iv had the elegance rom on my p3600 running perfect so try'd to unlock the phone to half way through it disconected from usb and rebooted but will only go as far as start up i love this phone and want it back the way it was any help please
havent u installed hard spl first?
if not...that could be a problem!
if u did just press the camera+power+soft reset buttons to enter the bootloader and install everithing again...see if that works!
(if i am wrong just correct it)
do have boot loder or spl-9.99.cp?????
whatever i put on just gets stuck on boot loader screen ???
Related
hi i am stuck now i think i hav destroyed bootloader of magician. i hav tried to upgrade bootloader 1.0 to 1.02 using pnewbootloader.exe. but i failed in that and got message protection found. now i cant reset and cant go into bootloader. magician is working perfectly in windows. no problem in connectiong to pc but reset and hard resents r not working. when i try to rest it just goes dead than i hav to take battery out for few mins and insert it back. cant go into serial mode.
is there any method to change the rom when i try to install new rom it never turns on after first reset from upgarde proggrame and than i get conbnection error. sd card methos is not working becoze no bootloader. it is under waranty but cant send it back to orange because i hav t mobile rom in it. plz help me to sort this out.
Hello all,
first let me apologize for the long post, and my noobiness. I'm new to the smartphone world, I've sucessfully flashed my Kaiser (from work). Also, I would like to thank everyone who is cooking!
I have the HTC Mteor, which I'm trying to Flash to WM6.1.
When I got it (used), I did a hard reset, and it went back to WM5 in Russian.
I believe I successfully unlocked it, and can now get to the tri-color screen.
It reads:
BBEE100
IPL-0.90
BREE100
SPL-2.05
Every ROM (including the original from HTC) opens, forces the phone to the tri-color screen, and then dies. Error 260, 262, etc.
I've searched the forums, and read that the SPL should be 1.10, but I can't get that to install either.
Any help/suggestions?
Thanks,
Jeff
jjmorris100 said:
Hello all,
first let me apologize for the long post, and my noobiness. I'm new to the smartphone world, I've sucessfully flashed my Kaiser (from work). Also, I would like to thank everyone who is cooking!
I have the HTC Mteor, which I'm trying to Flash to WM6.1.
When I got it (used), I did a hard reset, and it went back to WM5 in Russian.
I believe I successfully unlocked it, and can now get to the tri-color screen.
It reads:
BBEE100
IPL-0.90
BREE100
SPL-2.05
Every ROM (including the original from HTC) opens, forces the phone to the tri-color screen, and then dies. Error 260, 262, etc.
I've searched the forums, and read that the SPL should be 1.10, but I can't get that to install either.
Any help/suggestions?
Thanks,
Jeff
Click to expand...
Click to collapse
install this official rom from HTC
http://rapidshare.com/files/66085556/RUU_BREE100_1.34.261.1_1.38.00.10_HTCRUS_SHIP.exe
Its for RUS QTEK_AO7.
Then you will have SPL 1.10
I have similar problem
I had ROM 6.1 from Futureshock...still problem with radio (my phone couldn´t accessble but signal icon shows good signal, radio version 1.38.0000), so I decided flash some original ROM. Aftet that my booting stuck on HTC logo or Windows Mobile logo. So I can´t use normal way to flashing. Only from SD card or first turn on phone to boot loader mode and than attach usb cable and start flashing. From SD card (where is renamed ROM BREEIMG.NBH) after enter into bootloader mode start loading and than just turn to trhreecolour menu where is BREE100 - IPL-0.90 and BREE100-1.10.0000 and doesn´t want continue. If I flash ROM via USB cable (first go to threecolour mode, than attach cable) than run ROMUpdateUtility.exe and flash process is being started but always die on 2%, than autoreboot and again stuck on HTC logo.
I tried soft reset, I tried lot of ROM versions HTCRUS, HTCEUR, QTEKEUR, FUTURESHOCK but still same problem during flash ROM stop on 2%...
Any ideas how to back life to my MTeoR?
Can I use application like MTTY? Could me help this program?
Thanks for any help...
hi, can any1 send me a link for a ger version of wm6.0pro ?
Wigo said:
I had ROM 6.1 from Futureshock...still problem with radio (my phone couldn´t accessble but signal icon shows good signal, radio version 1.38.0000), so I decided flash some original ROM. Aftet that my booting stuck on HTC logo or Windows Mobile logo. So I can´t use normal way to flashing. Only from SD card or first turn on phone to boot loader mode and than attach usb cable and start flashing. From SD card (where is renamed ROM BREEIMG.NBH) after enter into bootloader mode start loading and than just turn to trhreecolour menu where is BREE100 - IPL-0.90 and BREE100-1.10.0000 and doesn´t want continue. If I flash ROM via USB cable (first go to threecolour mode, than attach cable) than run ROMUpdateUtility.exe and flash process is being started but always die on 2%, than autoreboot and again stuck on HTC logo.
I tried soft reset, I tried lot of ROM versions HTCRUS, HTCEUR, QTEKEUR, FUTURESHOCK but still same problem during flash ROM stop on 2%...
Any ideas how to back life to my MTeoR?
Can I use application like MTTY? Could me help this program?
Thanks for any help...
Click to expand...
Click to collapse
I'm not sure that I understand well, but if you flash from SD, it finish in 100% and than go to three color boot screen? ....
Hi alebo caf Vašek ;-)
My problem is that always stuck on boot image HTC or Windows Mobile blue screen. I can´t use way copy necesseary files to root of phone memmory and than run sspl etc...I have to turn manualy to three-color mode, than connect USB cable and run upgrade utility but still froze instalation on 2%, If I use SD card methode with BREEIMG file uploading doesn´t start....
p.s.: Ak by si mal dáku radu tak možno lepšie vysvetliť po česky ;-). Moje ICQ 208-393-971
Dík
CZ Rom
I would like to install new ROM into my Mteor, but I have no experience doing it. I do not know which version to try, all I need is to be able to enter czech letters on HW keyboard as with original ROM. Any sugestion? I preffer personal answer in czech language ([email protected])
Hello all,
as the title says, one of my touch diamond's is stuck in bootloader screen.
I didnt do anything in between it working and not working, it was on my desk, put it there working, got it 5mins later, and it was in bootloader screen (tricolor screen).
What i've already done to try and fix it:
flash it with the original HTC rom, flash completes succesfully, phone reboots to tricolor screen, so no solution there.
install mtty and format the phone, this completes, reboot the phone, again goes to the bootloader.
reflash the phone with original rom after cleaning it with mtty, flash again completes succesfully but when it reboots after flashing it just goes to bootloader again.
Tried to flash a Hardspl: stuck at 0% and stays there. so that doesnt work.
BUT! when in mtty i give the "boot" command, it DOES start to boot WM. but then again, when i turn the phone of, and on again, or it reboots because of first start after flash, it goes to bootloader again. The VOLDOWN button is NOT stuck, cause when it boots i can use the vol buttons perfectly fine.
Anyone got an suggestion in how to unbrick it? i have a second, perfectly working diamond here too, if that helps in any way.
Some more info ive just seen in mtty, when i told it to boot, it said ONE BAD BLOCK IN CE, remove block ---- to ---- (dont know the exact numbers anymore)
hi..i had something like that...
just download this.
"RUU_Signed_1_93OliNex_HSPL_UnsignedEdition"
it's only 1.7MB and it's will make it work.. atleast it did the job for me...
Hi,
My T mobile touch diamond stuck in bootloader screen? Any experties to help me please.
Thanks in advance.
Hi i get one HTC Touch Diamond blocked on XDP Diamond Logo,i try to reset with hard reset but i cant put in reset mode,so have any method to reflash because i'm new with HTC Phone thanks
Your only solution seems to be flash a new rom.
This guide should help you do just that.
Make sure your device is at the bootloader screen and connected to your computer before you run any of the executables. To boot it in the bootloader screen just turn the device on while holding the volume down button. Then enter the usb cable when the word 'Serial' appears on the screen and open the ROMUpdateUtility executable when the word 'USB' replaces 'Serial'.
Goodluck! Make sure to flash the Hard Spl first if you have never flashed a custom from before. There is no need to flash a radio, so you can skip that step if you want.
Goodluck and be very careful!
EDIT: If you have some problems or questions about the process or anything send me a message! Because if you post it here I probably won't see it.
I recently tried to update HTC HD7 firmware after a hang issue. I had hard reset the phone and the phone now boots in bootloader mode. I cannot exit the bootloader mode. Also, I may have tried flashing the device with RUU_Schubert_hTC_Asia_WWE_2.20.841.02_Radio_5.65.09.11a_22.44.50.15_NoDo
When the ROM version of the phone is 2250.09.12302.707. Now my phone is unusable. It starts in bootloader mode any attempt to flash it with other 707 ROMs RUU_Schubert_hTC_Asia_WWE_1.57.707.02_Radio_5.52.09.16_22.33a.50.10_Signed_SCHUBERT_RELEASE fails with a update error 270: saying the ROM file is corrupt please help. My phone is unbranded.
Thanks,
Please help
The windows phone support tool 'might' be able to help you out here.
://support.microsoft.com/kb/2530409
Unfortunately as a noob to the forums I can't post links. Add http to the above to make it into a link.
I had the same problem, but i managed to solve!!!
Invert the flash order from this thread: http://forum.xda-developers.com/showthread.php?t=1000520
Flash b2 (big one) first and ignore the error then flash b1 (small one) and the phone will boot
Now guys my phone is toast. It does not work beyond the bootloader mode. I tried flashing the device but the process gets stuck at 0%. I tried formatting the SD card but the same tricolor boot screen appears. What the hell has gone wrong? Anyone who can help me thanks a million. I would really appreciate it.
did you try flashing one of these 707 roms ?
http://forum.xda-developers.com/showthread.php?t=888747&page=20
if u stuck in bootloader mode, pull out the battery , and install it back again
It could be a faulty USB port during the flash process. Try another USB port.