Database Develop

Can someone explain the USB sync/charge interface?

Ok, so hoepfully someone can clear this up as I don't yet have my Kaiser (tilt) and am trying to get some accessories.
I previously had a PPC-6700 which synced and charged via a standard mini-USB jack.
I then upgraded to the PPC-6800 which I only had for about a week (had to give it back to my work). With that device there was a different type of usb jack on it that seems to be what the Kaiser also has. Can someone tell me what this is called?
From my recollection however, this slightly different jack would also accept the typical mini-usb plug as i can remember using my PPC-6700 wall charger on it.
So can you use standard USB to mini-USB plugs to interface the Kaiser with either a PC for sync/charge or to a wall-charger? What is the new interface called and what is the point of it?
thanks much!

I may have actually answerd my own question as I have found (I think) the name for this new interface... EXTUSBTM ? Is this correct. And the point is to interface the charger/sync and audio headset together?
If this is all it does then I should be fine using all my old mini-usb plugs for data interface/charging, right?
thx!

Yes, you can use a standard 5 pin mini USB cable. The port is HTC's 11 pin combination sync/charge/audio port. Both their plug and the standard 5 pin mini USB plugs fit and work.

Wikipedia (for once!) isn't too big on details here: http://en.wikipedia.org/wiki/HTC_ExtUSB
But basically, it's got 11 pins to handle audio, power and syncing.

Have a look here for pinouts etc.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}

AT$T Cheaped me out again. I only got a standard USB sync cable from them! DoH! lol

Car Charger = Crazy GPS?

Hi there.
I got a phone car holder and a car charger to properly use the GPS function (I use i-Go Amigo).
The problem is that the GPS is going a little crazy. It losts its signal, "spins my car" (the arrow in the screen stars to spin), transport me to another (wrong) place in the map, etc.
It doesn't happen all the time and it is usable, but very annoying.
This kind of stuff did not occur when I was using GPS just on the battery (for testing). I can only imagine that the car charger (not original) is interfering someway with the GPS software/signal.
Is it possible? Must I consider buy a original charger or there is no possibility that the charger is doing that?
Thanks!
PS.: Oh, I also use QuickGPS to get signal faster.

Is the charger built into the holder? If so that might interfere with the signal. Otherwise it is more likely to be the holder than the charger causing problems

stunno said:
Is the charger built into the holder? If so that might interfere with the signal. Otherwise it is more likely to be the holder than the charger causing problems
Click to expand...
Click to collapse
Really? Never imagened!
But no, the charger is not built into the holder:
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
How can the holder interfere in the GPS signal? Is it because it may be obstructioning the antenna spot?
Gonna test with the charger but without the holder and see how it behaves.

Activate Navi Panel without Car Kit, with simple mod

Hi
I don't know if people realise this but you can modify a generic car charger to automaticlly activate the Navi Panel mode so you don't need to buy the SU400 kit.
You will need a car charger that is capable of suppying 1 amp, to enable fast charging. ( Use an app called Spoon Charge to check) or disassemble the USB Micro A plug and ensure Data- and Data + are soldered together. DO NOT solder Data - and Data + togehter if not already done so this means the device is not capable of supplying 1amp.
If so you should have a unused pin ( this is called the ID pin) solder this along with Data + and Data - to OV.
When the charger is connected it will launch Navi Panle if enabled and turn on bluetooth and pair to a set device.
I will take a pic of the modded plug and post it up. In theory I would assume the same mechanism is used on more than this device.
Wayne

OMG LEGEND bro. lol. Finally someone figured out HOW to do this so you don't have to buy that overpriced HD2 carkit. Thanks. Mod's this should be a sticky.

mods seriously this should be front page news

Are you sure, that this will work? Did you tried it yourself? Cause my CU-S400 is also activaiting the Navipanel even if i don't have plugged in the Charger! So I think that it hasn't anything to do with the mAh-size of the charging unit....

You're right.
Right connections for recognition Car Kit Mode :
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Source.

Auto Shutdown After Samsung Logo (GT-I9070)

My Samsung Galaxy S Advance (GT-I9070) suddenly auto shutdown whenever i turn it on. I have tried flashing stock firmware using Odin but it didn't helped. Seems like the only thing i can do is booting phone in the download mode. And as i already told, i flashed stock firmware but nothing happened and it's still performing the same as before.
I hope you people understood the problem clearly. However, if you need any further information, please ask and i will answer you.
Regards

Does it work when plugged into a charger? The battery might be failing as it's probably old already.

3liteking148 said:
Does it work when plugged into a charger? The battery might be failing as it's probably old already.
Click to expand...
Click to collapse
When i plug it into a charger, it auto restarts (restart loop).

It also happened to me. The way, I repaired this, is a connnecting a external battery charger e.g.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
and leaving it for approx. 12h, until it fullfil the accumulator.

luke9813 said:
It also happened to me. The way, I repaired this, is a connnecting a external battery charger e.g.
and leaving it for approx. 12h, until it fullfil the accumulator.
Click to expand...
Click to collapse
You mean, all i have to do is charging the battery 100% in an external charger?

Yes, that's it. Sorry for late reply.

USB Type-C With Audio Charging Cable for Mi Note 3

Dear all,
Has anyone tested any of the below adapters?
Does it charge and answer the phone with mic?
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}

I've bought the second one on AliExpress. When it arrives, I'll report.

omercicek43 said:
I've bought the second one on AliExpress. When it arrives, I'll report.
Click to expand...
Click to collapse
Thank you!

Im curious too....

I have anbes, don't work

Nie work?
Where to find the original one? I lost mine now i can´t ear music..
Dam iphone ****!

I did buy one that is compatible with our phones.
Its a backup in case i lost the original one.

I received this, and it goes very well.

Receive another model, but only for audio...
Works like a charm!

Cuescorro said:
I received this, and it goes very well.
Click to expand...
Click to collapse
I bought it too, work like a charm

Is there anything fully working, even volume key, on custom rom?

I bought this one: https://www.fasttech.com/products/0...maisi-q15-usb-c-to-usb-c-3-5mm-audio-splitter
Simultaneous charging and audio playing (including microphone) works fine.

leledumbo said:
I bought this one: https://www.fasttech.com/products/0...maisi-q15-usb-c-to-usb-c-3-5mm-audio-splitter
Simultaneous charging and audio playing (including microphone) works fine.
Click to expand...
Click to collapse
I bought other kìnd of devices, but sound quality was very bad!! I will try this, thanks