I am using the bluetooth headset with the phone but when bluetooth headset is connected and a call comes in it is going straight to my headset i cant hear the phone ringing i can only hear if i have the headset on
can i change this someone how ?
Related
OK!
I feel stupid.
I am running a Tilt and a Jawbone headset.
With the bluetooth on, the ring tones go through the Jawbone. How do I make them go through the phone's speaker instead.
I did read a thread about this issue someone else had, but it was with a stereo headset, which the JB isn't
Thanks!
I feel stupid too - I have the opposite problem. The Bluetooth hands free in the car doesn't ring on INcoming calls... just the Kaiser rings (and if its in my case I don't hear it)
I guess its a setup issue - any suggestions?
Graham
Hi everybody.
I searched but did not found answer to issue I having.
If I turned on BT my bt headset (A2DP) works fine, but on incoming call there is no ring sound on telephone speaker. When I checked phone i could see that is muted. My wild guess is that phone sends everything to headset because it is in A2DP mode and send every sound through BT.
How to fix this?
Headset?
Is your Bluetooth headset designed to handle calls as well as music? If not, that will be your problem. When I'm listening to music via BT headset, the phone rings through the headset, not the device speaker
grahamkdt said:
Is your Bluetooth headset designed to handle calls as well as music? If not, that will be your problem. When I'm listening to music via BT headset, the phone rings through the headset, not the device speaker
Click to expand...
Click to collapse
My bt headset is designed to handle calls.
http://www.sonyericsson.com/cws/products/accessories/overview/hbh-ds220?cc=CA&lc=en
What I want is to hear ring signal through device speakers as well as I don't have all time earpieces in my ears and I can miss a call
I just wanted to buy a stereo bluetooth handsfree for my device and finally I decided to buy an EverE T909s about 40 $...
it pairs correctly and fully to the device and music sound is good... but when there is an incoming call or when i call some one its microphone is so weak and people cant hear me!
I just paired the headset to another phone but it worked properly...
any solution?
I have the same problem. But in my case people can hear me when T909S is connected to the phone (Samsung), not very good, but they can.
What I'm concerned is when I connect this headset to my computer and try to use it for Skype, whatever settings I use the sound from Microphone is always very squeaking and it's impossible to use this headset as my headphones in Skype...
Any solutions?
Whenever I'm connected to my Blueant headset, the call still rings on the phone, not the earpiece. After one or two rings, a funky kinda ring does sound on my headset, but this is not my preferred setup.On my other phones, the correct ring automagically was transferred to the headset and the phone stayed silent. Is there a setting somewhere that can fix this? Most obliged....
Hi,
I have a Blue-tooth hands-free set in my car.
Often I need to walk away from my car during a phone call.
It also happens that I am outside the car, a few yards/meters away from it when I make or get a call. when this happens the audio goes to the BT headset, but I can't hear it or be heard because I'm not near it.
So how can I make an ongoing call move from the BT headset back to my phone?
It has to be done from the phone only. No pressing buttons on the headset itself etc. (as I explained, I might be far from the headset and the car may be locked, etc.)
ThanX in advance!