Stuck in Bootloader screen - Touch Diamond, MDA Compact IV General

Hello all,
as the title says, one of my touch diamond's is stuck in bootloader screen.
I didnt do anything in between it working and not working, it was on my desk, put it there working, got it 5mins later, and it was in bootloader screen (tricolor screen).
What i've already done to try and fix it:
flash it with the original HTC rom, flash completes succesfully, phone reboots to tricolor screen, so no solution there.
install mtty and format the phone, this completes, reboot the phone, again goes to the bootloader.
reflash the phone with original rom after cleaning it with mtty, flash again completes succesfully but when it reboots after flashing it just goes to bootloader again.
Tried to flash a Hardspl: stuck at 0% and stays there. so that doesnt work.
BUT! when in mtty i give the "boot" command, it DOES start to boot WM. but then again, when i turn the phone of, and on again, or it reboots because of first start after flash, it goes to bootloader again. The VOLDOWN button is NOT stuck, cause when it boots i can use the vol buttons perfectly fine.
Anyone got an suggestion in how to unbrick it? i have a second, perfectly working diamond here too, if that helps in any way.

Some more info ive just seen in mtty, when i told it to boot, it said ONE BAD BLOCK IN CE, remove block ---- to ---- (dont know the exact numbers anymore)

hi..i had something like that...
just download this.
"RUU_Signed_1_93OliNex_HSPL_UnsignedEdition"
it's only 1.7MB and it's will make it work.. atleast it did the job for me...

Hi,
My T mobile touch diamond stuck in bootloader screen? Any experties to help me please.
Thanks in advance.

Related

WM5-Device Will Not Load Operating System

I am having a problem that I hope someone can help me with.
I have an SX-66 with WM5 on it. The other day the device suddenly stopped booting. I can get the device to turn on, soft-reset, hard reset and get into bootloader mode, but whenever I try to boot the operating system it gets stuck on the colored stripe boot screen and just sits there showing the version numbers and nothing else. I have followed the instructions on the Wiki for downgrading but I still have the same problem. I have tried draining the battery fully and recharging but still no dice. I am even able to reflash the device with my laptop and it says it succeeds with the up/downgrade but then it just gets stuck again. If I try to install a 1.40 the device says that the flash is successful but then WM5 tries to boot again and I am stuck at the striped screen.
Can someone please help me out? Do I have a brick?

HELP!!! please!!! stuck in bootloader

I have been flashing roms to my rhodium with no problem. However, recently i reseted my phone and when it turned back on it was in bootloader moder(the tricolor screen) It stays in this screen no matter what I do. I have tried: removing the battery and putting it back on, flashing other roms, flashing stuck rom, and nothing it alway goes back to the bootloader screen. I flash using the sd card method and it goes thru the process of flashing(with the percent bar) It completes the process then i soft reset and back to bootloader!. same thing via usb, it completes the process but then it goes back to bootloader. I am desperate, Please HELP!

My G1 will only boot up sometimes showing up the screen???

I have never encountered this issue... have been flashing roms for years.. on my windows phones and my G1 since it was possible..
The other day I went up update my phone to the latest CM ROM.. my phone finished and then I booted up the phone.. the screen was black.. i waited for a long time and not even the G1 screen showed up..
I booted again.. and same thing.. i booted again for days and tried getting into the recover with no luck..
I read someone had a simliar issue on here and they went into recover (though no screen or text shows up on screen) and proceded to hit alt w to wipe..i did that aswell and the next boot up the G1 screen showed up. I then did a complete wipe from there and began to install the new HTC recover and CM rom from scratch.. then same thing happend.. i kept getting the black screen...
I then tried to install the original SPL and install the original G1 rom and start all over.. i was able to install the original SPL (which I think is part of the issue) and then turned off the phone.. I placed the dreaimg in the sdcard and went to hit CAMERA and POWER.. and nothing shows up..
I can't for how many times i tried am able to get the phone to go into the install screen from holding down CAMERA and POWER..
I am able to restore the phone using the nanback up from the recover but since I installed the SPL it went away.. not sure if they are connected somehow.. so now i don't have those options either..
Can somebody help me with some ideas on how to fix this?
If you can't get into recovery? To me it looks like a brick phone.
As far as been here and read some post about not able getting into recovery or tri color screen not working as well and not getting any response from phone
ilostchild said:
If you can't get into recovery? To me it looks like a brick phone.
As far as been here and read some post about not able getting into recovery or tri color screen not working as well and not getting any response from phone
Click to expand...
Click to collapse
I am able to get to the Amon Ra recovery.. and do things from there.. the problem is that when I reboot..it sometimes shows up the G1 and sometimes it stays black..
I tried reverting back to the original ROM by putting the dream on there at that point i noticed that when hold camera and power nothing happens..im' still able to reboot and go into Amon Ra recovery though..
Just an update.. i noticed that my phone only boots up properly if I slide out the keyboard before I press the power button to turn on the phone.. same thing applies when getting out of standby mode while the phone is on...

[Q] HTC sprint diamond will not boot past splash

Hi, I have an htc touch diamond that will not boot past the splash. It turns on, says htc diamond without red letters. I have tried soft reset & hard reset, doesnt work. also phone does not turn on by power button but only the reset button. Every time I try to flash or unlock it says "Error 262", I've tried soft reset and continuing the setup and the error comes up again. I've tried the whole thing of changing the driver from 2007 to 2003 and completed it and still has not fixed error 262. I've tried many different roms and the only ones that bypass 262 are the .exe file rom setups, but after installed still doesnt boot past splash screen. the farthest ive gotten with one .exe is going through the phone setup, but after the setup the phone turns off. the only way my computer notices the phone and the way i flash the phone is when it is in bootloader. have also tried the bootloader where you press the back button. I've been trying so hard to fix this phone but it just wont happen. please help?
ryan21x5 said:
Hi, I have an htc touch diamond that will not boot past the splash. It turns on, says htc diamond without red letters. I have tried soft reset & hard reset, doesnt work. also phone does not turn on by power button but only the reset button. Every time I try to flash or unlock it says "Error 262", I've tried soft reset and continuing the setup and the error comes up again. I've tried the whole thing of changing the driver from 2007 to 2003 and completed it and still has not fixed error 262. I've tried many different roms and the only ones that bypass 262 are the .exe file rom setups, but after installed still doesnt boot past splash screen. the farthest ive gotten with one .exe is going through the phone setup, but after the setup the phone turns off. the only way my computer notices the phone and the way i flash the phone is when it is in bootloader. have also tried the bootloader where you press the back button. I've been trying so hard to fix this phone but it just wont happen. please help?
Click to expand...
Click to collapse
If this happens, you can just soft-reset the device and run RUU again. The update process will then continue.
Note: At this stage, the Wince is destroyed; instead, it is in upgrade mode.
for official rom you can find at http://www.shipped-roms.com/index.php?category=windows mobile&model=Diamond

Stuck on HTC Splash Screen

I'm able to flash this to any rom but it just keeps getting stuck at the htc splash screen. I tried all stock tmob roms and DeepShining's rom and always the same, hung at the splash. Any suggestions would be greatly appreciated.
Thanx in advance.
What does your screen say when you enter bootloader mode?
xdrc45 said:
What does your screen say when you enter bootloader mode?
Click to expand...
Click to collapse
Every time I was able to enter boot loader mode and flash to the appropriate bl depending on upon the rom. Even when I ran the dft xspl install and launch exe's and then loaded DeepShining rom it hung on the DS splash screen.
Update:
Turned out to be a hardware problem. Tore the phone apart and it seems the camera button was the problem.
Lol...looks like you figured it out before I could suggest that, it seems to be a problem with the hd7 camera button getting stuck and not allowing the rom flash to complete. Glad you figured it out though!

Categories

Resources