Cannot access EDGE after 2.16 ROM upgrade - 8125, K-JAM, P4300, MDA Vario Software Upgrading

Well after I upgraded my ROM to 2.16 and applied the Cingulcustomize_No_Emails.cab I no longer connect to the EDGE network... ideas?
Well at least the G icon doesnt change to E?

you have to apply a reg tweek to get the E icon if you use the imate rom..just search for it and you shall find it in this forum

Reg Hack just changes the icon....EDGE Modem is there in built and if u hv sunscribed to the services...u will automatically get the EDGE speeds even if u get G instead of E

I have a QTek 9100 and using 2.16 IMate and Cingulcustomize_no_email.cab I have the "E" without doing anything else other than adding isp.cingular to my ISP settings. The issue now is that the Cingulcustomize cab adds the wap settings needed for MEdiaNet which doesn't work after adding your ISP settings. I can live without MEdiaNet.

Related

Internet Problems On The 2.26 ROM(Please Help)

I just upgraded from the stock ROm to the 2.26 ROM and everything's cool(even though it's damn near the same to me) but for some reason I can't connect to the net at all. I'm thinkin maybe it's because I'm a Cingular customer and have a T-Mobile ROM. Are there any .cabs that can help with this or something, any help would be appreciated.
Also is there any way to make all connections Cingular connections and not T-Mobile
You have to manually enter cingular's wap settings and all that in start/settings/connections tab/connections. you shouldve soft reset your device before tmobiles customizations began to install. its a shame cingular doesnt offer their customers with updated roms as often as t-mobile does. call cingular and they'll give you all their connection settings.

T-Mobile MDA 2.26 Upgrade -- Roaming?

Hey Guys,
I've upgraded my MDA to the latest firmware from T-Mobile and did the soft-reset trick to avoid the installation of the T-Mobile extended rom junk.
The phone works great but it says that it is roaming even though I'm on my home network. It never did this on the old rom. FYI... the phone is unlocked and is being used on the Rogers network in Canada (which is my home network and where the SIM is registered).
Any ideas?
- Tatusmi
roaming update
Well I've made phone calls to Rogers and T-Mobile and here's the verdict.
The phone is not actually roaming, there is no roaming charges applied, the SIM card still knows where it is; however, the new ROM from T-Mobile is a USA based rom and it makes the phone think it's not on it's home network and therfore display the roaming icon.
Fortunatly, a bug in WISBar hides the icon most of the time so I guess I'll just live with it. If anyone has a solution to get rid of the icon I'd love to hear it though.
- Tatusmi
Although I'm a T-Mo USA customer, my MDA always showed roaming as well (without the extended ROM to disable it) because my SIM is from T-Mo's predecessor, "Voicestream" which had a different MNC.
To fix it, use a registry editor and change \HKLM\Drivers\BuiltIn\RIL\DisableRoamingIndicator to "1" and the roaming icon is disabled.
elecconnec said:
To fix it, use a registry editor and change \HKLM\Drivers\BuiltIn\RIL\DisableRoamingIndicator to "1" and the roaming icon is disabled.
Click to expand...
Click to collapse
If I disable the icon, will it show up when the phone actually is roaming?
Also, you mentioned without the tmo extended rom software to disable it... will this work correctly with the addition of the tmo ext rom? Is there a .cab we can extract to run on it's own?
- Tatusmi

Rogers+GPRS+xdaIIs+AKU 3.5v2 R5

Hello,
I can't seem to get my GPRS working with my xdaIIs. I am on the Rogers network. I have the AKU3.5v2 R5 Xplode Rom version and the 1.15 Radio Rom. I have tried all settings and a combination of the settings. I found CABs by a forum member named Lurch, and they didn't work. Everytime it just says "the answering modem has disconnected" I do see the little "G" with the signal bars but that goes away after a few seconds. My eyes have become buggy from reading forum post after forum post. PLEASE HELP!!!!!
Does GPRS works for you with different phone? Have you activated GPRS at your OP's network? In short words: No letter G on top of the screen = no GPRS connection possbile (Op is not offering such service: at all or just for you).
I have a data plan with Rogers. My xda IIs shows the "G" at the top of the screen. Today i tried a new older radio rom just for fun and still no luck. I have a nokia phone that i can browse the internet with. ANy ideas???
well...i think u should look up your the website of ur SP...in my case there are standard gprs setting for the whole network...i mean, there is a gateway, pass, username etc...and it isn't much fuss with a common nokia, but with the BA, i had to define a new modem connection with all the parameters given...so check the Rogers website for more information...anyway in some cases they send such sms that will configure your phone, but i think only for nokia, ericcson etc...
Try the following, I had it working before with Rogers (but I didn't have data plan, so the GPRS ate up all my money in pay-as-you-go, so I removed the setting), those hourly weather update from SPB do add up on data transfer.
Name : Rogers
Homepage: www.mymobilehomepage.rogers.com
Service Type 1: WAP
Gateway IP 1: 208.200.067.150 OR 172.025.000.107
GPRS APN: GOAM.com
User Name: wapuser1
Password: wap
Where do i put that information in. I can't find any places to put in the gateway info.I made a cellular connection (GPRS) then added the APN internet.com. Then the user pass wapuser1 and wap. But it will connect with the "g" and show the bars. then it will say "the modem has disconnected" I don't know what can be going wrong.

Cant get edge On Diamond only GPRS in US

Hey guys Just picked up the Diamond
I cant seem to get the E icon only G. which I believe is for GPRS. I know At&t 3g wont work but i thought @ least edge would
I tried the stock rom and the elite Rom still same issue
I have manually input the media net settings
wap.cingular
[email protected]
CINGULAR1
the isp.cingular setting wont work for me
Im located in 21117 zip if that helps & my blackjack gets a 3g signal and my Iphone gets the Edge signal from same location
GPRS is hella slow DSL reports have me @ 39kbit/sec please help!
Are you sure EDGE is running the 1900Mhz frequency in that area? Your other phones may be locking onto 850Mhz which may support Edge, but 1900 may not.

TyTN II Data connection problem.

I have a TyTN II that was on Hutchinson 3G UK, my dad had it unlocked (although I could have done it simply using tools here, but I'm not sure how he had it done, SPL was stock when I checked etc).
Anyway, I have HardSPL and flashed the TPC Elite V11 MEGA Manila Only.
I upgraded the radio to 1.71.09.01, protocol version 25.75.40.02.eMoH.
I can't seem to get any data connection at all, I just get the sync arrows with a cross.
I'm not sure if the problem is due to some software, or if it is because the device is from the Hutchinson 3G network, I have looked through the WiKi and FAQ and most things point to American providers and are of no help.
Any suggestions or help would be appreciated.
Thanks
Have you ran Connection Setup?
Yeh, iv just downgraded from an xperia so that was the first thing i checked. im in.a diferent area now with full hsdpa and no problems, just wont work in a gprs or 3G area.
further ideas? thanks
I had issues with connectivity with the default connection setup and 3g. Not sure if it's related or not but I installed the htc connection wizard and it corrected any network misconfigurations. I can upload that cab in a bit if you are interested. in giving it a shot (unless thats the setup you have already used)

Categories

Resources