Stuck at HTC logo - Tilt, TyTN II, MDA Vario III General

Today I flashed my device to L26 KaiserDiamond from a WM6.1 Dutty's ROM.
The device rebooted fine, but when I tried to restore contacts/notes/etc.(via Sprite Backup), it performed the operation normally, but after restarting it is now stuck at the HTC logo.
I tried to reset the device via a hard reset, and it doesn't even get to the HTC logo... it just hangs at the L26 flash screen with the version numbers.
Is there anything else I can try, or do I have an excuse to buy an iPhone now?

Have you tried to re-flash it?
I'd put it in bootloader mode and re-flash.
good luck

try taking the battery out of your phone

Related

HELP. tried upgrading.. stuck at 98%

hey.. ive upgrade to new roms before.. however i tried going from the cingular 2.25 rom to summiters aku 2.3.. and it froze at 98% and was unable to finsh.. now I jsut tried downgrading and it froze again at 98%.. it won't complete anytthing.. help. please.
It's normal for it to seem to freeze at 98%, but it really will complete if you just wait a few minutes. No worries... just be patient.
If Stuck
hey if your phone is doesn't go through with the rom upgrade and doesn't push through and when you reboot you get stuck on the boot screen.
Put your phone into USB programming mode by holding the camera button down and doing a soft reset with the stylus. Then you will be able to load any rom you choose.
With regards to your frozen at 98 just give it time i would say don't unplug
same problem, still stuck
2nd time trying to load "Cingular_Custom_AKU2.3_Combo_Installer_V1.exe" ROM but still stuck at 98%...on the computer it says 100% and finishes but the phone is still stuck at 98%..tried to do a soft reset, but stuck at bootloader screen..
Help pleaseee!
Thanks!

stuck at white bootloader screen

after several times trying to unsuccessfully install a hard spl. (it installs and on reboot keeps the version 3) i upgraded the radio and now its stuck on the htc loadup sreen with the version listed on the bottom . a hard reset just resets so i cant even run the repair utility
one more thing
Oh and one more thing because it wont boot full or go into hard reset mode the computer will not recognize it.

[Q] HTC sprint diamond will not boot past splash

Hi, I have an htc touch diamond that will not boot past the splash. It turns on, says htc diamond without red letters. I have tried soft reset & hard reset, doesnt work. also phone does not turn on by power button but only the reset button. Every time I try to flash or unlock it says "Error 262", I've tried soft reset and continuing the setup and the error comes up again. I've tried the whole thing of changing the driver from 2007 to 2003 and completed it and still has not fixed error 262. I've tried many different roms and the only ones that bypass 262 are the .exe file rom setups, but after installed still doesnt boot past splash screen. the farthest ive gotten with one .exe is going through the phone setup, but after the setup the phone turns off. the only way my computer notices the phone and the way i flash the phone is when it is in bootloader. have also tried the bootloader where you press the back button. I've been trying so hard to fix this phone but it just wont happen. please help?
ryan21x5 said:
Hi, I have an htc touch diamond that will not boot past the splash. It turns on, says htc diamond without red letters. I have tried soft reset & hard reset, doesnt work. also phone does not turn on by power button but only the reset button. Every time I try to flash or unlock it says "Error 262", I've tried soft reset and continuing the setup and the error comes up again. I've tried the whole thing of changing the driver from 2007 to 2003 and completed it and still has not fixed error 262. I've tried many different roms and the only ones that bypass 262 are the .exe file rom setups, but after installed still doesnt boot past splash screen. the farthest ive gotten with one .exe is going through the phone setup, but after the setup the phone turns off. the only way my computer notices the phone and the way i flash the phone is when it is in bootloader. have also tried the bootloader where you press the back button. I've been trying so hard to fix this phone but it just wont happen. please help?
Click to expand...
Click to collapse
If this happens, you can just soft-reset the device and run RUU again. The update process will then continue.
Note: At this stage, the Wince is destroyed; instead, it is in upgrade mode.
for official rom you can find at http://www.shipped-roms.com/index.php?category=windows mobile&model=Diamond

stuck in htc logo pls help

hi tried unlocking my bootloader worked fine then tried rooting phone worked fine installed custom rom phone went into htc logo and stayed there.
can get to bootloader tried recovery just ends up back to htc logo same when factory reset ends back to htc logo. when i plug phone into computer phone comes up fastboot usb but does not show up on my computer so i dont know how to get rid of this custom rom and install another one or the original one pls help. tried installing latest drivers they show up in device manager but my phone does not show up

HTC One M7 Unrooted stuck in bootloop, Nothing Works

Hey everyone, so today I tried turning on my mobile data on my HTC One M7 but it was not turning on so I decided to reboot the phone because that usually works but then when the phone restarted it could not get past the HTC ONE logo.
Now, my phone is not rooted and I do not have any custom rom, I only update my Lollipop with updates from HTC.
I have tried everything. I have tried the Shine a bright light trick, I have booted into recovery and done a factory reset and wiped the cache, I have done every possible action in the bootloader menu nothing is working.
PS - Unlike most cases I have come across, my phone is not rebooting it is just stuck at the LOGO. Someone please help or direct me to somewhere I can get help.
Thanks in Advance

Categories

Resources