Hello,
my MTeor doesn't playing any sound and doesn't read any SIM card. I've installed 1.54 radio ROM, but it have this same problems.
How I can repair this?
Related
There are almost a week that my Qtek 9100 is unable to connect to my Phone network. It keeps searching and searching. When I click on Manual Network Selection, I receive an error msg: "Unable to read setting from the network. Try viewing settings later ou disconnect data connetion and try again". What should I do?
ROM version 2.24.10.1
ROM date 4/17/06
Radio Version 4.1.13.12
ExtROM version 2.24a Mr. Clean
The SIM card is ok (I´ve tried on another mobile)
Thx
Did you already tried a (òh , ooh) hard reset or reflash? Otherwise it seems you're phone-receiver circuit is defect; you've got to go for repairs...
I´ve tried both: hard reset and reflashing with new ROM....
Nothing
This started after my battery runned out of power....
It didn't occur by any change after a new update..?
And what about you're radio version: isn't it your protcolversion? So, what radio version had you before and which one now?
(btw seems stupid but... try new sim unlock)
No, I upgraded to the new ROM after the problem....
I did a mistake about the versions: My radio version is 02.25.11 and the protocol version is 4.1.13.12....
I really don´t know the number of the older version of the radio, but it was working fine.
btw, the mobile was bought unlocked...
Thx, anyway.....
¹ (...but did you try sim unlockin' again...?)
² (off course you tested it on other locations...?)
I'm trying to SIM unlocking again, using Lockwiz02b, as I downgraded to ROM 1.5.4.2 WWE, but I'm receiving an error msg: "Could not update itsutils.dll to the currente version, is it inuse?"
BTW, as I upgraded to ROM 2.24 in english (the original ROM was spanish) should I understand that my mobile is CID unlocked?
(Why did you downgrade, that's not necessary for simunlock?)
For your utills.dll fault: maybe you need lokiwiz0.3
http://forum.xda-developers.com/vie...=0&postorder=asc&highlight=lokiwiz0+3&start=0
...with lokiwiz you unlock CID because of brand crossing ROM use, in order to prevent trouble (once CID unlocked it stayes unlocked) For language change it shouldn't be necessary.
For SIM unlocking you also can use i.e. attached file.
Hi,
using the sticky guides, i've successfully [i think] SIM and CID unlocked my wizard g3 which is a TM MDA Vario.
I now cannot get it to connect to my mobile network (o2).
I've installed various ROMs including O2, TM, Cingular, wm6 and the CUSTOM__RUU_Wizard; all install OK but after the reset, still says "searching...".
I've also installed the various radio only upgrades from the sticky; again after the resets it still just says "searching...".
Have i got a brick?
It was working fine on a TM sim before the upgrade but that sim is now expired so i cant test a TM sim.
PS my wifi works fine, Async etc. and all the PDA functions fine, it's just the phone network that's the problem.
Cheers
try another sim from another network.
gusnor said:
Hi,
using the sticky guides, i've successfully [i think] SIM and CID unlocked my wizard g3 which is a TM MDA Vario.
I now cannot get it to connect to my mobile network (o2).
I've installed various ROMs including O2, TM, Cingular, wm6 and the CUSTOM__RUU_Wizard; all install OK but after the reset, still says "searching...".
I've also installed the various radio only upgrades from the sticky; again after the resets it still just says "searching...".
Have i got a brick?
It was working fine on a TM sim before the upgrade but that sim is now expired so i cant test a TM sim.
PS my wifi works fine, Async etc. and all the PDA functions fine, it's just the phone network that's the problem.
Cheers
Click to expand...
Click to collapse
What is your IPL, SPL, GSM, and OS? Soft reset and copy these off the screen as it boots up. If you are in the state I think you are in it is because you flashed a 2.x rom into 1.x bootloaders and skipped the step of flashing your carriers latest rom before flashing a custom rom. This is just a guess because you haven't given much information, I apologize if I have it wrong. Give us more info and we can probably get you fixed up.
Also do you have a valid SIM card to test with? if your sim is expired as you mention it probably won't connect to the network which may be why it is searching. Unlocking just allows you to use sims from other carriers on your phone not allow you to use an invalid sim on any network.
thanks for the response.
I've tried several O2 sims that i know work and can get a signal where i am, i dont have any different sim types.
Since running lokwiz i havn't been asked to enter a code etc when inserting a sim other than TM ?
Anyway, my details are:
IPL 1.01
SPL 1.0
GSM 1.12.10.0
OS 1.5.4.2
This is because the last effort involved going through the instructions in the stick for unlocking the wizard which means flashing using:
CUSTOM__RUU_Wizard_1050412_WWE_101_11210_WWE.exe
Thanks again
gusnor said:
thanks for the response.
I've tried several O2 sims that i know work and can get a signal where i am, i dont have any different sim types.
Since running lokwiz i havn't been asked to enter a code etc when inserting a sim other than TM ?
Anyway, my details are:
IPL 1.01
SPL 1.0
GSM 1.12.10.0
OS 1.5.4.2
This is because the last effort involved going through the instructions in the stick for unlocking the wizard which means flashing using:
CUSTOM__RUU_Wizard_1050412_WWE_101_11210_WWE.exe
Thanks again
Click to expand...
Click to collapse
hrm, it looks like it should work. I would flash the T-Mobile 2.26 rom and update to AKU2.x. Then flash an AKU2.x custom rom of your choice (If you desire to do so.) The lowest I have ever flashed my device is the 1.05 button rom, but then always flashed back up to the Cingular 2.25 rom before installing a custom rom. I don't see why your setup would be an issue unless the radio you are using isn't compatible with that OS. Maybe others that are more versed in this stuff than I am can help.
I´ve a HTC 3600 and installed Hard-SPL Olipro 1.20 then executed the application for releasing the Sim and CID restrictions of my HTC.
I keept the WM5 ROM and tested the device. The Sim is now unlocked, i suppose so is CID, how can I check this before installing a new cooked ROM?
My gps was working fine, now I can´t get gps signal, do I need a radio update? Which is recommended? Did the sim unlocking process downgraded my radio rom
ROM: 1.23.410.2
RADIO: 1.16.00.00
thanks in advance
you are right
Unlocking P3600 downgrades the radio...
Therefore you cannot use GPS until you upgrade the radio again.
Take a look here, http://trinityguides.info/index.php , choose a gps enabled radio and upgrade...
Thanks, I also thought that.
Which of the Radio Rom´s should I choose?
Radio 1.38.00.11
Radio 1.41.00.11
Radio 1.46.00.11/30.11
Radio 1.50.08.11
How I can I check if my CID was succesfully unlocked? I want to install a new ROM with a different language.
If you installed hard spl on your device, it doesn't matter if you have cid unlocked or not, cause hardspl let's you install any rom in any language.
As for the radio, it depend's on your carrier and the country you are in.
I see you are in Portugal so you can use the latest version (Radio 1.50.08.11), it works just fine for me.
Humm, I´ve read that the latest ROM cause mora battery drain than the others, is this true?
What improvements are present in the latest ROM´s compared to 1.38 ?
Hi I have a O2 XDA IIi and I upgraded the rom to
ROM: 1.11.00 WWE
Radio: 1.00.00
Ext ROM: 1.11.169
The thing is i have done the upgrade without CID unlocking the phone but used the all unlocking software ver.1.5 to unlock!Everything went ok but the only problem is that now the phone in the signal bar has an exclamation mark and says no service!
I have tried to flash the phone with sever other rom, but its the same,still no signal.
I am not able to use the ph any more, please help!
try one of these from this link
http://forum.xda-developers.com/showthread.php?t=249474
Hi David the problem continues. I did use the tool.
I tried this site to unlock mine and it did work after some experimentation
http://www.buzzdev.net/downloads.php?category=29
You will need to register to downlaod but you should find one that works...
I have similar issue when unlocking my Diamond with Olipro tool. So what was essentially the problem here??? Was it a bad radio rom that causes the exclamation mark, or bad CID unlock before the SIM unlock radio gets loaded.
Hi I have a O2 XDA IIi and I upgraded the rom to
ROM: 1.11.00 WWE
Radio: 1.00.00
Ext ROM: 1.11.169
The thing is i have done the upgrade without CID unlocking the phone but used the all unlocking software ver.1.5 to unlock!Everything went ok but the only problem is that now the phone in the signal bar has an exclamation mark and says no service!
I have tried to flash the phone with sever other rom, but its the same,still no signal.
I am not able to use the ph any more, please help!
Latest unlocking tool
Have used this but no use. Same problem continues.....
i;ve had a similar problem using olipro unlock on my diamond. Just get the exclamation mark on all networks. I have a feeling it might be an issue with the radio. Any updates on this...did you get your device to work????