I think I must have changed a setting. My media net Edge connection stays on. If I restart the phone Edge (wap.cingular $20 plan)is not connected and no programs are loaded. If I check the weather (HTC Home screen) it connects using Edge. When I first got the Kaiser I thought it disconnect from Edge after the weather download. Now Edge stays connected. Any ideas what I might have changed. I have stopped all programs and it still stays on. I can stop it using comm manger Data Connection. (everything else works great, TomTom GPS, wifi etc.) Would prefer not to do hard reset since everthing else works. Waiting for ATT to turn on 3G in Denver in 4 days.
Hi everyone,
I got my new Kaiser (AT&T Tilt) last week, unlocked of course, and I have reformatted it yesterday, and since then, I am unable to get Wifi to connect to any network! The device shows me the available network and everything, but it says it's connecting to them and then it just says they're available
Any solutions? Suggestions?
-W.
TyTN X said:
Hi everyone,
I got my new Kaiser (AT&T Tilt) last week, unlocked of course, and I have reformatted it yesterday, and since then, I am unable to get Wifi to connect to any network! The device shows me the available network and everything, but it says it's connecting to them and then it just says they're available
Any solutions? Suggestions?
-W.
Click to expand...
Click to collapse
same here.... but no solutions yet....
What ROMS/Radios are you using?
Actually, a solution that would work is to power cycle the device (remove the battery for a few mins out of the device, put it back in, and run again) however, I am not sure about this solution as it may be a temporary one!
The ROM I have is:
1.57.502.2
Radio:
1.27.12.11
Any suggestions on the ROM/Radio?
-W.
just a suggestion of what works for me.......my POS router, i can only connect to it if the wifi power mode on the kaiser is set to best performance. same sh*t with the wizard and the hermes. i seriously should get a new router
i had the same issue. But today i triedd q-mobile rom, which has a different radio than before. It works now. I am finally connected to my router. I have a Tilt as well.
I've noticed variations in performance and willingness to connect to APs depending on the Radio version. On 1.27.12.32 it would sometimes connect, other times not - and take a long time! On 12.17 it connects pretty quickly to most APs. If it doesn't, I turn Wifi off, then on.
Actually, It used to connect to the same network (probably different AP) with no problems at all!
I encountered the same issue today, and even after a powercycle the same thing happened..
BiPolarXpress said:
i had the same issue. But today i triedd q-mobile rom, which has a different radio than before. It works now. I am finally connected to my router. I have a Tilt as well.
Click to expand...
Click to collapse
I had the same problems you guys had. tried to connect then would say available.
i took your advice. first i tried to install the radio that comes with the q-mobile. i couldnt install it to my phone, the screen would black out.
next i went ahead and installed the latest version of q mobile. now it works. and btw q mobile is one fast freaking rom! the screen goes from landscape to portrait in a flash!
thanks!
Mine abruptly started not connecting to any network as well. I'll try the powercycle idea. I have the AT&T standard ROM.
ranger47 said:
Mine abruptly started not connecting to any network as well. I'll try the powercycle idea. I have the AT&T standard ROM.
Click to expand...
Click to collapse
So if I powercycle it it works, except that when I try and connect to what wifi it works for a minute or so and then causes the same problems.
ok, need help with my wifi also, if I go to Wireless Lan settings it says LAN is off, and has a link to click to turn it on, I click it and it connects, shows info including signal strenth, then it disconnects.........it wont stay connected
jsnone1 said:
ok, need help with my wifi also, if I go to Wireless Lan settings it says LAN is off, and has a link to click to turn it on, I click it and it connects, shows info including signal strenth, then it disconnects.........it wont stay connected
Click to expand...
Click to collapse
I am facing the same problem. anyone help?
Hmm, sounds like the same problem I was having. See http://forum.xda-developers.com/showthread.php?t=366526
Not really a fix but a better workaround than having to reboot all of the time.
Wifi Problems with TyTn II
I have a HTC TyTn II and i have some problems with "wlan".
I cannot connect with my router.
I tried it even withouth a security key but it says connecting and for the rest nothing happens.
Ive resetted my router to default settings so everything is open but still i cannot connect my phone to the router.
My router brand is:SMCWBR14S-N2.
Details of my Phone:
Rom version: 1.56.404.6
Rom date: 08/28/07
Radio Version: 1.27.12.32
I hope you guys can help me, Thnx
Hi,SMCWBR14S n2 router the same problem for me but when i turn it to 802.b it works.
I think there is something in the mixed mode what the pda dont respect.
I have a similar problem, but with a twist.
When I'm at my parents, I can connect to their BT Homehub Wifi with no problems at all, even on power-saving wifi mode.
At my house, I have a Siemens Wifi router (from Tiascali), and I cannot connect to this (says it is available, shows signal strength, but won't successfully connect) unless I turn off the encryption/security key.
The only difference between the two networks (apart from the names) is the BTHomehub uses 64bit WEP key and the Siemens uses WPA-PSK key (AES/TKIP not specified in router setup page). I can change the key method on the Siemens to 64bit WEP, but it still won't connect. My laptop connects without problems to both networks.
Is this a problem with encryption handling by the Kaiser?
ROM: Dutty's WM6.1 WWE 29/04/08
Radio: 1.65.14.06 (tried the other radio version of Dutty's rom with same results)
Chris
edit: verfarkas, that's something I haven't trued yet - I'll give it a go when I get home tonight. That would be a nice simple fix - by default, my Siemens router has the "b" (and other suffixes) chosen automatically.
Change to best performance
I was having all of the above problems until I set my power save mode to "Best Performance". Go to settings -> Connections -> Wireless LAN
I have a Tilt with the stock AT&T ROM and HardSPL. I keep the HSDPA data on all the time and connect to my wireless access point while at home.
I understand and am fine with wifi disconnecting in sleep mode - email still checks using HSDPA. What normally happens is when I power the Tilt back from sleep the WiFi connects back to my access point.
I've noticed more than a few times however that coming out of sleep WiFi doesn't even attempt to reconnect to the access point. It is on in Comm Manager and appears to be associated with my AP, but checking the IP online shows an AT&T IP addr, not my CATV provider.
The only way to get back on WiFi is to shut off the phone (or reset). I don't want to keep WiFi on while in standby, I just want it to reconnect when it should.
Has anyone seen this behaviour?
Cheers,
Todd
Wifi access point problem
I had a problem where suddenly after months of use with my home wifi router, it suddenly would not connect with the router anymore. Would show that it was trying to connect, and then would suddenly not connect and try another router on the list.
I tried reseting and everything. Tried re-entering the password for my router as I thought that was the problem. finally the only fix i found to work was to actually delete the access point from the phone... then reset and then let it find it all over again from scratch. And miraculously that time it worked.
I know this is not exactly your problem, but hope it helps.
I will try that and see what happens. It seems whatever sub-routine that turns the wifi on isn't running at times and doesn't even attempt to search.
Having my Diamond for a month now, today i noticed strange behavior : My WLAN/WIFI disables it self.
For a month Wifi worked fine (connects to a Linksys WRT350N).
At first I didn't notice, but while surfing the net I notice that new pages didn’t load. I looked in my WLAN settings in Commanager which was says that WLAN is disabled. No problem, enabling it again. But still in the Commanger, I see it disables itself roughly within 5 seconds. And again and again.
Surprised I did some softresets but that didn’t help either. Than I remembered reading that somebody had troubles with the powercable when the device was too hot.
In the Netherlands is was quit hot today and i was using my phone outside. I put my device in the fridge for some tens of minutes and after that WLAN works fine again.
Other seeing this behavior too??
PC connected
Not use connected to PC with USB cable or with power cable.
HTC UK O2 NoDo and unlocked
Odd behaviour. I usually toggle off wifi,bluetooth, gps and data to save battery if I'm away for extended periods and speed up charging since you can't turn off the phone if connected.
1. Whilst USB connected. If I leave Data Connection On and turn off 3G. USB disconnects and orange LED turns off. No charge or sync with zune within 1 minute.
2. If I leave Data Connection On and turn off 3G before plugging in. Same thing happens. Again within 1 min.
3. If I leave Data Connection On and leave 3G On. Stays connected and charges/syncs with zune without any issue.
4. If I turn off Data Connection completely. Stays connected and charges/syncs with zune without any issue. But if I toggle Data Connection On whilst plugged in and 3G still off..again in 1 min it disconnects.
It is as if I toggle off 3G prior or after plugging in USB to a PC. Connection drops after 1 minute but not straight away.
Not a big deal. But curious if someone else could try the above scenarios, could be a WP7 OS thing, could be device specific or maybe I put too much homebrew apps and registry changes screwing it up.
Let me know you experience same thing! Many thanks
TMOUS HD7 here, no connection drop with 3g on or 3g off, even when i toggle while its connected to zune..I'm guessing it must be something you did to your registry..
rhn said:
TMOUS HD7 here, no connection drop with 3g on or 3g off, even when i toggle while its connected to zune..I'm guessing it must be something you did to your registry..
Click to expand...
Click to collapse
Thanks, all I needed to know. Cheers mate!