I Installed a fresh windows on my diamond , and after that , everything went fine , the only problem is that , when i restart my device(suhtdown the startup again) it acts like a fresh windows install , you know , customazation , tapping the screen , etc , it delets all of the installed progs , and contacts ,just like a new install , and it keeps repeating every time i restart my phone , i need help , pls guys ... im desperete !!!
what ROM did you flash to? Flash another ROM this time using MTTY and doing a hard reset after its flashed the ROM.
i used about 5 diffrent roms , same problem ... dont know what to do ... and i can't find my old rom either , i had windows 6.1 and a manila 2.1 can't find it anymore
I suggest you flash the stock rom then run the unlocker again and then flash the custom rom. Good Luck!
i tought about flashing a stock one , but now , my phone won't even start , it just freezes on the start screen ( it shows the touchDiamond text , and the radio version , windows , etc ) , i tryed using mtty but it won't recognize my phone , and the drivers won't install either , i am using windows 7 ...
Code:
alexu2007 said:
i tought about flashing a stock one , but now , my phone won't even start , it just freezes on the start screen ( it shows the touchDiamond text , and the radio version , windows , etc ) , i tryed using mtty but it won't recognize my phone , and the drivers won't install either , i am using windows 7 ...
Click to expand...
Click to collapse
If you can get it to go into bootloader then you can flash. It should say serial toward the bottom. Then when you connect with your cable it should change to usb. Your ready to flash.
and with what program should i flash it ? i can get into bootloader , it says usb .. but what program should i use to flash s stock rom ?
alexu2007 said:
and with what program should i flash it ? i can get into bootloader , it says usb .. but what program should i use to flash s stock rom ?
Click to expand...
Click to collapse
You need to have your carrier's shipped .exe version for your device downloaded to your pc.
could you explain what should i have , i got my phone from a friend . u know second-hand , i didn't get any cd only a headset and a charger... if so where can i find that .exe ?
edit:i googled it and i found a stock rom .exe like u said , thanx a lot , hope it will work fine now ...thanx a lot again for helping me
alexu2007 said:
could you explain what should i have , i got my phone from a friend . u know second-hand , i didn't get any cd only a headset and a charger... if so where can i find that .exe ?
edit:i googled it and i found a stock rom .exe like u said , thanx a lot , hope it will work fine now ...thanx a lot again for helping me
Click to expand...
Click to collapse
You're Welcome!
I figured you would find it.
Good Luck to you!
Related
hey i'm an newbie , so please take it easy on me .
i have wizard , G4 version .
i tried to flash my WM5 to WM6 ( touchflo NBD ) using the software shelltool.
so i did everything i was supposed to , installing the cabs files and on .
but when i flash to the new version , it's disconnected while saying it's finished ( finished to write the rom ) . this was after 9 minutes - and i thought that's because i have good computer .
anyway , i hard rest my wizard - but it's get stucked on the splash screen of orange with all the version of SPL IPL .
now i get real stupid , cause i didn't know what to do , so i enter to the bootloader and tried to flash again with the shelltool while my wizard at bootloader status .
right now it's in the middle of writing the new version , but it's been more than 40 minutes , i'll guess i'll unplugged the cable cause it will stay like this for hours.
is there anyway to fix what i have done ?
please help me out !!!!
i don't know nothing about fixing the wizard with bootloader and stuff, so i need an guide .
hope for an answer thnx everyone
Same happened here. How i fixed. Downloaded wizard love rom. Get into bootloader. connect cable get usb connection. no active sync needed. Flash using RUUgetinfo file from love rom folder. not using shell tool. wait till finish. reinstall both cab files and reset. now use shell tool to flash to your choice rom. give it at least half hour to run. before disconnect even if it says program not responding. hope this helps....
yeah , i did the same and it's work .
too bad i didn't see your answer before 4 hours , i didn't sleep because of that.
by the way , wizard love is WM5 or WM6 ?
i tried to flash to black diamond and to NBD but with no luck , it's never end flash even after 2 hours !!!!!
is there any way to flash without shelltool ? maybe through RUU ?
please help us getting those flash on our wizards
You can't flash with RUU on a CIDLocked G4 That's why we want it so bad (cidunlocking )
heheh alright , so how come i can flash with RUU the wizard love edition ?
and is there any way to slove the problem with shelltool program ? cause everytime i'm flashing an rom , it's never end ...
guys ...
few month ago i had instaled HTC ROM ... and it's working on my X1i ...
but i think it little bit slowly ...
then now i want to restore it into my original X1i rom ... i had download it from rapidshare ... i format my micro sd card ... then copy it on it ...
then i flash it ...
but i can't boot it ... just stop in SE logo ...
anyone can help me to turn my X1i back ...
please ...
T.T
Try to flash another official ROM, i.e. a previous version (R2AA, R1AA) or just connect to SEUS and let it flash your X1
Same issue
[email protected] said:
Try to flash another official ROM, i.e. a previous version (R2AA, R1AA) or just connect to SEUS and let it flash your X1
Click to expand...
Click to collapse
i have same isue
after installing windows 6.5 i cannot use TOMTOM in my fone always hang and neeed to remove battery and plug it back again
and on right top task bar icon is not appearing and due to this i cannot close or end any application
want to roll back to original ROm and i didnt figure out on net
if possible can you email me the link on masimk3 at h o t m ai l. c o m
Thanks
Asim
knuckle89 said:
guys ...
few month ago i had instaled HTC ROM ... and it's working on my X1i ...
but i think it little bit slowly ...
then now i want to restore it into my original X1i rom ... i had download it from rapidshare ... i format my micro sd card ... then copy it on it ...
then i flash it ...
but i can't boot it ... just stop in SE logo ...
anyone can help me to turn my X1i back ...
please ...
T.T
Click to expand...
Click to collapse
I'll try to help :
1. Unpack the file you've downloaded.
2. Rename the file (without quote) to "kovsimg.image" or "kovsimg.nbh" and make sure it's not "kovsimg.image.image" nor "kovsimg.nbh.image"
3. Copy the file to your micro SD card.
4. Turn off your device and release the battery for few seconds then turn it on again, bring i to boot-loader mode by by holding the "volume down" button on the right, and holding the power on button until you see the tri-color screen. Just follow the onscreen instruction. I believed you have known this method, otherwise you can read this.
5. If you don't have a plan to flash custom ROM again, restore to stock SPL. Find it and read the instruction here.
Just do search my friend, you'll find the answer.....
masimk said:
i have same isue
after installing windows 6.5 i cannot use TOMTOM in my fone always hang and neeed to remove battery and plug it back again
and on right top task bar icon is not appearing and due to this i cannot close or end any application
want to roll back to original ROm and i didnt figure out on net
if possible can you email me the link on masimk3 at h o t m ai l. c o m
Thanks
Asim
Click to expand...
Click to collapse
It is not the same issue. You have a compatibility software issue, that is normal since you are running a beta ROM or a software that was not designed to run on WM6.5. Knukle89 has a ROM issue, i.e. his phone doesn'e even turn on.
Follow bulux instruction or/and read this thread http://forum.xda-developers.com/showthread.php?t=431218
still can't work ...
i had run SEUS ...
but when identifying phone it always says that " the phone can't identified ... please reconect the USB "
i try it again n again but still no use ...
hard reset maybe?
hello friends
i have a big probleme with my TYTN II , i installed ARABIC LANGUAGE SUPPORTS , but when i restared the machine , i found that :
1 - the phone blocked on black screen .
2 - the phone can not be detected by the computer .
* i used the reboot hard set , but the problem also the same ....
please how to resolve this probleme ?
Try doing a master reset on the phone it will clear any stuff that you done & will have to start over but it will get your phone back to it's original state when you flashed it with a different rom. You can do a master reset by holding down the 2 soft keyes & then use your styles to click on the reset. hope that helps.
hy friend ....i did that before ...but no result ....
Get into bootloader and flash new ROM. But have u do hard-spl before? If u don't do hard-spl before, u have to find exact ROM for ur device.
Moved as not software release.
Follow poster above directions and stock ROMs can be found in sticky. "to which as mentioned you need your carrier ROM"
Ho. Hi all, i have problem with my xda 2 & I have it 3. All have the same problem, it can't use to make a call or receive a call otherwise the GPRS run well. I already try all new roms, but still the same, cant use it to make call. I cant remember the last time it can use to call. Somebody help please.... n sorry for my bad english thanx
mipsiz said:
Ho. Hi all, i have problem with my xda 2 & I have it 3. All have the same problem, it can't use to make a call or receive a call otherwise the GPRS run well. I already try all new roms, but still the same, cant use it to make call. I cant remember the last time it can use to call. Somebody help please.... n sorry for my bad english thanx
Click to expand...
Click to collapse
hi
I suggest you could try unlockig it again (I assume it is sim-unlocked?). I used to run axdadev_all_unlock-v1.6_138 only once, but I was having some problems, so I always use same application twice and it works great
1) download axdadev_all_unlock-v1.6_138 and copy it onto device
2) find it and run it (on device) via file explorer
3) when u see "success" screen, soft reset device
4) run axdadev_all_unlock-v1.6_138 again
5) when u see "success" screen, soft reset device
let me know if it worked
BTW:
1) have you tried to Hard reset your xda II ?
2) have you tried different radio's ?
3) are your devices european or maybe from USA?
regards
Matt
Ho. Hi Matt, thanx a lot for your answer on my problem. I already try every step you told me, but still looks the problem still happen. I Already hard reset my devices for many times, but not help. Should I try another radio? hehe, i don't know how to try another radio coz i newbie. Hope you will help me to solve my problem. Btw, I live in ASIA, Indonesia if u ever heard, so I guest my device made for ASIA....
Regard,
Indra
hi..try to upgrade ur radio stack..
according to this forum,radio 1.17 is the best choice..
but i'm using radio 1.18,wm6.1 by aeroflyluby and still not find any trouble..phone OK GPRS OK....but the latest one is 1.19
u can use himaupgradeut or himaupgradeut_noid (for european or other but i think ur device is asia version)then put ur rom file (nk.nbf),ur radio file (radio.nbf) and click the himaupgradeut..
but u must sure there are enough battery (50% above) in ur device before upgrading..
just wait and relax(coffee,snack,etc)
ps:if u want a 30mb storage for ur device when using wm5 above,before upgrading u can use ExtROM unlocker and HIMA DOC Tools for repartition ur storage.
hope this will help
xda_anto said:
hi..try to upgrade ur radio stack..
according to this forum,radio 1.17 is the best choice..
but i'm using radio 1.18,wm6.1 by aeroflyluby and still not find any trouble..phone OK GPRS OK....but the latest one is 1.19
u can use himaupgradeut or himaupgradeut_noid (for european or other but i think ur device is asia version)then put ur rom file (nk.nbf),ur radio file (radio.nbf) and click the himaupgradeut..
but u must sure there are enough battery (50% above) in ur device before upgrading..
just wait and relax(coffee,snack,etc)
ps:if u want a 30mb storage for ur device when using wm5 above,before upgrading u can use ExtROM unlocker and HIMA DOC Tools for repartition ur storage.
hope this will help
Click to expand...
Click to collapse
1.17 radio is most stable
Himaupgradeut_noID is safier, it works like normal update but does not check device orgin, so you can upgrade even chineese PPC For Chiineeesee hands himalaya too.
hi all .i am not a phone expert, but i flashed my phone several time's with topat , cheetah en more . but now my phone is realy slow , with everything. if i type a message it wil crash , if i want to see a picture it crashes. is there a program wherewithal i can format my whole phone ? and which kitchen can i use for the topat 2.1 rom . i am from holland . dutch plaese. thanks all
jeetje103 said:
hi all .i am not a phone expert, but i flashed my phone several time's with topat , cheetah en more . but now my phone is realy slow , with everything. if i type a message it wil crash , if i want to see a picture it crashes. is there a program wherewithal i can format my whole phone ? and which kitchen can i use for the topat 2.1 rom . i am from holland . dutch plaese. thanks all
Click to expand...
Click to collapse
Do you hard reset after you flash?
You may want to consider MTTY Task 29 before flashing. Info can be found here.
no i didn't . i have done a hard reset . thanks it workd fine .thanks again