Hi,
Wanted to ask if this was a common problem. The 3.5mm socket on my Xperia has worn two pretty significant grooves into my headphone jack. It's now so bad that the right channel doesn't work half the time. The problem persists when I use the headphones in other devices to it's definitely managed to damage the heaphone jack.
I experimented with the included microphone lead and it has also managed to scar that a little so I immediately stopped using it.
Has anyone else encountered this problem? FYI the headphones are AKG K414P.
Thanks
Tome
The socket sucks. It ALMOST broke my in-ear headphone's jack. It's too tight.
yeah the socket is really tight on mine as well, haven't streaked any headphones yet though, maybe I haven't used them enough?
I have something like this. I think I have the same problem.
It is indeed too tight.
Managed to pull away the rubber coating on my headphones jack, while trying to unplug :/
dogans said:
It is indeed too tight.
Managed to pull away the rubber coating on my headphones jack, while trying to unplug :/
Click to expand...
Click to collapse
That's what happened to me. Be sure to grab that rubber very tightly.
ksian said:
I have something like this. I think I have the same problem.
Click to expand...
Click to collapse
Same problem here, i think this is a common problem on all XPERIA. The socket is too damn tight.
Anyway once you know that you start taking care and you won't break anything. And it's clearly an advantage that it's so tight, if you're using big headphones and your X1 slips out of your hand, it won't touch the ground (Assuming the cable is not too long and you ain't too small ). I like this.
I think we're talking about two different problems here.
My original question was about the contacts on the inside of the socket being so strong that they have cut grooves into the headphone plug. The grooves are so deep that they will not make connection half of the time i use it so that I am losing the right channel of audio on my headphones.
The other problem you guys are talking about is that the heaphone jack holds onto the plug too tightly and so the plug is damaged when you try to remove it.
While you might be able to prevent the second problem by removing the plug carefully, there is no way to avoid the original problem that I reported.
It sounds like Ksian might have the same problem as me but i can't tell from the short reply. Has anyone else experience loss of audio through one channel of their headphones due to the socket cutting grooves in their headphone jack? I know for sure that the X1 socket is too hard as it always makes marks on plugs that are inserted into them, but i want to know if my headphone plug might also be too soft combining two problems to make me lose sound in the right-hand channel
tome_1 said:
I think we're talking about two different problems here.
My original question was about the contacts on the inside of the socket being so strong that they have cut grooves into the headphone plug. The grooves are so deep that they will not make connection half of the time i use it so that I am losing the right channel of audio on my headphones.
The other problem you guys are talking about is that the heaphone jack holds onto the plug too tightly and so the plug is damaged when you try to remove it.
While you might be able to prevent the second problem by removing the plug carefully, there is no way to avoid the original problem that I reported.
It sounds like Ksian might have the same problem as me but i can't tell from the short reply. Has anyone else experience loss of audio through one channel of their headphones due to the socket cutting grooves in their headphone jack? I know for sure that the X1 socket is too hard as it always makes marks on plugs that are inserted into them, but i want to know if my headphone plug might also be too soft combining two problems to make me lose sound in the right-hand channel
Click to expand...
Click to collapse
I DO have BOTH problems. My plug has quite deep scratches. But no loss of audio so far. I think this will get better with time, the socket will also lose some material If your headphones are expensive and break quickly (and you absolutely want to keep your X1 as Mp3player) you might want to use a very small extension cord to avoid damage to the headphones themselves. Extensions of say 2" exist.
dogans said:
It is indeed too tight.
Managed to pull away the rubber coating on my headphones jack, while trying to unplug :/
Click to expand...
Click to collapse
Same thing it did to mine, killing my Creative Aurvanas's 3.5mm jack rubber housing. They still work but the rubber is loose.
Ah well, because of that I am actually looking at some Shure E530's (the Xperia is a pretty good source IMO). They have a detachable extension cord so i can use a L-plug instead of a straight plug.
Really, use L-plugs, they are a lot more durable against the tight socket. Its just because the sound is really great for a phone, hell, I bet its better than most MP3 players, else i would be very mad, killing my favourite IEM's . Very clean sound, although sensitive IEM's will hiss but that is expectable from such a 'noisy' thing like a fully packed-with-features phone.
But hey, a tight socket is better then a loose socket, or a proprietary extension cord like the HTC's.
Apart from killing my Aurvana's I still think the 3.5mm socket is High Quality Stuff. It just feels 'right' when you plug in your IEM's/headphones.
Keep in mind that you shouldn't keep the extension plugged in all the time because the phone actually detects this and routes certain sound events from the speaker to the headphones. For instance if you pick up a call with the extension plugged in but no headphones, you will not be able to hear the caller.
yeah i was thinking that i might have to make/buy a short extension to save my expensive headphones
it's like you guys are saying, the sound is good enough that i want to put good headphones on so i'll have to find a way to protect them. I wonder if the included handsfree extension is resistant to the phone's socket?
I use the stock extension. It gets scratched as well (have xperia for 2 months). As for the sound quality, I'm thinking about repairing my good old Ipod nano for listening mp3's. I do think, that it has better sound quality and more than that the battery of the phone won't die out so fast (playing music for about 2 hours a day).
Lol. Would not have noticed this without you guys. Who would look at their earphone jacks? Either they are very bored or something about their earphones is screwed up.
Does other HTC phones have these problems? Oh wait, only the THD has 3.5mm.
The jack has ground grooves into the jack on every single pair of earphones I own,and based on this alone, I'd say SE, give me my freakin money back!
Is it serious? Probably not. But is it supposed to do that? Hell no.
I don't want to use the stock extension cable, otherwise I wouldn't choose a phone with a 3.5mm jack, Jesus bleeping Christ.
I have the same problem here. I used a nokia handsfree and after 2 days I had that scratches and sometimes I couldn't here well, the sound was faded and i had to turn the jack in a certain position. Today I tried an Iphone handsfree and it doesn't work well..
I don't know why... Is it to thin? It's new but the sound is faded. I don;t get it? Has anybody tried this apple headphones? (The one with microphone, so 3 stripes on the jack)
LATER POST: I TRIED ANOTHER HEADPHONES AND THE SAME BLURED SOUND...SO I GUESS MY SOCKET IT'S SCREWED
well, then again the apple handsfree is thiner i guess, because i tried some Lg headphones and they were ok. the apple headphones are functioning conected on laptop. I don't know what to believe... I really wanted to use the apple stuff on this phone, i should buy an extender.
use your xperia handfree as an extension, have been doing that for over a year now, and even though it's scratched like hell, it works fine, without damaging my beats
Could you please tell me wich model of headphones by SE are they? I mean the x1 headphones.
I found out that iphone's 3.5mm socket is not like the others so the x1 is not like the others and maybe that;s the reason i can;t use the apple headphones.
ok...got it.."If they have a mic, then they're useless for anything but an iPhone.
Apple decided rather than follow the industry standard of Right/Left/Mic/Ground, they would make their own up. They chose to make their socket Right/Left/Ground/Mic, which means your N900 is trying to ground the headphones through the mic, which clearly will not work.
In short, they won't work on anything except an iProduct."
hi: So my friend gave me a pair of dr dre beats(tour) earbuds. I plugged them in and everything sounds fine on the phone, but I realized today that when I wiggle the wire near where it goes inside the jack, my music stops. As if my phone thinks the headphone has disconnected. So for example, with double twist, if the wire moves, the song pauses, and I have to press the play button again. I tried a friends Seinheiser headphones, and when I wiggled them, there were no problems. What should I do?
If the head phone connector is gold and appears to be wearing off it just means that thee signal is not making it to the headphones. Gold plated connectors is a way to make a cheap cord better but once the gold wears off the signal strength weakens. I have some really nice dj quality headphones that sound amazing but it can be hit or miss bc the gold is going
Sent from my SGH-I897 using XDA App
just make sure its pushed all the way in.
some headphone jacks are cheap and just dont sit right.
just feel for the click.
if everything is fine there, wiggle just the wire part.
ive had many headphone extention cables break internally and they cut out.
if no other headphones do it, id assume its the headphones,
btw why did your freind give them to you? theyre expensive,,,
it's probably not the jack afterall... i put ipod buds in my captivate and the sound played fine...probably the dre earphones since when i plugged them into a mac nearby and i went to listen to a youtube vid after twisting the wire tip around the sound was lost. thnks anyways
i have the same problem when i plug into the an audio jack from my car stereo.
when i plug it in the right side normally goes out. takes some wiggling of the wire to get sound to both sides.
my friend has the same problem so i think that maybe the jack on the phone is cheap. who knows. maybe ill try another cord.
Anyone else having an issue with the headphone socket, when I plug my headphones in and put the phone in my pocket or bag it only takes the slightest knock or me just walking to jar my headphones lose and then the music pauses. I know I could turn the "pause music when headphones disconnected " off but I find it handy and in this case the music would continue to play until I'd opened my bag to plug my headphones back in.
Any tips for me?
I've yet to try a different set of headphones I must admit. I don't have a second set to hand
Yes, exactly the same issue. With some earphones its really bad, with others its a little less bad. I even have two identical sets of headphones, one of which disconnects with the slightest touch of the plug, the other is not quite so bad, but still a pain. Must be a common problem.
its crap, can't believe this wasn't a known issue when the device was being tested. Its go the point I'm thinking of selling the phone and getting something else
Nothing like that here ... Its nice and firm ... Maybe you should get a replacement ...
Sent from my HTC Incredible S using XDA App
Are you sure you put your 3,5mm connector deep enough in the socket?
I don't recognize this problem at all, its more the opposite.
Last week I pulled my cx300 out of my phone the connector was still in it, the rubber protection came loose from my cx300, I put it back and haven't managed to do that again.
i don't have this problem either. im using all sorts of headphones and still ok. put it all in. push harder. lol. all headphones work but not the mic. especially the three button ones
maybe its just the excuse I need to buy some new headphones
Use bose earphones... Socket Isn't loose at all.
Maybe you've already defective socket or earphones.
Sent from my HTC Incredible S using XDA Premium App
Whenever I connect my Skullcandy headphones, only the left headphone works. Also, the white earbuds that came with the Note do the same thing. Only 1 earbud works while the right one doesnt. Is anyone else having the same problems? The phone is new.
press the headphone connector firmly.. also there are some headphones pin configuration are changed so all the headphones are not comfortable with all the 3.5 mm jacks..
if the problem persisted same there are chances to service your connector...
If I push the connector down hard it works, but when I let go, one earbud stops working. Even my Samsung earphones don't work properly.
I previously had a droid ultra and it had thr same problem. Im using bose headphones and for some reason they headphones dont plug in all the way. I know the headphones work properly because i use them on my computer and tablet. Do i need to be using a specific headphone jack size. I figured the size the bose headphones came with would be fine. Anyone else having this problem??
Do you mean the plug sticks out above the chassis, or when you plug them in, sound still comes through the speaker and not headphones?
When I plug my Yurbuds into my Moto X there is a very small portion of the gold plug still showing. I think the port is just shallow, but the headphones work fine.
I've had the same issue. I opt not to use it. Bluetooth ftw.
ultramegaman963 said:
I previously had a droid ultra and it had thr same problem. Im using bose headphones and for some reason they headphones dont plug in all the way. I know the headphones work properly because i use them on my computer and tablet. Do i need to be using a specific headphone jack size. I figured the size the bose headphones came with would be fine. Anyone else having this problem??
Click to expand...
Click to collapse
They just don't have as much extra material around it to cover the whole thing. It is a result of the curved edge the jack is on. Works just fine, though, and produces some decent enough sound for a phone.
Yeah my earbuds' jack sticks out a little bit, but the sound itself is okay. Never had an issue with my jack yet.
Make sure there is not lint in the jack. That can cause sound/fitment issues.
Pretty sure everybody else covered it, but mine works fine as well. I do find that you have to give the 3.5mm plug a little extra "push" at the end but I am rewarded with a satisfying "click" once it is all the way in. A portion of the plug still shows from the back, but this is irrelevant as the only connections that need to be made are further down anyway. I have used it with both headphones, and the AUX cable in my car (with a VERY expensive subwoofer and sound system) and have found that the sound quality puts my Droid Bionic (even with DSP manager) to shame.