Hi,
The battery cover is not flush with the device. Only on the left side.
Does anyone else have this problem?? I bought the phone used, but this issue was not mentioned.
Thanks
milkchug2000 said:
Hi,
The battery cover is not flush with the device. Only on the left side.
Does anyone else have this problem?? I bought the phone used, but this issue was not mentioned.
Thanks
Click to expand...
Click to collapse
Are you mean the battery cover cant closed nicely?
if yes,ok we dont have that issue. and you must know that is hardware problem
maybe you need to change phone case,both front and back
Related
I musta pushed the stylus in wrong a time or two and now the Battery back door won't fully snap closed in that corner.
Anyone know a good fix for this without having to buy a new housing for the Wing?
Please Advise
Thanks!
zcink said:
I musta pushed the stylus in wrong a time or two and now the Battery back door won't fully snap closed in that corner.
Anyone know a good fix for this without having to buy a new housing for the Wing?
Please Advise
Thanks!
Click to expand...
Click to collapse
I know this sounds stupid as hell... i kinda squeezed mine (not enough to crease it) and it snapped on no problem. never falls off.
Hi everyone,
I had seen a thread somewhere that someone mentioned that their battery was loose inside the phone and that the could hear it rattle around but I cannot seem to find that thread now.
I too have this issue. When I shake the phone for example I can hear the battery rattle around inside and when I take off the cover I can move the battery a bit from side to side. Can anyone tell me why this is?
I KNOW this is NOT a fake battery as I watched the store clerk open my box and build my phone from BRAND NEW and I have done the comparison on the batteries as well. It just seems that the hole for my battery is a bit too big orthe battery is a bit too small.
Can anyone tell me what I can or should do about this issue?
yes, i recall that topic as well
so you are not hallucinating
no idea where it went
if you do have this issue with the phone + battery, i'll suggest you take it back to bell for an exchange
they should be able to tell quite clearly this is not normal when they compare to the other phones they have
I stuck a business card, cut in half, between the battery and the cover. Seems to have filled the space in just enough to make a tight fit, my battery is no longer loose.
For now I have wedged a piece of paper between the battery and the hole and it has stopped the battery from moving as well but this should not have to be done I am sure.
@allgamer - I would take it back but I purchased it from Future Shop and the location I bought it has not received any new shipments in since and that was a month ago. The concensus from the Bell Stores here is the same as well stating that they are all on backorder.
I will keep my ears and eyes open on this and when they do have some new stock I will be bringing it to their attention for sure.
Yiann, even i have this problem with my bell i9000. I just found out and was looking if anyone else had this issue. I will take it in when i get a chance and will let you know. Did u get a chance to get it replaced or how did u fix this issue?
Thx
Raj
rajesh26e4u said:
Yiann, even i have this problem with my bell i9000. I just found out and was looking if anyone else had this issue. I will take it in when i get a chance and will let you know. Did u get a chance to get it replaced or how did u fix this issue?
Thx
Raj
Click to expand...
Click to collapse
Raj,
No I never did get it fixed. Please keep me posted rom what BELL does for you...
Thanks...
Sent from my GT-I9000M using XDA App
ya for sure...so you didnt take it to bell at all?
+1 i too have the same issue. piece of folded paper does the trick, but like all the above posts this shouldn't be necessary...
azzledazzle said:
+1 i too have the same issue. piece of folded paper does the trick, but like all the above posts this shouldn't be necessary...
Click to expand...
Click to collapse
I have this issue too.. the battery is way too loose. It must be a common manufacture error.
Same problem
i also have a loose battery in my gti9000.....even after wedging a piece of folded paper in between the battery and the surrounding loose area and making it fit quite tightly, the phone still makes a rattling noise when it vibrates....though when i hold the phone in my hand, it doesn't make that rattling sound...wondering if it cud be something other than the battery...
If I want to replace my top cover on the HTC One (because it has been scratched, and I then want to buy a new top replacement http://www.parts4repair.com/top-cover-bottom-cover-for-htc-one-m7-white/ ) is it possible just to heat it up and then remove it? without opening anything else up in the phone?
Seems possible to do with the bottom cover, but can it also be done with the top?
Also want to know plse, anyone ?
s7yler said:
If I want to replace my top cover on the HTC One (because it has been scratched, and I then want to buy a new top replacement http://www.parts4repair.com/top-cover-bottom-cover-for-htc-one-m7-white/ ) is it possible just to heat it up and then remove it? without opening anything else up in the phone?
Seems possible to do with the bottom cover, but can it also be done with the top?
Click to expand...
Click to collapse
Z900 said:
Also want to know plse, anyone ?
Click to expand...
Click to collapse
From a tear down I saw here (possibly general section) the top cover can only be replaced after a complete dismantle as it appears to be screwed in place from the back
Thankk you rider !:good:
s7yler said:
If I want to replace my top cover on the HTC One (because it has been scratched, and I then want to buy a new top replacement http://www.parts4repair.com/top-cover-bottom-cover-for-htc-one-m7-white/ ) is it possible just to heat it up and then remove it? without opening anything else up in the phone?
Seems possible to do with the bottom cover, but can it also be done with the top?
Click to expand...
Click to collapse
here is a link to the teardown "http://www.ifixit.com/Teardown/HTC+One+Teardown/13494/1"
it appears to be really hard to replace because you have to take the Screen and Digitizer off the casing.
Z900 said:
Also want to know plse, anyone ?
Click to expand...
Click to collapse
Here is the teardown done by an XDA user:
http://forum.xda-developers.com/showthread.php?t=2353895
it has been just over a month only and my phone's charging port cover has became loose...plz tell anybody else also has same problem..is it covered under warranty??
ayushbh said:
it has been just over a month only and my phone's charging port cover has became loose...plz tell anybody else also has same problem..is it covered under warranty??
Click to expand...
Click to collapse
First of all - its not udner warranty.Second - get the flap clear from dust over it.That is one of the reasons for gettin loose.Clear the flap and the port aswell. :highfive:
Hello,
I've recently bought a second hand Xperia SP and I've noticed a small problem:
The back cover (battery cover) is not perfectly shaped on the phone.
More exactly, there are small areas on the top and on the bottom (next to the led) where the lid doesn't close properly. There isn't anything broken, and all the wholes where the case must fit in are ok, but still it's not perfectly put on the phone.
I read many articles saying that this is a flexing problem of the cover, that happens. Is this a common issue? Would it be solved by buying a new cover?
b3cks89 said:
Hello,
I've recently bought a second hand Xperia SP and I've noticed a small problem:
The back cover (battery cover) is not perfectly shaped on the phone.
More exactly, there are small areas on the top and on the bottom (next to the led) where the lid doesn't close properly. There isn't anything broken, and all the wholes where the case must fit in are ok, but still it's not perfectly put on the phone.
I read many articles saying that this is a flexing problem of the cover, that happens. Is this a common issue? Would it be solved by buying a new cover?
Click to expand...
Click to collapse
The new phone has the same issues. THis is worst phone that sony made so that is normal
So there is no fix to this?
b3cks89 said:
So there is no fix to this?
Click to expand...
Click to collapse
No and if you are going to buy sony again, buy a flagship
Next time, i'm going for HTC )
SP is a low price high performance based phone. Because of the price Sony didn't give importance to other things.
I was hoping that the back cover was the problem, and I could replace it and fix the issue, but it seems I am not that lucky.