I did the search, but not finding anything...Thanks for the help
Not sure what you want... but you can go to Start...Setings....System and choose CLEAR STORAGE and that will give you a hard reset as far as whiping data.
austinsnyc said:
-Enter Bootloader mode: Hold Camera + Power buttons together and reset with stylus(thanks pof)
-HardReset: Hold Both soft keys in while pushing in Reset button :When prompted push Green Talk Button to clear data.
Click to expand...
Click to collapse
This is the information I found... bu t I HAVE NOT been able to get my Tilt to Hard Reset from pushing any combination of buttons...
But this does work...
grizzley said:
you can go to Start...Setings....System and choose CLEAR STORAGE and that will give you a hard reset as far as whiping data.
Click to expand...
Click to collapse
Ron
I know this already. I am looking for combination of bottons + reset. As press softkeys + reset for 8525...etc
grizzley said:
Not sure what you want... but you can go to Start...Setings....System and choose CLEAR STORAGE and that will give you a hard reset as far as whiping data.
Click to expand...
Click to collapse
Don't forget about your good friend, WIKI.
I hard reset a TILT that was locked up after installing Blackberry connect to SD card (known issue). Hold down the two soft keys, then use the stylus to press the reset button for a few seconds, then release while still holding in the soft reset buttons. The warning message comes on, and as said earlier, use the green send key to initiate the data wipe.
Jim_R said:
I hard reset a TILT that was locked up after installing Blackberry connect to SD card (known issue). Hold down the two soft keys, then use the stylus to press the reset button for a few seconds, then release while still holding in the soft reset buttons. The warning message comes on, and as said earlier, use the green send key to initiate the data wipe.
Click to expand...
Click to collapse
interestingly, it does not work on my TyTN II.
However, its working on the Trinity.
It worked on my Kaiser/Tytn ll. Thanks!!!
not for me :-(
Hi,
maybe me being stupid, but this procedure does not work for me. Problem is that I installed software for the iGo bluetooth keyboard (I know ...) and ever since the Kaiser is resetting itself every 30 seconds. So what I get is only the smart mobility message, a short vibrate and then back to start. Anyone any idea how to get out of that? May I just press the wrong softkeys?
many thanks in advance
eRay42
new situation: the keys I press are definitely the right ones, I can also get into bootloader mode. I flashed the original rom (RUU_Kaiser_HTC_WWE_1.56.405.5_radio_sign_22.45.88.07_1.27.12.11_Ship) back which finished successful but the situation is the same. When I hard reset I am told it has been done, being asked to press the green button and it reverts to the old problem immediately. I should say that I have not modded my device so far, it was in original state before I installed the above mentioned software. Could it be a coincidence and it is a hardware problem?
HELP!!!
I found hard-resetting my HTC TyTN "GB" somewhat unpredictable. Holding down both soft keys while depressing the reset buttone is the correct procedure. It's either related to the HTC_END.cab. Do you have this installed?
Cheers
Strange, can't perform a hard reset either, using the softkeys of my TyTn II. No matter how long I press and hold them, no message screen, no option to hard reset.
The only way is to use Clear Storage.
pietrucci said:
Strange, can't perform a hard reset either, using the softkeys of my TyTn II. No matter how long I press and hold them, no message screen, no option to hard reset.
The only way is to use Clear Storage.
Click to expand...
Click to collapse
haha, my two fat fingers...
I finally managed to hardreset, using two pencils to push (only!) the softkeys.
pietrucci said:
haha, my two fat fingers...
I finally managed to hardreset, using two pencils to push (only!) the softkeys.
Click to expand...
Click to collapse
Pencil trick worked for me tooooo
reset
thank you..my tilt went crazy and won't bot...just keep restarting and turning off.
I had to use the pen and hold down
damn it now i have to restore everything
No still not working. These button things doesnt work. BTW does using Clear Storage give same effect, anyone?
I also haven't been able to perform hard reset on my TyTN II with the Soft Keys.. it just keeps rebooting! Can anyone help me?
Cumpz
LoL.. nothing like keep trying..
Already got it..
i read on another forum that i need to press the camera button and the power button, they are both located on the same side and press the reset button..
i done that but keep getting a red green blue and white bars, the text say sspl-1.0.0lipof and at the bottom serial..
its the same as the first thing i had to do to load wm6.1..????
thanks
icum said:
i read on another forum that i need to press the camera button and the power button, they are both located on the same side and press the reset button..
i done that but keep getting a red green blue and white bars, the text say sspl-1.0.0lipof and at the bottom serial..
its the same as the first thing i had to do to load wm6.1..????
thanks
Click to expand...
Click to collapse
It's in the Kaiser Wiki, under 'Kaiser resets'.
this is what is says...
Hard Reset **NB** This cannot be performed while the device is connected/charging!**
* Press and hold both soft keys
* Using a stylus, press and hold the soft reset button at the bottom of the phone
* Keep all three buttons pressed until the keypad lights turn off and then flash
* Release the soft reset button while still pressing the soft keys
* Let go of the two soft keys once the message "This operation will delete all your personal data, to manufacturer default" appears on screen
* Finally, press the green call button to perform the hard reset, or press other key to cancel
1. what buttons are the soft keys..
2. i pressed the power and the camera buttons then the reset set pinhole button.. release the reset pinhole button after the keypads lights go off still nothing..
AEB button plus bricked my device. It will start but when the green screen appears it will not continue. Activesync will not connect and I cannot hard reset. Please help!
You should be able to hard reset as you dont need to be in the OS to do this. Try following the hard reset procedure whilst your phone is booting up.
PROCEDURE EXTRACTED FROM WIKI:
Press and hold both soft keys
Using a stylus, press and hold the soft reset button at the bottom of the phone
Keep all three buttons pressed until the keypad lights turn off and then flash
Release the soft reset button while still pressing the soft keys
Let go of the two soft keys once the message "This operation will delete all your personal data, to manufacturer default" appears on screen
Finally, press the green call button to perform the hard reset, or press other key to cancel
Hope this helps
I have ae button plus on my tilt. How in the world did it brick your tilt?
You installed it to your storage card didn't you? tsk, tsk, tsk...
It will work in storage card only if you change it's start up number in the reg. Otherwise it's stuck trying to load a program from a place it can't see yet. Because the startup directory tells it to boot before your SD card loads. It's not bricked though. You can hard reset you just have to know how.
Firstly do a soft reset. Immediately after the reset depress both softkeys. As soon as the green screen comes up depress the reset button again while still holding the soft keys. Then follow the directions on the screen! Voila!
Thanks guys, I did not install to my card. During installation it read some type of "language" error. Eventually I did get it to hard reset. I hooked it up to my comp and then tried a hard reset, after about 10 tries it worked. Thank you for your help...
I press the power button and camera button while pressing the soft reset button. all I get is a 3 color bar screen that says serial. That's it...
Then I tried to use the clear storage app. I typed in 1234 and clicked yes. nothing happens.
I have htcs home / customier too. and ever since the install I can't fully turn off my phone using the power button.
help please. I just wanted the phone back to default. Not bloatware free.
wrong key combination dude, hard reset is the two soft keys, and then the soft reset button
Push and hold the two soft-keys, then HOLD soft reset until screen changes. It may take a couple attempts...
You're not kidding!!
I tried, same result.. tried again, and again... after about 12 tries it finally worked. Man what a PITA!!
Just persevere!
Luck
hello, i did try soem options like press the 2 front keys + use stylus, but its not working.
i also try the use comm btn + camra btn+ stylus and agian not work. any help pls.
i am stuck with a password in kais 130.
thks
press and hold both softkeys and then press the reset button with the stylus keep holding the softkeys. if it doesnt work keep trying
and dont put a password that you cant even remember
Yeah, I've found the hard reset option to be finikle, but if you keep doing it eventually it will get there.
There is no limit on the passwords you can try, so try all the obvious ones first. This is assuming it is your Kaiser
If you have Sync'd with ActivSync and Outlook then once you have reset and let the operators customisations go through hook it back up to the PC and resync. You might want to check that the names/machine id matches with what is on the PC before you do that so it doesnt create a new profile. I've got loads of the sods here now
hello ;it does'nt worck with me !
can you explain with pics
thanks
How to do a hard reset?
You see the two icons above the 'Internet' and 'Email' icons on the pad at the bottom of the PDA? Press and hold those two while pressing the stylus in the reset hole underneath and follow the onscreen instructions...
How to do a hard reset?
You see the two icons above the 'Internet' and 'Email' icons on the pad at the bottom of the PDA? Press and hold those two while pressing the stylus in the reset hole underneath and follow the onscreen instructions...
thanks i will try now
im new to this so please be simple if you can help. i love my phone and i am really mad i cant get to anything. i would try to hard reset but i cant get to the start menu or anything. ive soft reset on multiple occasions but it does nothing
You don't have to be able to get to the menus to perform a hard reset.
Simply push both soft keys (keys above the 'E' and the mail icon on your pad) while performing a soft reset. You will then be prompted to push the 'Send' key and everything will be restored.
Welcome to XDA
Yeah, you can hard reset using the physical keys. However, the above method has never worked for my ATT Tilt. The method described in the wiki has never worked either. The method I use which works for me, is:
Press the two "-" softkeys on the front of the device while it is off
Then, while still holding the sofkeys on the front, press the stylus into the reset hole on the bottom for at least 3 seconds
While Still holding the two softkeys on the front, press the power button briefly then release it
You may release the softkeys once you see the warning message
Good luck,
Dave