So in the middle of the day, I pulled my phone out of my pocket to check the time. I was faced with a black, backlit screen. It'd turn off and back on every 5 seconds or so. I pulled the battery, attempted to turn it on, but I was faced with the same black, backlit screen. It continued the cycle.
I tried powering it on in bootloader mode. This caused the backlight to stay on continuously, but again, nothing on the screen. No M logo, not even a faint hint of text.
Is this phone done for?
It may be possible that it is just the screen, however I do not have the phone to look at it. If you plug it in when it is powered on do you get a recognized device on windows/linux?
The wires connecting the LCD screen could also be loose. If you are at all tech savy you might try taking it apart and looking at it.
The Droid is an amazing phone, but it is getting outdated pretty fast. I still use the Moto Droid and have no problems.
Do you have the insurance with Asurion? if so you can send it in and they charge like $50 to replace the phone.
xslntx said:
So in the middle of the day, I pulled my phone out of my pocket to check the time. I was faced with a black, backlit screen. It'd turn off and back on every 5 seconds or so. I pulled the battery, attempted to turn it on, but I was faced with the same black, backlit screen. It continued the cycle.
I tried powering it on in bootloader mode. This caused the backlight to stay on continuously, but again, nothing on the screen. No M logo, not even a faint hint of text.
Is this phone done for?
Click to expand...
Click to collapse
I would contact the manufacturer/carrier if there is still a warranty. If not, I would still contact to see if there is anything they can recommend, or if they will fix it for a minimal fee. Otherwise, look up how to take apart your milestone/droid on these forums and check for a loose connection or something. If all else fails, you may be able to buy a replacement screen. Those are the steps I would follow, but contact motorola/carrier first no matter what.
Good luck.
Related
My camera led light just started acting funny an hour ago. It turned on and it si now impossible to turn the damn thing off. It still stays on when the phone is turned off. I've tried removing the battery and then put it back again. As soon as the battery is in, the light turns on again. I've tried a soft reset and ultimately a hard reset. Light remains on.
Don't want to have to go to Sony for this because I bought the phone off the bay a month ago and therefore don't have a receipt so it won't fall under warranty. Anyone have any ideas? What a pisser.
hi,same here
I think its a hardware issue where the cables have been short and are giving direct connection. I dont know if this will work but try to tap the phone a little hard on your palm. If its just a loose contact it might get sorted. This is a very crude way.
You guys want help or just venting air?
Great story.... so ?!
If you guys want venting off air, that was it! If you are looking for help however, then KINDLY state some info, like:
what the frak is the phone model, firmware, recently flashed, if so to what. Branded or unbranded, built date, etc.!
After that, perhaps a few answers can be expected
MichaeltheImage: I doubt that in this case this had anything to do with software because of the fact that it remained on after a boot or when the phone is off.
Moleculez: Yesterday it ended up fading by itself after 2 or 3 hours. This morning it started again as I removed the battery. Tapped the led side of the phone on my palm a few times; and it worked. Thanks.
"Anything mechanical, give it a good bash."
Incase someone is still looking for a way to fix this problem:
I managed to pry the plastic covering off of the camera lense/ LED with a needle.
All it took was a slight nudge on the LED cluster to reposition it. It was situated slightly off to one side, causing the short circuit which lead to the LED being constantly lit.
Problem is, in my initial frustration I poked the LED and broke it which, as a result of the short, meant that although the LED was no longer lit it still drew power from the battery.
The only way I know that the later fix worked was by using a power consumption monitoring tool to verify that the LED (and the short circuit) was no longer drawing power.
Awesome.
hey boys
thought I'd post this to be sure my phone doesn't have a defect.
Sometimes. and I mean Sometimes. Maybe 1 reboot out of 10...
I turn off my phone.
When I turn it back on, my phone vibrates exactly 7 times and stops.
I cannot boot my phone back unless I remove/restore the battery.
Hardware failure imminent or simple bug?
You should plain straightly get your phone checked in Customer Centre- most probably a hardware problem!
hasn't happened since.
when I look back, it happened when I powered on my phone within 2 seconds of the phone completely powering off ...
if I want 1-2 extra seconds, no problemo.
i have the exact same problem. no idea why either.
For what it's worth, I notice that when the phone is going through the boot process right about the time the softkey lights under the screen light up the screen vibrates ever so slightly. I imagine this is normal behavior, perhaps the digitizer or the haptic feedback (engine/service/whatever) starting up. It's a very slight tremor that you might even miss if you're holding the phone in hand.
Is this similar to the issue you two have seen, only stronger?
Here's what is going on...
My Galaxy S I9000 (Bell Canada) was water damaged, after being dried for many days it turned on, but the battery almost immediately drained. I left the phone and forgot about it. Bought a new cheap phone without a SIM.
More recently I got a new battery for it and it turned on and was working great, staying charged and everything. When I went to the service provider to get a new SIM for it, we powered down the phone, pulled the battery and SIM card and put the new SIM in followed by the battery. Afterwards the phone would not power on, but the two face buttons on either side of the 'Home' button lit up and would react to touch. I tried removing the battery and SIM a few times and would get the same result.
After bringing my phone home and leaving it with the battery out for a few days, I thought I would try it again. It powered up again as if nothing was wrong. To test it again, I pulled the battery and SIM, replaced them, and my black screen/won't turn on problem returned.
Every so often it will power on and be useable. It is recognized by Kies, I've flashed it to firmware 2.3.4.
I'm looking for any helpful suggestions for what might solve my problem. I'm wondering if it's a hardware problem and short of isolating the part of the phone that is faulty and replacing it, the phone is toast.
Thanks for your time, and I apologize for the length of my post.
My friend has dropped the SGS into a pool before. Problem was fix after buying a new battery.
Either: Damaged screen + Contact. Or the reaction with water and the battery. hydrogen gas prevents screen from connecting to main-board.
It still turns on occasionally, and when it powers up, it's as if nothing is wrong. Screen works, displays everything fine, colour is crisp, screen reacts to touch. The big problem is it won't turn on all the time. Would what you said still explain this?
tacotbone said:
It still turns on occasionally, and when it powers up, it's as if nothing is wrong. Screen works, displays everything fine, colour is crisp, screen reacts to touch. The big problem is it won't turn on all the time. Would what you said still explain this?
Click to expand...
Click to collapse
The only thing I know (assuming the screen or motherboard is 100% functioning) is hydrogen gas being present. You might know TV remote with old battery casually respond to presses. After cleaning contacts it should work again.
I disassembled the phone and cleaned all the contacts on the main board with rubbing alcohol, I did not do anything to the screen though. Should I try taking it apart again and breaking it down further? (ie. separate the screen?)
tacotbone said:
I disassembled the phone and cleaned all the contacts on the main board with rubbing alcohol, I did not do anything to the screen though. Should I try taking it apart again and breaking it down further? (ie. separate the screen?)
Click to expand...
Click to collapse
No, I am starting to think it's a hardware fault if that didn't work
So I recently cracked the screen on my HTC One m7. I bought a replacement screen and front housing. The screen was so far beyond repair that I couldn't shut off the phone prior to starting the replacement. I tried waiting for the phone to die but after two days I became impatient and did it anyway (essentially the phone lost power when I disconnected the battery). After transferring all parts into the new housing and being what I though as diligent putting all parts and connections back in their place, tried to power the phone back on. all that happens is that the back and home buttons flash and then I hear what sounds like the audio for when the phone powers on. The screen stays black and then phone doesn't technically turn on. I know this because I have missed messages and the green led light would be flashing if it was. Therefore, at this point I'm not certain that the new screen works or if I've connected it right. I've tried the numerous boot tricks with the volume buttons, nadda. I have had the phone on a charger for a full day and the same problems. (Disclaimer: I don't have the original charger, but I have been using this one for a long time). I do see the red charging led if I wiggle the charger in the input, but also just recently I saw a green led when doing this, which when the phone was working was a sign that it was fully charged. If anyone has a solution to my problem that would be great. I'm also interested on what's wrong, why this is happening, what might have caused this behavior? What do the flashing home and back buttons mean?
Howdy,
I've had the same problem, but my phone was shutdown allready. When I replaced the front screen, the phone won't boot. I would like to know if its anyway to get the files from sdcard down?
Thanks for the support!
So, one year ago, my C6602 felt on the water, for my bad, some of the waterproof doors were open. At first, it didnt damaged it at all, so i managed to turn it off, and wait cause we have a person who fix eletronic things. But, i was stupid. Even knowing that this would damage the phone, i did turned it on again...at first it were ok. One hour later, touch stoped working, couldnt turn the alarm clock off...then the screen goes off as well. Well, i did take it to stores who are specialized in cellphones and all of them told my cell was dead. Today, i decided to open it to see what the **** was happening, it turns out that i couldnt figure nothing out by myself, buttt i put the charger and got a red light. I though, its dead already, nothing bad will happen heeh. I let it for 4hrs~ charging, pressed the on buttom, but nothing happened, oh, at first, when i charged it a little, when i press the on/off buttom it would gave me 3 red notifications blinking, but that time it didnt. Instead, it went to green, and i could manage to access the cellphone on the computer (internal memory), all my files were there. Also, when chargin, it first showed me a red light, followed by a yellow/blank light, and, therefore, a green.
There is any chances that the cellphone isn't dead? Its this sorta of protection of your data what happened? Or the screen is really broken (and, by changing it, it'll be back to normal)? Thanks.
It seems that phone is turning on, but displays nothing. It may be display fault, but may be display related pcb malfunction also.