this is not a repeated topic
i searched all the web for solution but i couldn't find any
my At&t tilt is unlocked it works perfectly for short time ever few resets
else, it give the message "the sim card is missing" you can srtill make emergency calls if your provider supports it
i tried every thing, unlocker, hard spl, all the tools herebut nothing worked
can any body help?
Any chance the SIM is loose in its mounting?
It looks to me like there is a bit is wiggle space in the SIM slot.
did you try another SIM card?
cmegascharf said:
this is not a repeated topic
i searched all the web for solution but i couldn't find any
my At&t tilt is unlocked it works perfectly for short time ever few resets
else, it give the message "the sim card is missing" you can srtill make emergency calls if your provider supports it
i tried every thing, unlocker, hard spl, all the tools herebut nothing worked
can any body help?
Click to expand...
Click to collapse
One of my kaisers uses an old sim where a layer of laminate had been peeling away. This meant that when I inserted the sim, the loose laminate folded back on itself and acted as an insulator between the brass phone and sim contacts. So I removed the offending laminate but still had the occasional "no sim installed". The problem was that the sim was now a little thinner. I applied pressure to the centre of the metal belt that holds the sim in place ensuring that the contacts were "always together" and have not had any problem since.
I hope this simple solution works for you.
Regards,
J
ANother thing you can try is rubbing the gold portion of the SIM card on your jeans or clean it off with a pencil eraser. I had that problem, and it stemmed from a little corrosion or crud building up on the face of the SIM card, and by rubbing it on my jeans it cleaned the corrosion off and the sim was able to make good contact with the points in the card slot.
Sometimes sim cards go bad. I've had about half a dozen go bad out of about 40 devices that I have supported over the last couple of years. AT&T acts like it's a common occurence and no big deal. I just take the device to one of their storefronts and they replace it immediately.
alt236 said:
Any chance the SIM is loose in its mounting?
It looks to me like there is a bit is wiggle space in the SIM slot.
Click to expand...
Click to collapse
i'm not sure, but i tried to add a sticker to the sim card's back but it didn't work
also the mounting seems fine to me
how can i bee sure
g-fall said:
did you try another SIM card?
Click to expand...
Click to collapse
i tried another 5 working sim cards
i have another tilt it's working perfectly with all the other sim cards
[email protected] said:
One of my kaisers uses an old sim where a layer of laminate had been peeling away. This meant that when I inserted the sim, the loose laminate folded back on itself and acted as an insulator between the brass phone and sim contacts. So I removed the offending laminate but still had the occasional "no sim installed". The problem was that the sim was now a little thinner. I applied pressure to the centre of the metal belt that holds the sim in place ensuring that the contacts were "always together" and have not had any problem since.
I hope this simple solution works for you.
Regards,
J
Click to expand...
Click to collapse
thanks alot for ur support
but i tried many other sim cardss
the problem is that is work some time with out any reasons then go "sim card is missing again"
snooginsguy said:
ANother thing you can try is rubbing the gold portion of the SIM card on your jeans or clean it off with a pencil eraser. I had that problem, and it stemmed from a little corrosion or crud building up on the face of the SIM card, and by rubbing it on my jeans it cleaned the corrosion off and the sim was able to make good contact with the points in the card slot.
Click to expand...
Click to collapse
thanks alot
but i tried many other working sim cards "in other att tilts" but it didn't work
mitchrl said:
Sometimes sim cards go bad. I've had about half a dozen go bad out of about 40 devices that I have supported over the last couple of years. AT&T acts like it's a common occurence and no big deal. I just take the device to one of their storefronts and they replace it immediately.
Click to expand...
Click to collapse
i tried lots of other sim cards
thanks every one for ur responses
but i have a feeling this tilt was wae wrongly unlocked
does any one agree with me
is there any way to restore every thing it's initial conditions?
i'm getting frustrated here
Did you try unplugging the battery, put the sim card and then reinsert the battery and start?
[email protected] said:
One of my kaisers uses an old sim where a layer of laminate had been peeling away. This meant that when I inserted the sim, the loose laminate folded back on itself and acted as an insulator between the brass phone and sim contacts. So I removed the offending laminate but still had the occasional "no sim installed". The problem was that the sim was now a little thinner. I applied pressure to the centre of the metal belt that holds the sim in place ensuring that the contacts were "always together" and have not had any problem since.
I hope this simple solution works for you.
Regards,
J
Click to expand...
Click to collapse
hey just wanted to say thanks. i just added a piece of paper between the card and the metal part and it worked. just wanted to say thanks.
I had the very same problem today after putting a brand new sim in the phone.
Found that I had put the damn sim in the wrong way round. Oops.
I had the exact same problem and in my case, putting a piece of paper in did not help at all. I had to get a brand new sim card.
i had a similar problem. it couldn't read my sim card, but read my gf's tmobile sim card and her phone read my sim card fine. then i next day i took it to an ATT shop, asked for a new sim card and it worked perfectly fine now. even the guy from the shop couldn't tell me what is the problem, he said, it happens every now and then.
my sim card is not workin only can make emergency calls,what is the problem??
darrellkelly93 said:
my sim card is not workin only can make emergency calls,what is the problem??
Click to expand...
Click to collapse
umm your service is disconnected?????
no,its not reading the card slot at all
This may be a stupid question- is the SIM card in the proper way? When did this start? What changed? Did you drop the phone?
darrellkelly93 said:
my sim card is not workin only can make emergency calls,what is the problem??
Click to expand...
Click to collapse
When I first bought my Tilt used, I had the same problem. I had to stick a tiny part of a post-it to the back of my SIM and shove it in there. It's like my SIM wasn't thick enough.
The best way - to try with another SIM (maybe your friends have a mobile-phone )
Sometimes the old SIMs don't want to work with modern devices....
well heres my 2 cents as i just fixed it, my issue at first i thought it was the sim slot (replaced...) then found out the ribbon was damaged a crack occured, after another week of waiting for a package (today) i replaced it and now its running fine
Same here
My Sim was no longer available.
Kaiser had "sim card is missing", but the sim was in there.
I disassebled it and found that the main flex cable was damaged.
Now I'm waiting for replacement.
So, When the phone shows up "sim missing" it's an flex cable matter not the sim card flex or the sim card unit.
same problem here
I'm having the same problem here. thought that it was the flex cable of the sim, but when I disassambled the Kaiser I found out that the main cable was slightly scrached from a corner, and the sim's cable was there pluged well... I'm trying to fix it..gonna post the result for "sim card failure"...
Well I bought Nexus 5. Because of that I had to get a Micro SIM card to fit in it.
I bought another Micro -to- Normal SIM adapter. Like an external Jacket so that I can use the same SIM in my SGS Advance.
Now, because of the SIM holder design, the terminals might have gotten a little worn out due to inserting and removing the SIM card.
But What I dont understand is, it was working fine until suddenly my SGS Advance stopped recognising my SIM card.
Ok.
So I tried other SIM cards. Still the same result. Mind you, the phone was recognising the SIM Card(s) before it was stopped recognising.
Cause for it :
1.physical damage
well I dont think so cause I dont see if there are any terminals missing or something out of place or anything that has fallen off.
2.Software issue.
Please help me. And yeah Phones outta warranty period running 2.3.6 & yeah thats about it. Please see image below. Top notification bar just right of the mid line, symbol that no SIM card is inserted.
Hello. Was in a hurry and attempted to pull out the Sim card (nano with an adapter) in my xt1064 and ended up removing it, but the phone no longer recognizes any SIM cards. I contacted a local repair and was told the SIM tray is soldered to main board. I did see this video which shows the dual-sim variant as removable (see at 4;45-5:00 min (http://youtu.be/l29IvoYolh8) SIM cards go inside (but not as before), but do pish in and eject OK. I read online re: trying to align pins in the tray, but didn't see a good tutorial. I did open the phone and the tray is not easily openable (see a spring on the side). So how would I go about trying to get this repaired? Looked at etradesuppky and just saw few major parts (screen, housing, battery), unlike a lot more small components avail for xt1032. Any ideas/suggestions? This had to happen right after I flashed an updated lollipop 5.0.1 with success after few weeks of waiting. Thanks for any input.
Like you said it sounds like the SIM pins might be damaged. If you're pretty confident about tinkering with it yourself then be careful and continue Or else just take it to a service center.
Can someone post a close-up macro picture of the SIM tray? I can't seemed to figure out how the pins should look like? Is there a guide/tutorial on how they should look/work? Thanks A LOT.
Since yesterday my phone can't detect both my Sim card. It said no Sim inserted. All the while is working fine. Any solution on this? I'm not using sim adapter. I changed already 2 different Sim card and mostly i only got message new sim card inserted Restart to take effect. But after bit completed it still no Sim detected.
The SIM-slots of the Moto G are a very weak part of the phone, I had problems from the very first day to insert the cards correctly. After a short time the one slot doesn´t snap the card into place anymore,the whole construction is not build precise.
I had a few issues in not detecting the SIM card, after all I sticked a piece of thin plastic (or paper) on the top of the SIM´s to be certain that they stay tight at their places and if I´ve found the exact position everything works. So in my case it was a mechanical problem.