I would like to know will ring volume auto adjust when headphone is plugged?
When I am listening mp3 by using the TouchFLO player, someone phoned in, the speaker & headphone will both sound. Since the volume of ringer is tuned to Max, it hurt my ear. So, I need to tune ring volume each time when I plug or unplug the headphone.
Is there anyway to auto tune the volume level when headphone plugged or unplugged? Or, ring tone won't play in headphone even headphone is plugged?
Thanks.
I am using HTC RC E100 as a handfree and listen music. But I found that the volume is very loud. Everytime I using the handfree, I need to trun down the system and ringtone volume level to 1 !! And everytime I put it down, I need to reset the volume to the loudest level, otherwise, I can't hear the ringtone.
I know that the "audiopara3.csv" file can make the speaker and headset volume louder, can it also suitable for handfree? What value I need to change? Thank you for your help.
My setup:
AT&T Tilt with AT&T stock WM 6.1 firmware
HTC Audio Manager 2.0 Build 1819.2129
30 ohm impedance headphones connected to default audio adapter
When playing back a song in Audio Manager, the volume control is too coarse. At the lowest level, there is of course no sound. At the next level up, it's way too loud. Is there any way to make the volume control more fine grained?
I have this same problem. Audio manager is missing volume control and the system volume control is either nothing (lowest bar) or loud (2nd bar) and ear splitting on up.
If you use windows media player, it has a volume control which decreases the percentage of the volume from the system. So say you have it on the 2nd volume bar which is loud in Audiomanger. Open up WMP and lower the volume to 50% and it will lower the overall system volume to 50% of the 2nd bar. This affects audio manager and the whole system though. If you leave it on 10% in WMP then turn a speaker phone call all the way up it is only 10% of full volume, which sucks. So you have to go into WMP and change the volume percentage before and after you use audio manger which is a hassle.
Is there a better version of Audio Manager that has volume controls? I know the earlier versions did but I am using Manila2D and want the nice display and a volume control!
Hi,
I have been having this problem for the last couple of days, for some reason the volume of my ringer has dramatically decreased to the point where i can't hear the phone ring when it's in my pocket (wasn't the case before). When i try to play the ring tone (it's a wave file by the way) using the media player the volume is normal and very loud, the same applies to when i play it from the settings->sounds¬ifications the volume on the ring tone is perfect, but when i receive a phone call the ringer volume is cut down by more than half, i checked the ringer volume and it's set to the max, I also did a hard reset then restored my files using the sprint backup but the problem didn't get fixed, I tried using a different ring tones and the same happens. any help would be greatly appreciated.
There are three volume controls: System, Ring and In call Volume.
Have you checked the System Volume?
If you press up on the hard volume key, you'll see arrow on the top right to switch to the next vol control. Check there.
HTH
ringtone problem
yea all 3 volumes are set to the max level
ringtone volume problem
the phone has the original stock rom from rogers (canada) hope this helps in any way
Have you got any profile managers installed (G-profile, Phoneweaver etc)?
ringtone volume problem
no i dont have a profile managers installed... so i just noticed that when the phone start ringing and i dont pick up, a second before the phone stops ringing the volume of the ringtone increases to the normal level (then stops ringing), the increase of the ringtone volume happens for like a split second after the caller hangs up and the phone stops ringing. hope this helps in any way. Thank you
Sounds like you have a Ringtone delay problem, there are a couple of solutions.
1. Disable HTC dialer (and use the Winmo one instead), can be done using Advanced Configurator 3.3.
2. Try the CAB I've attached, remember to only use WAV as ringtone though.
I would also recommend adjusting Call Forwarding timing to 30seconds. Settings/Phone/Services/Call Forwarding and get settings.
Disabling the HTC dialer is probably going to be the best solution as the HTC dialer is a hungry resource eating monster but I would just try the CAB and adjusting Call Forwarding time. There are some other REG setting as well but I never found them useful.
The volume keys make the most annoying sound when adjusting ringtone volume. Is there any way to disable the sound level preview so I can adjust my ringtone level without blowing my ears out or making a scene. I forget to turn volume down before I start work. Now when I turn it down it goes through the sound and is loud and obnoxious. Also before I go to sleep I turn it up and its loud and kills my ears in a silent room. I just want the volume buttons to change get the volume without making a beeping noise to preview that sound level. I might sell this phone because of the damn volume buttons.