[Q] stuck on Samsung logo - Galaxy Tab Q&A, Help & Troubleshooting

I did a sucessful update to Gingerbread, everything worked fine. Then I tried to restore my applications from CWM Manager, it did run for a while then at reboot it got stuck. Galaxy Tab in the middle of the screen and sansung at the bottom. Can anybody please help me bring my tab back to life.

you are having Soft brick
you may follow the guide in this thread http://forum.xda-developers.com/showthread.php?t=1133590

Related

Factory reset doesn't work. how to reformat?

I have an galaxy s i9000m and it got rooted. After installing the Galaxy S Battery Icon mod and I rebooted my phone it just (apparently) bricked it. I went into the recovery mode and tried to factory reset but it didnt suceed. After reboot it either goes black after load screen or it proceeds to the start up mananger where I was confronted with a loop of "kernal something" and force close things. Before sending it to bell, is there a way I can fix it myself?
please help and thanks in advance!
Sent from my friends galaxy phone.
you got download mode ??
if so flash a 3 file firmware with pit and repartition
that should sort you out

[Q] samsung galaxy note loads to logo screen and stays there

samsung galaxy note, uk model will not load up, it stays at the samsung logo screen. I tried to hard reset and was unable to get to any other screen other than the samsung logo screen, so that was unsuccessful. I then downloaded odin3 v1.5 and firmware from sammobile: N7000XXKKA_N7000CPWKK3_N7000XXKK5_HOME.tar.md5
i followed this post on how to flash:
http://forum.xda-developers.com/showthread.php?t=1389693
after i completed the process, odin stated "pass" the phone restarted but still remained at the logo screen, so that was unsuccessful.
i dont know what to do next. Its been three days since ive used my phone. please help.
thankyou
Take your battery out for about 20 mins. If that dosent work
Try a reset. If that dosent work.
Try flashing
again.

Boot problem P1000

I was following these steps on the cyanogen mod wiki to flash my tab to CyanogenMod but now my tab is bricked?
I managed to install the clockworkmod recovery. But now my tab is stuck on the GalaxyTab Samsung screen. I suppose it got bricked here somehow. I followed all the steps and everything went fine. I can go on download mode and the clockworkmod recovery but the tab doesn't go pass the boot screen.
These were the last steps I did:
7- A blue transfer bar will appear on the device showing the kernel being transferred. The device will reboot automatically.
8- The Samsung Galaxy Tab now has the ClockworkMod Recovery installed. Continue to the next section.
Can someone help me? I tried to fix the dbdata with heimdall but no success.
My tab was rooted. I tried to do a factory reset as well but it doesn't work either.
Thank you!
EDIT: I installed another kernel and it seems to be working now.

[Q] Galaxy S Plus I9001 - Bootloop

Hey,
I had the cm9 on my I9001, now i want to have the stock rom, i downloaded the Stock rom, ArriesVE.ops, and Odin.
Than i flashed the ROM on my phone, after this was done, it restarts, i can see the White Samsung Logo , after this i see the "Samsung Galaxy S Plus" Logo, this logo stays for a few seconds and than my phone restarts again and all repeats..
What should I do
Maybe this would help you http://broodplank.net/old/flashsamsungi9001.php
Same Thing...
Gnampf7 .. did u find a way past that.... have been stuck @ de same point whole day now... flashed the stock ROM thrice... cleared cache... cant do a factory reset thou... its asking for a passcode i dont have.
any ideas??
Bootloop on i9001
Hi guys, i gonna tell you about how my i9001 was stuck in a bootloop. Maybe you could help me. I'm sick of it.
Cause: I installed cm10 and cwm5 or 6 as recovery and upgrade my device by using Ota Updater. When I restarted my i9001, it got stuck in a bootloop.
What my i9001 can display: It can access to rampdump mode and download mode. In case I try to turn on my i9001 or access to recovery mode the Samsung logo is shown twice. It often gets stuck showing the typical grey battery flat (with a loading stopped) and the black screen alternately.
Attempts: i've tried everything except for the right solution. Lots of forum threads and nothing works for me. I've tried:
1.- Boot_loader for device boot.
2.- I've flashed an stock rom: XXKQP, and 2 more: BVKPC y XXKQ1. Each one are official.
3.- And then recovery-clockwork-5.5.0.4 and -6.0.1.2.
4.- I've tried, then, flashing feamodrecovery 1.2.
5.- Nothing works for me.
I've been using Odin 4.43. AriesVE in OPS section and when flashing these roms: one package. For recovery packeges: one package and pda (I tried these two options).
I can't reach at recovery mode. Any help would be greatly appreciated. Greetings!
http://forum.xda-developers.com/showpost.php?p=51290392&postcount=13

Requesting help with Galaxy Ace S5830D stuck at boot screen

Hi,
Okay so I have a Galaxy Ace S5830. It was rooted etc with no problems. I was just running the stock ROM (Koodo) that it came with.
Earlier I took a backup with CWM, then I used ODIN to flash a different ROM that I got from a different thread. However this ROM was not working well for me, the network connection kept winking in and out, so I wanted to go back to my stock ROM.
I got the stock firmware from SamFirmware using my model + country. I then used ODIN to flash the stock ROM.
When I boot after doing this, I go into a bootloop between the Koodo splash screen and the glowing SAMSUNG logo.
To hopefully remedy this, I used CWM to restore the backup I had taken previously.
However, when I boot after doing this, there is no loop, the phone simply sits at a screen with a black background that says Samsung GALAXY Ace GT-S5830D in white lettering. I have left it for a substantial amount of time and nothing changes.
I have read some other threads and they all suggest re-flashing stock rom with ODIN which I have done to the same result. So at this point the firmware will not fully boot, whether or not I have restored the backup.
Any help in fixing this will be appreciated! I'm stuck and I don't know what to do at this point, other than try some other firmwares.
Thanks!
Update:
Thanks to ver3go I was able to get back to stock rom + factory settings. the bootloop issue has been resolved.
HOWEVER,
when I load from the backup I made with CWM, it freezes forever at the black + white samsung galaxy ace screen.
Any solutions would be great. Though it's not a huge issue, it would be nice to not have to re-install all my apps and reconfigure my phone
frozenreddy said:
Update:
Thanks to ver3go I was able to get back to stock rom + factory settings. the bootloop issue has been resolved.
HOWEVER,
when I load from the backup I made with CWM, it freezes forever at the black + white samsung galaxy ace screen.
Any solutions would be great. Though it's not a huge issue, it would be nice to not have to re-install all my apps and reconfigure my phone
Click to expand...
Click to collapse
Before restoring your back up, do 3 the wipes and then restore your backup

Categories

Resources