.10.0000 and doesn´t want continue. If I flash ROM via USB cable (first go to threecolour mode, than attach cable) than run ROMUpdateUtility.exe and flash process is being started but always die on 2%, than autoreboot and again stuck on HTC logo.
I tried soft reset, I tried lot of ROM versions HTCRUS, HTCEUR, QTEKEUR, FUTURESHOCK but still same problem during flash ROM stop on 2%...
Any ideas how to back life to my MTeoR?
Can I use application like MTTY? Could me help this program?
Thanks for any help...
Click to expand...
Click to collapse
I'm not sure that I understand well, but if you flash from SD, it finish in 100% and than go to three color boot screen? ....
Hi alebo caf Vašek ;-)
My problem is that always stuck on boot image HTC or Windows Mobile blue screen. I can´t use way copy necesseary files to root of phone memmory and than run sspl etc...I have to turn manualy to three-color mode, than connect USB cable and run upgrade utility but still froze instalation on 2%, If I use SD card methode with BREEIMG file uploading doesn´t start....
p.s.: Ak by si mal dáku radu tak možno lepšie vysvetliť po česky ;-). Moje ICQ 208-393-971
Dík
CZ Rom
I would like to install new ROM into my Mteor, but I have no experience doing it. I do not know which version to try, all I need is to be able to enter czech letters on HW keyboard as with original ROM. Any sugestion? I preffer personal answer in czech language ([email protected])

help help help !!!!!! bad flash/unlocker

iv had the elegance rom on my p3600 running perfect so try'd to unlock the phone to half way through it disconected from usb and rebooted but will only go as far as start up i love this phone and want it back the way it was any help please
havent u installed hard spl first?
if not...that could be a problem!
if u did just press the camera+power+soft reset buttons to enter the bootloader and install everithing again...see if that works!
(if i am wrong just correct it)
do have boot loder or spl-9.99.cp?????
whatever i put on just gets stuck on boot loader screen ???

Need some expert help,

So today i tried updating my Three locked Xperia X1i, Donwload went fine but it decided to crash half way through installing the update and is now stuck on that Colourfull Lined Screen. saying "upgrade ROM code error" Now ive tried restarting the download and the updater says it cant read the phone and wont do anything! can someone please help on the situation.
Providing you HardSPL'd first just get yourself a KOVSIMG.NBH file (for the XPERIA, I recommend Sutyi's SECOND ROM) put it on your microSD card and start up in boot loader mode. You can search how to start in boot loader mode easily enough.
I havent HardSPL'd, I just bought the Xperia and thought i should officially update it, Didnt know it would cause this. there should be some easy fix to it.

help needed please with possible brick fixed:D

hello all
yesterday i wanted to flash a friend tp2
when i flashed it it went to 100% and then it gave a rom code error
i restarted the phone in bootloader to flash a other rom and it wanted to read the image on the sdcard
wich resulted in red serie of digits on top of the screen 00058002
and the phone turned off
i deleted the image from the sdcard and tried it again
i came in bootloader and i saw threu the spl text rom upgrade error
now everytime i enter bootloader it turns off the phone in 5 sec
i managed to run a task 29 one time by resetting the phone multiple times
can some one help me
owww its not fixed
i managed to get stock rom on it again but during the custimizsation the phone turned off:S
and now i have the same problem again
edit: i dont know how but its fixed

[Q] htc hd7 firmware update gone wrong

I recently tried to update HTC HD7 firmware after a hang issue. I had hard reset the phone and the phone now boots in bootloader mode. I cannot exit the bootloader mode. Also, I may have tried flashing the device with RUU_Schubert_hTC_Asia_WWE_2.20.841.02_Radio_5.65.09.11a_22.44.50.15_NoDo
When the ROM version of the phone is 2250.09.12302.707. Now my phone is unusable. It starts in bootloader mode any attempt to flash it with other 707 ROMs RUU_Schubert_hTC_Asia_WWE_1.57.707.02_Radio_5.52.09.16_22.33a.50.10_Signed_SCHUBERT_RELEASE fails with a update error 270: saying the ROM file is corrupt please help. My phone is unbranded.
Thanks,
Please help
The windows phone support tool 'might' be able to help you out here.
://support.microsoft.com/kb/2530409
Unfortunately as a noob to the forums I can't post links. Add http to the above to make it into a link.
I had the same problem, but i managed to solve!!!
Invert the flash order from this thread: http://forum.xda-developers.com/showthread.php?t=1000520
Flash b2 (big one) first and ignore the error then flash b1 (small one) and the phone will boot
Now guys my phone is toast. It does not work beyond the bootloader mode. I tried flashing the device but the process gets stuck at 0%. I tried formatting the SD card but the same tricolor boot screen appears. What the hell has gone wrong? Anyone who can help me thanks a million. I would really appreciate it.
did you try flashing one of these 707 roms ?
http://forum.xda-developers.com/showthread.php?t=888747&page=20
if u stuck in bootloader mode, pull out the battery , and install it back again
It could be a faulty USB port during the flash process. Try another USB port.

Categories

Resources