So I recently messed up my phone and had to flash a few things using CMD while my phone was in AP Fastboot. Well everytime I boot it it automatically goes to the APFastboot Failure screen, So then I have to turn it off, hold Vol. + & - and then choose normal boot. I do have safestrap tweaked 1.08 installed on it. Any suggestiuons as to what to do?
Related
was using my nexus one as i was switched it off removed the sim card from this phone placed it in another phone... left my nexus one on charge and turned it on left the room when i got the vibrate didnt even saw wether it was completly on or not... came back home saw the phone off... tried to turn it on but it wouldnt.... then connected the charger to the phone then turned it on and it shows a X and a unlocked sign at the bottom stays for a while and then the screen gets black and the same thing happens over and over again
Its going in a reboot loop I think.
Try going into the bootloader by pressing the trackball and power button together.
and then enter bootloader and then recovery.
In the recovery select reboot.
Btw do you have a nandroid backup?
I do have a backup lying around somewhere but i'm not sure of that. And i tried that boot loader thing but when i go to that menu as soon as i press the volume - button the phone boots off again
did you try the 3 finger:
pwr/vol-/trkball at same time may take up to 20 seconds to boot into bootloader
or, may need to use fastboot from command terminal and flash new recovery/rom like passimg to go back to stock then upgrade from there
pass image method is in wiki
Try this:
- Press the power button and the trackball together
- Select Bootloader and then Recovery
- Flash a different ROM (Stock\CM\MIUI\or try flashing again your current rom)
- If it doesn't work, flash a new rom AND wipe data and cache
tried to update using sd card and oreo update after doing factory reset.
1. was on stock 2BQK2
2. downloaded BQK2 (N OS) to CQL1 (OREO).zip added to sd
3. did fsactory reset from recover
4. then went up to update from recovery. ran the file above.
5. when i rebooted i get stuck on boot screen
steps taken.
1. hold down bixby and up volume then power ....does nothing
2. hold down just power does nothing
3. hold down bixby vlume up and power does nothing
4. hreboots back yo boot screen then stops on boot screen
5. hold down volume then power 7 seconds until screen turns black and just before she reboots i let go of volune down and power then immidiately hold down volume again without power button, this seems to torn off phone.
so as you see i cant get into download, recovery or safe mode. just start to boot screen or off
please i know i want to odin stock filmware back but cant seem to get phone into download mode.
i,m tired and most likly nissed an important step help please.
I do no see where you tried download mode... Hold volume down bixby and power for about 2min. That will get you to download
Ok I can get it in download mode
I get Odin to recognize.
Fill up the slots
BL
AP
CL
CSC?
USM
Using latest Verizon .
I eitther get stuck on setup initialize or
Update fail.
pospower said:
Ok I can get it in download mode
I get Odin to recognize.
Fill up the slots
BL
AP
CL
CSC?
USM
Using latest Verizon .
I eitther get stuck on setup initialize or
Update fail.
Click to expand...
Click to collapse
if you get stuck at setup connection or initialize try a different usbport/cable/computer
Hey guys,
So I'm having issues trying to fix my Samsung Tab A 10.1 ( SM-T510 ).
At first I was trying to install a custom TWRP recovery image, and I had a boot loop where it kept getting stuck at the SAMSUNG splash screen(not the initial samsung boot screen that shows TAB A 10.1). I however overcame that issue by factory reseting and through some additional tinkering.
Now the part I'm starting to regret.
I tried once again to flash the custom TWRP to the tablet, but this time I forgot to tick the "autoreboot" setting off.
So ODIN shows a PASS for the flash, but now when the tablet boots its stuck in the following boot sequence:
START:
Initial Samsung boot screen asking to press power button to continue due to unknown boot image source etc
PRESS POWER
SAME INITIAL SAMSUNG BOOT SCREEN minus the power button prompt, lasts for about 3-5 seconds
REBOOT
Now I have managed to get into download mode with the tablet connected to a computer.
I CANNOT get into recovery mode to factory reset the tablet, which was the solution the last go around.
I am starting to think that the only way I am going to get the tablet back in original working order, or any working order for that matter is to:
A: LOCATE original firmware for my device, I believe it is GTAXLWIFI firmware for my device. However the files I have found don't seem to be accepted in ODIN...
B: Try to continue on with the TWRP process, which I have tried to reflash the TWRP recovery that I have, and it shows pass. But, the issue persists.
Any suggestions or help would be amazing!
Thanks!
Timing is the key
Set your finger on position where you gonna restart the device.
Hold power + vol down
After the screen restart switch soon as possible you finger to set to recovery by
Hold vol up + down + insert the USB C cable
Remember timing is the key. I have done this for several tabs that screw on my home so you are welcome bro
frontchasack said:
Hey guys,
So I'm having issues trying to fix my Samsung Tab A 10.1 ( SM-T510 ).
At first I was trying to install a custom TWRP recovery image, and I had a boot loop where it kept getting stuck at the SAMSUNG splash screen(not the initial samsung boot screen that shows TAB A 10.1). I however overcame that issue by factory reseting and through some additional tinkering.
Now the part I'm starting to regret.
I tried once again to flash the custom TWRP to the tablet, but this time I forgot to tick the "autoreboot" setting off.
So ODIN shows a PASS for the flash, but now when the tablet boots its stuck in the following boot sequence:
START:
Initial Samsung boot screen asking to press power button to continue due to unknown boot image source etc
PRESS POWER
SAME INITIAL SAMSUNG BOOT SCREEN minus the power button prompt, lasts for about 3-5 seconds
REBOOT
Now I have managed to get into download mode with the tablet connected to a computer.
I CANNOT get into recovery mode to factory reset the tablet, which was the solution the last go around.
I am starting to think that the only way I am going to get the tablet back in original working order, or any working order for that matter is to:
A: LOCATE original firmware for my device, I believe it is GTAXLWIFI firmware for my device. However the files I have found don't seem to be accepted in ODIN...
B: Try to continue on with the TWRP process, which I have tried to reflash the TWRP recovery that I have, and it shows pass. But, the issue persists.
Any suggestions or help would be amazing!
Thanks!
Click to expand...
Click to collapse
Original firmware I used to fix my sm-t510
Account Suspended
flavarasa said:
Timing is the key
Set your finger on position where you gonna restart the device.
Hold power + vol down
After the screen restart switch soon as possible you finger to set to recovery by
Hold vol up + down + insert the USB C cable
Remember timing is the key. I have done this for several tabs that screw on my home so you are welcome bro
Click to expand...
Click to collapse
I think "restarts" may be confusing. Switch from down to up as soon as the screen turns off.
frontchasack said:
Hey guys,
So I'm having issues trying to fix my Samsung Tab A 10.1 ( SM-T510 ).
At first I was trying to install a custom TWRP recovery image, and I had a boot loop where it kept getting stuck at the SAMSUNG splash screen(not the initial samsung boot screen that shows TAB A 10.1). I however overcame that issue by factory reseting and through some additional tinkering.
Now the part I'm starting to regret.
I tried once again to flash the custom TWRP to the tablet, but this time I forgot to tick the "autoreboot" setting off.
So ODIN shows a PASS for the flash, but now when the tablet boots its stuck in the following boot sequence:
START:
Initial Samsung boot screen asking to press power button to continue due to unknown boot image source etc
PRESS POWER
SAME INITIAL SAMSUNG BOOT SCREEN minus the power button prompt, lasts for about 3-5 seconds
REBOOT
Now I have managed to get into download mode with the tablet connected to a computer.
I CANNOT get into recovery mode to factory reset the tablet, which was the solution the last go around.
I am starting to think that the only way I am going to get the tablet back in original working order, or any working order for that matter is to:
A: LOCATE original firmware for my device, I believe it is GTAXLWIFI firmware for my device. However the files I have found don't seem to be accepted in ODIN...
B: Try to continue on with the TWRP process, which I have tried to reflash the TWRP recovery that I have, and it shows pass. But, the issue persists.
Any suggestions or help would be amazing!
Thanks!
Click to expand...
Click to collapse
You can use frija.exe to get the latest stock firmware. To get TWRP you MUST boot to recovery before system. If you allow the tablet to boot to system first, it will overwrite TWRP with the stock recovery. Do this by pressing vol down and power till the screen turns off. As soon as it does, switch from vol down to up while still pressing power and keep holding both till the red warning message appears. You also need to leave the cable attached to the PC while doing this.
My mum tried to do the last update on her phone, during which most probably battery ran out - now phone is basically a brick.
When turned on it's stuck on logo loop, rebooting itself every 5-10 seconds or so vibrating once and repeating. When unplugged or plugged into the wall none of the button combinations work - the phone basically ignores everything.
When plugged to PC via USB I can invoke "updating process"? with Volume Up + Power / Volume Up combination, which should lead me to recovery menu - instead the phone goes into "update", loads bar up to 25%, gets stuck for about a minute or so, reboots and goes into logo loop.
Hard reset also "works" when plugged into PC - update screen shows up, gets stuck on 1%, phone gets hard rebooted, update comes up again, goes up to 25%, reboots and on to the logo loop...
Can I even somehow get into recovery mode to wipe cache to allow the phone to get update again or even wipe data to flash custom ROM? Screw data, I just want to make it work and not have a brick lying on the desk...
UnableToSee said:
My mum tried to do the last update on her phone, during which most probably battery ran out - now phone is basically a brick.
When turned on it's stuck on logo loop, rebooting itself every 5-10 seconds or so vibrating once and repeating. When unplugged or plugged into the wall none of the button combinations work - the phone basically ignores everything.
When plugged to PC via USB I can invoke "updating process"? with Volume Up + Power / Volume Up combination, which should lead me to recovery menu - instead the phone goes into "update", loads bar up to 25%, gets stuck for about a minute or so, reboots and goes into logo loop.
Hard reset also "works" when plugged into PC - update screen shows up, gets stuck on 1%, phone gets hard rebooted, update comes up again, goes up to 25%, reboots and on to the logo loop...
Can I even somehow get into recovery mode to wipe cache to allow the phone to get update again or even wipe data to flash custom ROM? Screw data, I just want to make it work and not have a brick lying on the desk...
Click to expand...
Click to collapse
Have you tried using reiboot-for-android.exe by Tenorshare Co Ltd? Might help. Or if the device is within warranty then try Service Centers for that device.
You can try flashing stock rom from odin.
Download your current stock rom from samfw.com and extract the zip file.
Install odin and samsung usb drivers (link) and reboot your pc.
Reboot into download mode from your phone and press volume up:
Keep USB connected, Hold Volume Down and Power buttons, When screen turns off, hold Volume Up and Volume Down buttons
Click to expand...
Click to collapse
Open odin and load the files:
AP = AP*.tar.md5, BL = BL*.tar.md5, CP = CP*.tar.md5, CSC = CSC*.tar.md5
Click to expand...
Click to collapse
Click flash and wait till it says pass
Press and hold volume down and power to reboot. The first boot can take a while. Hopefully this will fix it.
Moin,
My phone was one day suddenly unable to boot into system nor Recovery, but could still enter fastboot.
Took me a while to figure out that USB Hubs let flash attempts fail too. (you can watch the drama in my older posts)
Now i was able to flash System back into a workable state and it looks like that recovery is also successful flashed.
BUT...i can enter recovery only ONCE per Vol - and Power on Button.
i have NO OTHER WAY to enter Recovery at all. i have no reboot option in system (LOS 18.1).
In fastboot/adb command and after one succsesfull reboot per keys, it always stuck after the Sony logo into a black screen. i then have to restart it into system with Vol+ and Power (one vibration) or shut down with vol+ and power for 6 seconds (three vibration) to get it either into fastboot (Vol+ and USB connect) or system again. then i have to flash it again to get into TWRP once. i tryed the latest twrp version (3.7.0) and one older version (3.3.1) that had once worked until the phone broke.
Any idea what is going wrong here. i have already try to completly wipe everything from the phone and try to fix SEL Linux in twrp. nothing seems to work. Did i miss something?
/€: Now it is again in the full broken state. recovery nor System won't boot anymore and end in a black screen.
/€²: Found the Problem: my lilca zip was polluted with altered files i forgot about.