Have Succeeded with SPLXploit.. need help for next step!! - P3600 Software Upgrading

hi guys,
i have used SPLXploit and it displays success
i tried flashing immediately with
RUU_Trinity_DOPODASIA_WWE_3.00.707.18_6275_1.46.30.11_108_Ship
but the error message shows "Wrong vendor ID"
now my bootloader page shows:
TRIN100
IPL 0.50
TRIN100
SPL- 3.03.0000
Have tried flashing SPL 1.2oli and it says Error 270 image file corrupted.
Am i right to say i can immediately flash a official rom without installing HARD SPL?
or can i install HardSPL and try installing another cooked rom?
Or can i install the official rom using the minisd method?
Questions Questions

Related

ERROR 144: Radio ROM Update Error (please help)

Hi
I tried to upgrade my rom image and everything worked perfectly.
But when I started my device, it says "No GSM" instead of displaying the RADIO ROM version.
So I tried to upgrade again the radio ROM, but everytime it says "ERROR 114: RADIO ROM UPDATE ERROR".
What can I do?
I even tried to restore my SD card backup, but it says "not allow".
Is there a possibility to use some bootloader commands via mtty and my SB card backup?
Thanks for your ideas!

cant flash other rom

Hello all,
i tried to flash a rom "Christian_NL_2502_Full" and ruu give an error "262" every time so tried sd flash feature but that wont work either can someone help me what i am doing wrong.
Specs
original rom is r3a
kovs110
spl-0.78.0000
microp1-787
microp2-707

ROM flashing "Error 262"

Hi,
i have problem with flashing my X1 with custom ROM
In Rom update utillity there is message: Error 262
On display is: KOVS 110
SPL-0.78.0000
Micro P1-787
Micro P2-787
Please help me!
What i can do with this error and how i can unlock my phone?
Before you can flash a custom ROM you need to hardSPL your phone. It isn't yet, because bootloader says "SPL-0.78.0000" and not "SPL-0.72.OliNex".
http://forum.xda-developers.com/showthread.php?t=431218
After you hardSPL'ed your phone you can flash custom ROMs.
gl
Yeeeah
Yeeah!
I did it!
Thank you very...very...much!

Trying to revert to stock

I followed first guide in the "informative threads" thread about reverting to stock up until this step:
5. Hit power to start the update DO NOT INTERRUPT!! i can not stress this enough.
Whenever I enter the bootloader it gives me a grey screen for a second and says "No Image Found" and then shows me the attached image.
Any ideas? I've been on the updating my phone with Cyanogen as often as he releases a new version of his rom.
How far are you trying to go back? Stock SPL and recovery? or just stock ROM? If you're going all the way backwards, change the SPL first, cause when you flash rc29 or rc7, it flashes an incompatible radio img.

[Q] Flash 2.22.27.08 radio and 1.33.0013d via recovery

Can i flash the new radio(2.22.27.08) and spl(1.33.0013d) via the ClockworkMod 2.5.0.7 recovery(or RA 1.7.0)??
I have the files downloaded from a mytouch 3g thread and want to know if i can flash them over the recovery?it says there they are flashable but can i flash them with an HTC Dream??
wipe-flash radio-wipe-flash spl-wipe-flash rom
or will i brick my device??
Or can someone send me a german introduction how to set up fastboot on windows xp??i dont get the english one
Phone: HTC Dream (rooted)
ROM: COS-DS 03042011 2.3.3 Gingerbread
Radio: 2.22.23.02
Spl: 1.33.2005
sdcard: 2gb ; ext/3​
You can flash spl and radio using recovery, but I would *not* suggest you to do so, because the risk of bricking your phone is much higher, than flashing by fastboot.
To setup a fastboot environment on XP you can try to have a look at www.android-hilfe.de There are many people using a windows environment and I suppose they have a setup instruction in German, too.
I agree. To flash it via Fastboot safer. First flash Bootloader and reboot your phone, then flash new radio and reboot phone again.
thanks for reply!i will try it now with fastboot!if it wont work i try it via recovery
Helo
I have a question. I flashed via fastboot the radio(2.22.27.08) and spl(1.33.0013d) and i have a problem with the batery. I want to put back the old radio and spl and the problem is that i cannot flash it via fastboot the mesage is:
failedremote:signature verify fail)
Somebody some ideas
Pls read the OP of ezTerry's 2708-thread (a link can be found in my signature). But I doubt, that the radio is the reason for your battery problems.
Sent from my Gingerbread on Dream using XDA App
Agreed with AndDiSa. It also depending on what ROM you use and the apps that you have on your phone.
I made the change of radio and spl like in the link in the signature and it was ok(Radio: 2.22.27.08, SPL: 1.33.0013d), the flashing was working. The rom is update-cm-6.1.0-RC1-DS-2708port_S.zip because the update-cm-6.1.0-DS-2708port_S.zip is entering in boot loop.
Like you sad that this is probably a radio image problem that's why i tried to flash the old image back with the spl and i had that error message. Also I tried to change my splash image via fastboot(to flash it) and the result is the same
Mine is also bootlooping on COS-DS rom with this radio/hboot combo...probably just a radio error or something

Categories

Resources