I was running CM6 RC1 firerats recovery mod bx theme and decade's #7 kernel
all was well in hero land for me then i found out that sprint released a new prl so i flashed back to a 2.1 rom and updated my profile and prl then i tried to do a nand restore and all was bad in hero land none of mine worked and i have serval so I just said forget it and did the whole thing over again and still no go even tried to flash a different theme and same results I'm able to boot up and run the rom fine and i even flashed CM6 8/22 build and was able to boot up and run fine but every time i flash a theme i get stuck in a boot loop tried to flash the bx and the all black theme but no go always a boot loop so I'm looking for some help with this problem i would like to b able to flash themes again thanks
Related
I was using a theme CM 3.6.8.1 ROM today with modified launcher_7, phone and MMS. I changed the Launcher from 7 to 8 and flashed the themed ROM again and I got stuck at the G1 screen.
I fastbooted (Dreaimg.nbh) to refresh, did the usual steps, flashed RC33, the radio, then I tried to flash the original 3.6.8.1 (no theme). After flash and reboot, it took me to fastboot. I flashed JFv1.5 -ADP1.5 and it did the same thing.
I then flashed the Special SPL and then tried each ROM again which left me on the T-Mobile G1 screen.
However, when I flash RC33, it loads just fine and works normally. I tried searching for a thread that'll help me flash back to the 3.6.8.1-level ROMs but nothing seemed to match my situation.
If anyone can help or send a link to a thread that can, it'll be greatly appreciated.
I am completely stuck as of now, tried everything! No idea what else I could try. I basically can install any rom just fine, Dwang 1.12 works fine, Cyanogen Mod 4.2.5 works fine too. I am not able to install the latest ones by either though, what could be the issue?
I have rooted MyTouch 3g.
What do you have on your phone right now, and what methods have you tried? What have your steps been?
I have 2 MyTouch 3g phones actually, one is my roomie's and I can install dwang's 1.13 just fine on it, weird .
For dwangs:
Backup
Wipe
Install
Reboot and get stuck on the MT3G boot screen
For Cyanogens:
Backup
Wipe
Install rooted Base
Install Cyanogens
Reboot and get stuck at MT3G boot screen.
It is my understanding that Dwang's latest is based off Cyanogen's 4.2.6, thus I can see why both of them won't work. But why?
I am on Cyanogen's 1.4 recovery tools, I've had Amon RA 1.3.2, as well as RA 1.4.
HBOOT: 1.33.0006 (SAPP30000)
Radio: 2.22.19.26I
anybody?
afive720 said:
anybody?
Click to expand...
Click to collapse
Sorry i can't help, but just to add on... I'm having almost the same issue, but with a G1. Although i can install any of Dwang's versions, including 1.13, but as far as cyanogen goes, 4.2.5 works great, but 4.2.6 and 4.2.7.1 i get stuck at the g1 logo when trying to flash. If anyone can help my set up is
SPL 1.33.0006
Radio 2.22.19.26I
Amon_RA recovery-RA-dream-v1.2.3.img
have you both done thorough wipes through the console?
Are you flashing the signed developer zip file before trying to flash the rom itself?
The process should be...
Wipe
flash signed dream developer zip
NO REBOOT
flash the rom zip on top of the previous zip
Reboot
you can find links to the signed dream dev zip here
http://forum.xda-developers.com/showthread.php?t=593626
Since the first guy has a mt3g, you'll need to find that primary file. The dream one wont do it for you.
check cyanogen's wiki over at cyanogenmod.com
I've had a similar problem. I follow all the instructions correctly, but Dwang's 1.13 works and CM doesn't. For CM I did everything, wiped, flashed 1.6, flashed CM, rebooted, and then it would go back into Recovery for some reason. I'd reboot again and it'd hang on the Rogers screen for me. I couldn't fix it so I wiped, flashed Dwang's, and his worked fine. No clue why CM wouldn't work for me since that's the ROM I actually wanted.
DiSTroy3d said:
For CM I did everything, wiped, flashed 1.6, flashed CM, rebooted, and then it would go back into Recovery for some reason. I'd reboot again and it'd hang on the Rogers screen for me.
Click to expand...
Click to collapse
Yes the first reboot writes the radio files. The second boot writes the cache.
You will have to hit reboot when the cache writing stops. (reboot will become an option in the recovery)
This is the first boot of a brand new OS as far as your phone is concerned and it will take a few minutes. The boot process will take a while. The phone is writing and moving the entire android OS.
I have had mine hang for about 10 minutes before. Sometimes it is 5 minutes.
Mine normally hangs for about 2-5 in the G1 boot screen and another 3-5 in the cyanogen logo.
Hi All,
I seem to have a problem with the wife's G1.
She had Cyan's latest ROM 4.2.14.1
She wanted to try a 2.1 rom so I loaded CaNNoN202 eclair and it worked fine, even the live wallpapers.
Anyway, she wanted to go back to Cyan so I wiped the phone including the dalvik cache.
I then flashed cyan 4.2.14.1 and tried to re-install her nandroid but it just hangs on the first boot screen.
The other issue I sometimes get is it says 'run nandroid from console'..
Any odeas what I need to do?
Thanks
I have been on cyanogen and super d for a while now but recently decieded to try out the eclair Hero and sense roms, eclair flashes fine and I can flash the Kingklix hero rom no problem but I cant flash any other hero or sense rom.
Jacheroski rom at first just got stuck in a boot loop after reflashing the radio and spl it boots but everything and I mean everything force closes phone acore mms it doesnt even get to the setup process I have to do a battery pull and reflash kingklix.
On the sense roms it boots into htc quietly brilliant or nexus boot screen then just stops there waited more than 20mins for it to boot, nothing happens.
I've updated to the latest radio installed the death spl and updated to the latest recovery but I still cant get any other rom to flash, can anyone help
Not sure if it'd help you but commonly I havta wipe SD including ext partition to flash any sense rom.
Sent from my MT3G
using the XDA mobile application powered by Tapatalk
Jonnibravo said:
I have been on cyanogen and super d for a while now but recently decieded to try out the eclair Hero and sense roms, eclair flashes fine and I can flash the Kingklix hero rom no problem but I cant flash any other hero or sense rom.
Jacheroski rom at first just got stuck in a boot loop after reflashing the radio and spl it boots but everything and I mean everything force closes phone acore mms it doesnt even get to the setup process I have to do a battery pull and reflash kingklix.
On the sense roms it boots into htc quietly brilliant or nexus boot screen then just stops there waited more than 20mins for it to boot, nothing happens.
I've updated to the latest radio installed the death spl and updated to the latest recovery but I still cant get any other rom to flash, can anyone help
Click to expand...
Click to collapse
what rom are you currently trying to flash?
what does logcat show while it's loading? (adb shell logcat)
is it stuck at the G1 screen or at the HTC animated screen?
what ext partition do you have? (type and size)
Did you wipe your ext partition, data and system first?
Yes I followed all the instructions doing a full wipe I repartitioned the sd card I changed the swap to required values. I was stuck at the HTC screen.
Since then I have managed to get kingklix Legend2g1 to flash it took nearly 20 minutes to boot but now works perfect.
Still cant flash Jacheroski rom though but I think it was the swap that needed to change, I tried to put a large swap on to help speed the rom up but it only seems to flash on 96 swap.
I'm having a strange issue with my N1. If I try to apply a theme to any rom I get a boot loop. I've tried this on CM6 after a complete wipe, I've tried it on Pauls Desire Rom. I've tried it on RoDrIgUeZsTyLe rom. I've tried glass theme, NexTheme 2.2. Every theme I try seems to put me in a boot loop. Anyone have any idea what it could be?
As stated I have tried a complete wipe, fresh install and then the theme and nothing works.
You need to apply a theme ONLY to a specific ROM that this theme is made for.
Unless you do that, you get a boot loop.
So nothing strange here...
Jack_R1 said:
You need to apply a theme ONLY to a specific ROM that this theme is made for.
Unless you do that, you get a boot loop.
So nothing strange here...
Click to expand...
Click to collapse
Maybe I didn't make that clear. I am using the correct theme for the correct rom. NexTheme 2.2 is for CM3 RC3 which is what I tried to apply it to and got a boot loop. But in the past I have gotten this problem with every rom I installed and tried to apply a theme too..
theme boot loop
I am having the same problem did you ever figure that out?