My charging port has broke!, easiest way to fix it? i have checked on ebay they only sell the port by its self with out the pcb board attached,
Related
I think I messed up my plug on the bottom -of my Kaiser. I have to wiggle the cord to get it to charge. Anyone have any experience with working on these or replacing the plug ?
USB connector
Call HTC repair center. They are going to make you pay to replace the mother board as the USB connector is attached to it. They charge around US295.00 so I do not think you messed it up but is not working anymore?.....
Oh something else they will keep your messed up mother board maybe for other repairs...
is there a place where i could find an actual charging port for the kaiser? apparantly my charging port is finished.. i need to get a replacement and dont care if i need to solder
Search for replacement USB for Kaiser.
I'm having a bit of an issue with my usb port where I need to push the cable upwards (if you are facing the phones screen) in order for the phone to begin charging. It also is taking a little longer than normal. I have tried a different cable as well with the same result.
Is there anyway to repair the usb port on the HD7? I just took the case apart on the back, but the port is still shielded. Is there any instructions out there on how to replace this port?
Iron soldering or a new board, your choice.
try with the soldering, if that fails, a new board must be bought, it cost around $25-$35 online.
where can i get usb charging port part for my defy MB525 Green lens which has a small cable which connects to a IC its quite different from mb526 usb charging port :cyclops:
Might be able to find spare parts somewhere
So I've ended up destroying (the charging circuit) my I9000 by removing the usb connector the wrong way. I've followed this guide
but I was to impatient with heating up the usb connector., Because of that the copper pads came along with the pins of the usb connector.
So now my question. Is it still possible to make the charging circuit work?
I've found these two images. Source 1 and Source 2. I don't know if the images are right, can anybody confirm this?
But if I run wires from the pins of the usb connector to the components in the image would it make the charging system work again?
Or are there any other smart solutions to fix this issue?